Vote Now 🏆 for the Grow Awards 2025!
Recommended
Likes
Comments
Share
@hooolian
Follow
the plants have been cut and will hang and dry for 10 days looking forward to seeing the end results and harvest as the topping worked wonders producing many thick colas.
Likes
11
Share
25/01 Still having problems with the heat, I've build a exaust with 2 120mm computer fan, this week has arrived the humidity controller and I noticed that is to low for the temperature. Now I waiting for a mist maker to build a DIY humidifier(using a simple water spray for now) I belive this will be the solution to get a better VPD and control this fucking heat inside the tent 😎 30/01 The temperature is reaching more suitable levels, between 25-27°C. Even with the rainy days and higher humidity outside, the grow is stabilizing well at around 65% humidity.
Likes
2
Share
Last week for the 8 , on Feb 1st will be flipping them into bloom 12/12. I think I did well flatten em out like a table. If one tall than the other I’ll try my best to tuck em & if too many buds site to the side or nodes then Ima let em be…. Prolly have to get a 2 nd net trellis…
Likes
10
Share
01/29/25: The journey begins with five Runtz feminized seeds from Zamnesia. To ensure a strong start, the seeds are placed in room temperature distilled water pH’d to 6.0. This softens the outer shell and allows moisture to penetrate, triggering the early stages of germination. Distilled water is used to avoid any potential contaminants, ensuring a clean environment for the seeds. A slightly acidic pH of 6.0 is ideal for early root development. The cup is set on an AC Infinity heat mat at its lowest setting. Maintaining a stable temperature around 75-80°F (24-27°C) encourages germination by simulating warm soil conditions. Too much heat could damage the seeds or dry them out, so a gentle, consistent warmth is applied. After 20 hours, the seeds will be transferred to a growing medium consisting of 85% coco coir and 15% perlite. Coco coir is chosen for its excellent moisture retention while still allowing for proper aeration. The addition of perlite improves drainage and prevents the medium from becoming compacted, ensuring oxygen can reach the roots. By carefully controlling the environment at each stage, these Runtz seeds are given the best possible conditions for a strong and healthy start. Updates will follow once they’re in the medium. 01/30/25: After 20 hours of soaking, the Runtz seeds have absorbed enough moisture to begin their journey. A couple have already cracked open, revealing the tiny beginnings of their taproots—the first sign of life. With germination officially underway, it’s time to transfer them into their growing medium. A fresh batch of 85% coco coir and 15% perlite is prepared, ensuring a light, airy structure that retains moisture while providing adequate oxygen to the roots. The mix is carefully placed into five starter pots, where each seed is planted a quarter of an inch (0.6 cm) deep before being lightly covered with more of the medium. This depth provides enough coverage to protect the seeds while still allowing them to break through the surface easily once they sprout. After planting, the medium is watered with distilled water pH’d to 5.8, slightly lower than the initial soaking water. This pH level optimizes nutrient availability for young roots once they begin developing. The starter pots are placed inside an AC Infinity Propagation Kit on the heat mat at its lowest temperature. To maintain high humidity within the dome, a small amount of distilled water is added to the bottom of the propagation tray. As the heat mat warms the water, it will create a steady supply of moisture in the air, helping to keep the environment stable while the seeds settle in. With everything set up, the seeds will now be left undisturbed for the next four days while I’m out of town. The goal is to return home to find at least four out of five seeds successfully sprouted. Since I plan to run this grow with four plants, I’ll select the strongest seedlings if all five make it. The chosen four will be transferred to the grow tent to officially begin the vegetation stage. For now, all that’s left to do is wait and let nature take its course. More updates to come once I return. 02/04/25: After returning from a four-day trip, I found that two of the five seeds had successfully sprouted. They were standing tall, looking strong, and showing early signs of healthy development. The other three, however, had yet to emerge from the coco coir. To assist the late starters, I carefully used a wooden toothpick to gently remove some of the surface medium over each of the unsprouted seeds, searching for signs of life. After locating them, I lightly covered them back up and used a spray bottle to redampen the surface without over-saturating it. Now, one day later, two more have broken through the surface, bringing the total number of sprouted seedlings to four. Three of them are looking strong and healthy, well on their way to transitioning into vegetation. The fourth newly emerged seedling appears weaker and slightly struggling, but I’ll leave it undisturbed and allow it to strengthen naturally. The fifth seed remains unresponsive, with no visible sprouting. At this point, optimism is low for that one, but since the goal was to grow four plants, everything is still on track for a successful run. With germination now complete, I’ll be starting a new entry to track Week 1 of Vegetation on the 6th. Excited to see how these Runtz seedlings develop from here.
Likes
2
Share
@Haoss
Follow
The beautiful girl has started growing right now. I haven't fertilized her yet. I've done some topping and removed the small leaves. She's feeling great. 💚🌱
Likes
6
Share
Likes
6
Share
1/28/25 She has a very strong berry smell to her. Very different from her sisters 1/31/25 kinda late but i lollipopped a bunch of lower branches 2/3/25 downloaded the photone app and noticed the levels of par are very displaced and was able to raise the lights to get a better reading.
Likes
4
Share
@Haoss
Follow
The beautiful girl has started growing right now. I haven't fertilized her yet. I've done some topping and removed the small leaves, She's feeling great 💚
Likes
2
Share
@Haoss
Follow
The beautiful girl has started growing right now. I haven't fertilized her yet. I've done some topping and removed the small leaves of the avemoth. She's feeling great.💚
Likes
6
Share
Likes
12
Share
Week 5 day 1. I have a favourite for next run. I’m very happy, I haven’t really defoliated at all this grow, just letting it grow. Wish I was going for mains(topping) but still very good. Going to wait around week 9 so seeds will be good for next run. I have decided to do very hard hst next round to show max potential. Very happy with supercropping so will do it very heavy with scrog. I will try to reveg the one I really like but it is difficult having only 1 set of lights and 1 tent. Plants are about 7ft tall, might just run 2 next round in 4x8 or will still continue to go 4 in the 4x8.
Likes
6
Share
Likes
Comments
Share
@Marbanya
Follow
2025-01-21 to 2025-01-27 This week, she really put on the lemon-lime smell of Chernobyl. I've pollinated her (once again) with Chemdog #2 pollen from a previous grow. I'm looking for a "stay lifted" effect, as both of these cultivars have. But, I'm hoping for more of the earthiness to come through from the Chemdog in the potential seeds that are produced.
Likes
12
Share
Week 5 day 1. I have a favourite for next run. I’m very happy, I haven’t really defoliated at all this grow, just letting it grow. Wish I was going for mains(topping) but still very good. Going to wait around week 9 so seeds will be good for next run. I have decided to do very hard hst next round to show max potential. Very happy with supercropping so will do it very heavy with scrog. I will try to reveg the one I really like but it is difficult having only 1 set of lights and 1 tent. Plants are about 7ft tall, might just run 2 next round in 4x8 or will still continue to go 4 in the 4x8.