Chat
RecommendedRecommended

the top is slanted looks weak

Startergrower10
Startergrower10started grow question 3 years ago
I don t know why from 2 days the top is slanted looks weak
Solved
Week 6
Other. General questions
like
Mr_Incognito
Mr_Incognitoanswered grow question 3 years ago
With 40% RH and 30 degrees C it makes about 2.55 VPD (Vapour Pressure Deficit) that is high stress for plant. High temps with high PPM make the plant to consume more nutrients because it's using much more water for evaporation. Lowering PPM of solution will help. As I mentioned in my comment earlier, the plant likely has nutrient burn due to very high ppm is applied once per week. It's better to lower feeding for some time and then feed every other watering (feeding-watering-feeding-watering). Also apply relevant PPM according to temperature. High temperatures require less PPM. That's my IMHO.
1 like
Complain
Selected By The Grower
CRiSPrGrow
CRiSPrGrowanswered grow question 3 years ago
hey there Startergrower , you have a (rare) case of magnesium lockout, you're giving too many nutrients and the magnesium locked out. to fix this you need to flush , then give 1/2 or a 1/4 of your normal nutrients . try to remove as many as possible extra nutrients that have magnesium in them and some of the additives also. Hope this helps ! 🚀
like
Complain
GanjaReaper
GanjaReaperanswered grow question 3 years ago
+ you can also add an air inflator that inflates cold air :) It not only cools down the temperature a bit but it is also very healthy for your plants.
like
Complain
GanjaReaper
GanjaReaperanswered grow question 3 years ago
Hey Startergrower10, This is what i found out when checking on your diary: - Your EC level is to high. It should be more like 1.8-2.4 and not 3, depending on size plant and buds. To proof this you can see that you have some yellow tips on your leafs, this indicates overfeeding. - Looks like you are having a heat problem, 30 degrees is a little bit hot unless you inflate with co2 and/or having strains that can handle that heat. When a plant is getting to hot(not burned) the leaves will go up to perspire. Solution: 1. Get a higher humidity if you can't lower your temperature or make your air extractor run harder if you have one. 2. Lower down your EC to like 1.8 since they are not that big yet. Good luck growing :)
like
Complain
AsNoriu
AsNoriuanswered grow question 3 years ago
Huge nitrogen toxicity ??? Plants are rapidly dying ??
1 like
Complain
Growladyeastmidlands
Growladyeastmidlandsanswered grow question 3 years ago
Yiu sure you have not been pollinated looks like balls on the stalk hopefully not but can stop them growing cos they start producing seeds if so scrap the lot start again with fresh seeds when cleaned everything happy growing
like
Complain
DoctorGreenThumb
DoctorGreenThumbanswered grow question 3 years ago
Looks like it was bent some from training. Also looks like its reaching for the strongest light section in the room. Cheers!
like
Complain
Hashy
Hashyanswered grow question 3 years ago
Your Ec seems on the high side of things for soil. Like at least twice as high as it should be. Have you not accidentally caught the top and bent it over by mistake a few days ago.
like
Complain
Similar Grow Questions