By continuing to use the website or clicking Accept you consent to our cookies and personal data policy. For details please see Privacy Policy
Accept
Questions about mold growth and moisture fluctuation
JSanchezzstarted grow question 4 months ago
I grow in cold climates
Environment is constant 15.6-16.5 C (~60F) Rh 56-62%
Is it better (less risk of mold) if these values do not fluctuate?
In the tent it is (with Heating)
Day 22C 60RH
Night 18 62 RH
Im in Last Week Flower
Good air exchange & good air circulation
First Grow
Solved
Setup. Other
like
nonick123answered grow question 4 months ago
Tienes muy buenas condiciones, PERO dos puntos importantes
Intenta que la temperatura NUNCA baje de 18 ºC. Si ocurre, se produce estrés
La humedad está bien si tienes una buena circulacion de aire (ventiladores), pero sería más ideal si la pudieses bajar a 40-50% en late flower
NamasteDaveanswered grow question 4 months ago
I think you are doing great based on your enviromental conditions. Fans to circulate air, LST/ScrOG to allow for better airflow, defoliated.
Only recommendation is select a strain resistant to mold, which you likely did already! Best of luck to you; the colas are looking good...
like
Complain
AsNoriuanswered grow question 4 months ago
My days a bit wormer, but i grow in very similar conditions in last 5 years had bud rot only with one strain, in that grow was like 10 more , but Whitey Freezey had it on both plants.
Think you are ok.
1 like
Complain
Similar Grow Questions
Solved
LoveGrowWeed
Hello. Colleagues tell me who dealt with the organic CO2 generator? How effective is it? How long does it work (manufacturer writes 9 months). I don't have instruments to measure CO2 levels
Maybe someone measured the indicators with instruments?
thx.
Week 2
Setup. Other
2 years ago
8
5
Solved
XXXXXX
Timer?Hey!! Could you guys recommend me a timer to switch my lights on/of automatic? Thanks!!Setup. Other
2 years ago
5
4
Solved
LiberFelix
PH keep rising in DWS, RO water?I use tap water (soft water), Canna Vega A/B and related products, with rockwool.
PH is stable around 7.2 - 7.5. I PH down to 5,5 and 6-12 hours later its back up. This is my second rund and had the same problem then.
Could reverse osmosis water help this, or other advices?2 years ago
2
1
Solved
TheeLemon
High heat Low humidityWeek 6 of my 1st ever grow. Having a problem of high heat, low humidity. I closed my tent, and woke up to 40°C & 12% humidity. Ive read that this problem is often what causes a plant to go Hermie
Just looking for some thoughts on how to fix this / how my ladies are doing generaly
Setup. Ventilation
Setup. Other
2 years ago
6
7
Solved
GrowKing1998
Grow box oneHey everyone i am going to grow with the grow box one have some one did this before let me know tanksSetup. Other
2 years ago
1
2
Solved
DopeGrows
4x4 16 Plant Veg Time and TrainingHello guys, I am planning on flowering these 16 ladies in my 4x4, but I am unsure of how long to veg and what training to utilize for maximum yield.
I was thinking 3-4 weeks? Or maybe longer?
Is topping in such a tight space a good idea? If yes then at what time?
Thanks!2 years ago
5
5
Solved
GingerSkunk
Ph rising and then crashesEverything was going fine, until Friday, when her ph shot up, to about 8, added some ph down, brought that down and stabilised @ 5,5 ph - 11pm , @ 6:30 Saturday was in the 4’s, put it in to clean RO water 0ppm - @ 7 pm was high, so changed the water to fresh Ro water with nutrien
Week 12
Setup. Other
2 years ago
1
3
Solved
ItsGrowingOnMe
Simple wick system (bottom of space bucket) for first grow wise?I have a space bucket lying around and want to use the wick system with reservoir to feed my plant while also using an air stone to increase oxygen.
Is this a successful route if I polyester wick to a fabric pot with FF soil or should my first grow just be standard soil?Setup. Other
2 years ago
1
1
Solved
AwfulBuddy
Green spectrum work lightHi buddies! hello, I hope everything goes well with your projects!
I would like some advice.
I want to buy a green spectrum lamp so I can work in the box in the morning before leaving the house for work
I would like to have some feedback about it2 years ago
7
5
Solved
ItsGrowingOnMe
Lowering temp in a small tent?My grow tent is small sitting at 85 degrees F and 30% RH.
My set up inside:
2 mars hydro TS 600s (culprit)
1 vivosun in-line fan with ducting pumping air out.
Small humidifier.
Coming soon:
Co2 bag (increase resiliency)
305 cfm circulating fan.
What else can I do? No ACSetup. Other
2 years ago
1
2
Solved
KittyDong
Should I remove some plants yield wise ?Hello ! First grow. I wanted to know if it would be better to remove some plants if we think purely in yield. I'm just having fun, these are 5 different automatic seeds, I'm not only interested in harvesting the most.This is just out of curiosity.
This is a 2*2ft tent (60*60cm).
Setup. Other
2 years ago
2
5
Solved
ViTeM
wohin soll ich meine Heizmatte plazieren?Ich bin gerade dabei mein neues zelt und alles aufzubauen :) freue mich wie ein kleines Kind.
Kann mit einer der Profis sagen wohin ich meine Heizmatte plazieren soll? habe auch eine 1x1m wanne (*da drunter?) oder soll die Matte zwischen die zwei Zeltmatten?Week 1
Setup. Other
2 years ago
1
1
Solved
gottagrowsometime
DWC×2 33cm H fit in 70x70x160it's not Q about my grows, rather my new to be set up. So, I ordered 2 19l DWC by growrillahydroponics. They are 33cm H and the tops are 30cm in W. With a 70x70x160 do you think I'll be able to hold 2 plants thru veg-harvest or will I have to swap them out giving em 12hr each?Setup. Other
2 years ago
1
3
Solved
Jannis_Botanicum
Air-Intake / Equipment question.Ok, so i bought a air outtake system for my grow tent with a active carbon filter so my whole house doesn't smell like weed as it does now. My question is can i just install my air outtake in there and close the tent without having a air intake ? Or will that cause Problems ?
Setup. Strain - Autoflowering
Setup. Ventilation
Setup. Other
2 years ago
2
9
Solved
Newbie101
Clusters of white stuff in my watertank (hydroponics)When I stur in ly water tank, I notice some white flake like things comming up. It lays at the bottom but when I mix the water, it spreads out and some settles on the surface afterwards. I tried to take a photo, but it’s hard to see on them. Has anybody had this before?Setup. Other
2 years ago
1
3