The Grow Awards 2026 🏆 
Time-r settings.
SanderanderSstarted grow question 4y ago
What is the best timer setting for growing with a drip system on clay pebbles?
On / Off , day and night etc.
Solved
Setup. Sensors
likes
GMSgrowsanswered grow question 4y ago
5 times a day at 15 minute drip times is what I use to do with good results. Depends on how much water comes out of your drippers. There are ways to figure it out. Sure if you look online you will find the calculation
Similar Grow Questions
Solved
I_T_C_R_W___GROW
perfekt small grow - what is needed? What a perfekt light needs or should have?What features should a universal Growbox have ?
And what a perfekt light (for a 50x50cm Area in this box ) must have- for seed / settling/grow/& bloom & maintaince like holding a Mother near endless? Can you all help me to build the perfect diy box?1mo ago
1
3
Solved
Newbiegrower420
I was struggling with low humidity, now I can’t keep it below 70%.Hi! Since upgrading my 4 girls into new 3 gallon pots & giving them a good water the humidity levels in the tent have soared to over 70% Will this reduce as they drink all the water in the pots? Shld I invest in a dehumidifier yet? Running out of space 😬Week 3
Setup. Sensors
5y ago
3
5
Solved
Z1984
RH% and temperatureHi guys, got the transplant done today as suggested by Burmese.
I have an issue after transplant:
- My RH doesn't seem to go below 62%
- Is this level bad for the plant?
- What is the optimum RH and Temp for this strain?
- Or average optimum temp and RH in general?
Thank you :)5y ago
1
1
Solved
Abacus
InkbirdI bought a inkbird itc 308s to control temperature. In heat plug I put a little heater, but in cold? I was thinking to connect extractor, but until now in my grow the extractor was always on, from 1st day of veg to last day. So, should I connect something to cold plug or not?Setup. Sensors
3y ago
2
Solved
Hisknibbs935
Pre run test showing high temp and low humidity,Hello,I have pre run to test the temps and humidity on my first one ,i run a 600w hps in a 1x1x2 tent with 5 inch rvksileo extract my temps at at 35c and my humidity below 30 despite setting for 55% would a test without a plant be false ? Should i drop to 400 ?Setup. Sensors
Setup. Lighting
5y ago
1
3
Solved
ItalianDesertBalcony
Are these photos good enough?Should I invest in a stronger lense clip for my cell phone or are these photos clear enough to judge harvest time?Buds. Other
Plant. Other
Setup. Sensors
1mo ago
1
6
Solved
laberg
Set auto system for VPD or RHI have AC Infinity set up. I am wondering whether I should have the humidity triggers set up for VPD or continue with RH triggers. So far I have it triggered when humidity gets a tad low. If I trigger for VPD, I think I will have to constantly check leaf temp. Thoughts?3y ago
1
2
Solved
versace_grow
RH 90% during Flowering!I have a problem with RH. I am at the 3rd week of Flowering and I'm struggling to keep my RH down. Today it was 90% when I opened the grow box. I have access only to a window. Is it better to suck air inside or blow the exhausted air out? I can't do bothSetup. Sensors
Setup. Ventilation
6y ago
2
3
Solved
Minnesota_Grows_420
CO2 meter suggestionsSuggestions on a decent reasonably priced CO2 meter? ThanksWeek 2
Setup. Sensors
2y ago
2
2
Solved
AirDuster
Help in understanding instrument readings for hydroI'd like to undertand what the importance or significance of these numbers are, and if they indicate issues to resolve:
Hydro - 30 litre reservoir
ph: 5.91 - pretty sure that's in the perfect range for hydro
ppm 1502 - no idea
μS/cm - 3195 - no idea
humidity 41%
Temp: 21 - 36c5y ago
4
4
Solved
CANNA_401
Luftfeuchtigkeit zu hoch für die Blüte? - Methoden zur LuftfeuchtigkeitsregulierungIch merke das ich die Luftfeuchtigkeit nicht dauerhaft unter 50% bekommen werde, denkt ihr ich sollte in einen Luftentfeuchter investieren? (Sensor auf Pflanzenhöhe)
Ich will nicht riskieren das sich Schimmel and den Blüten bildet.
Danke schon mal für die Antworten 💪👽2y ago
7
1
Solved
KCduzit
How can I get my humidity down? (Basement grow tent)Plants are currently sitting at Rh 55% on my controller on day one of flower. I have a small $40 probreeze (Amazon) dehumidifier In the tent and am using a 4 inch intake (full strength) and 6 inch exhaust fan (1/4 strength). Day Temps around 25 Celsius in basement5y ago
2
3
Solved
JSanchezz
serious question about VPD value in the tentI'm not sure which values I should consider more important, or both.
I have one sensor about 10cm above the Canopy and one sensor directly below it.
I am trying to keep the VPD optimal in this grow, but which one is the "right" one?Setup. Sensors
2y ago
3
