Days 35-42 (Day 36) Some minor problems starting to arise here. A few times this week it got up to 90+ degrees which I think may have caused a bit of heat stress in some of the plants. I’m seeing a bit of cupping/crinkles on some of the fan leaves and some of the new growth is looking pretty gnarled and twisted. I hear windburn can cause this too so I’m turning my fans down to low speed. This could also be a problem with humidity so I’m going to turn off my humidifier, dim the lights and raise them. During my last feeding I mulched in some worm castings but it seems like they’re keeping the soil/coco from drying out. Pots are still decently heavy and even the surface is still quite moist but they aren’t showing any major signs of overwatering. I figure it will only be a few weeks before the castings break down so I will just leave it. A few of the plants are starting to show yellowing leaf tips which is probably some kind of micro nutrient lockout from my PH being slightly too high. It could also be from nute burn so I will water in 6.0 until I see some runoff. Although the most likely culprit is potassium excess. I’ve been feeding potassium almost as much as nitrogen so far. I know that can cause the yellowing of leaf tips by locking out trace minerals. It can also cause leaf problems like crinkling. Excess K can even cause water retention! Will water at 6.0 until run off next watering. The lst is coming along nicely. It was a good idea to remove the first two sets of branches (not leaves). Now I have 4-6 perfectly even stems coming from each plant that I plan to top one more time each. (Day 37) Today I’m going to vacuum, clean, wipe down and spray all my equipment in the tent. I’ve been letting the floor get quite dirty and I haven’t had the chance for a thorough clean since last round. I’m kind of surprised I haven’t seen any powdery mildew yet. I guess the prevention spray is working because the room has to be infected from my last crop. (Day 40) I was reading that you can foliar spray whatever you are deficient in for an immediate uptake. I‘m going to try that with my current potassium excess since it locks out trace minerals. I’m going to foliar feed a bit of phytoplankton at 15ml/L and some MagnifiCal + VeloKelp from Remo nutrients both at 5ml/L. The cal mag is not organic but as long as it’s not going into the soil and doesn’t contain chlorine I’m fine with it. I’m also going to be changing the light cycle to 18/6 for the remainder of veg. This will be their first dark cycle so they can properly foliar feed. Edit: humidity shot up to 85% a few hours after foliar spray. I went to top dress everything today and I mixed up the plants while doing so! So the ones I was unsure about I gave 1 extra tablespoon. I won’t top dress again for at least 10 days. Might give a light tea sometime next week. I also tilled the shit out of the top of each pot. It had a hard crusty layer on top that was keeping the medium from drying out properly. I’m not going to water again until everything is bone dry. Then I will water until slight runoff at 6.0 ph with some Dr. Marijane bacteria/root probiotic. I’m starting too see a lot more of these abrasions on some of the bigger fan leaves. It almost looks like thrip damage but I’m 100% sure it’s not a pest above ground. It could be bulb mites, which I found in my worm castings but I can’t check until the roots are more established in their pots. The leaves themselves are cold and feel damp to the touch. I haven’t even seen a fungus gnat since I last fed. I’m hoping it’s related to the K excess and clears up with the troubleshooting. (Day 41) Just ordered a wire cube rack to prop my plants up with and help evaporation/root warmth. Each cube is 11.8”x11.8”x11.8” and it comes with 16 cubes. So it will fit just perfectly in my 4x4. Depending on the size, I might order another one for the flower room where I would need 25 cubes.

She's starting to show progression up top in the big pot, things are looking good 3/7 - more progress up top, hoping things dry up so I can feed

So I set up the veg room at last since I want to flip the main plant. That meant light proofing it, which I did with air con putty, myler blanket layers and A LOT of duct tape. It's not pretty but I hope it will get the job done! Perpetual grow is the grow, harvesting every 2 months. The clone I made from topping got transplanted to a solo cup, and I can see a root through the clear inside cut so I guess she is doing her thang., Also added lights to the flower booth so it should have 153w. Put 4 led bulbs with the tops popped off to see how they go, apparently, they are more economical than cfls? And I am considering what to do for side lighting, leds might be a choice because they have a lower profile, Or LED strips? Or fluorescent tubes? I guess it's not neccisary for this grow but in the future. I've tied down the main branches so I think they will all have their own space to get light. I think I've done enough training to flip. Can't wait for her to start flowering :)

So Here we go,guys 🙂 3rd week is here and Im totally glad I hit these genetics. The girls are eating AF and I water them everytime I have the time 😀 They love it! so much! I bend them like real girls (you know waht I mean,vrrrrrrr) 😀 I had a little bit of mistakes : crash some new stems,but the others will have their power now,so..... Well : beast incoming!

this week the plant has grown well I'm being struck by the compactness of the plant which is very close between one internode and another I hope it continues like this and stays nice and compact, or started using the water produced by the dehumidifier which is basic ph 6.4/6.6 and an ec between 0.3 and 0.5 and however not with chlorine or other added things as it is water recovered from the air and allows me an error regime with a higher ec because it is based on a lower ec than the tap water which I used to use after decanting with this I hope I don't have problems but we'll see for now and ok, rating for the performance held this week and a nice 10 ahaha unfortunately for me it's a male I'm right but I don't despair I'll use it to mix it with my don diablo and try to make it stay more compact between one internode and the other, since she has a very compact growth while easing a male.

Next time I will use a net and veg for

Update February 4, 2019 (Video and Pics actually taken Feb 1). I’m figuring I’m about mid-way into flower now with the 6 girls I have flowering. Overall, I’m very happy with how things are going. The buds are coming in strong on all plants, they are stinky and sticky and I’m not complaining about anything really. But, I still see more yellow than I like. Last week I fed Recharge, Mammoth P, MegaCrop, and CalMag+. I don’t feed all of those at once, Recharge & Mammoth P one time, MegaCrop & CalMag+ the next, then the 3rd is usually straight water. I also seem to be able to go at least a day between waterings/feedings. Anyway, yellowing leaves during flower seems to be most common with a Nitrogen deficiency as far as I can tell. I’m tempted to feed in a round or two of veg nutes to see how that goes. One more thing… I transplanted my clones and seedlings into larger nursery pots today. They were transplanted into pots with soil that has been composting/recharging for almost a month now based on some of the tips from the books I have been reading. I’m excited to see how they react to their new environment.

Growing great. been adding calmag to the mix and she bounced back. Still a little yellow but the buds are growing nicely. Great trichome production To the touch it smells SO much like blueberries Im blown away and theres still more maturing to do! Excited to see how much more she fills out.

AMS Supreme is doing really good with the Athena Nutrition, under the Mars Hydro FC4800 light. She is stacking nicely , and starting to develop a aroma. She is due for a solution change very soon. She has been drinking a lot, she should be a nice harvest if she stays on current path. Nothing else to report at this time. Thank you Athena, Mars Hydro, and Amsterdam marijuana seeds. 🤜🤛🌱🌱🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g

Black Cherry Gushers - Barney's Farm Day 95 - watered with 3L of RO tap water with nutrients, pH'd to 6.3. She's been bulking really well and has started to pull nutrients from her fan leaves. I will monitor her maturity from this week, I'm thinking harvest could be as soon as two weeks from today 🙏🏻

Hi all the happy people here in GrowDiaries. This is my second cultivation ever and it will be fun to try a bigger space than my closet grows First, I'm just going to say I'm done with the construction of my new growroom. I put some pictures on the construction here in week one. The room is 2.14 meters by 1.7 meters and has a ceiling height of 2 meters. It provides a floor area of ​​3.6 square meters. I use a 54 Watt Lightwawe T5 for germination and 2 Pcs 400 Watt HPS lamps. I have a channel fan that replaces the room air about 40 times an hour to get a comfortable theme in the room, the air enters a fresh air intake from the outside. The air is purified through a carbon filter to then leave the room to the rest of the basement. Then I use that heat to heat the rest of the basement. I will use 8 pcs 15 liter Autopots to grow with and a 100 liter water tank that supplies the pots of water and nutrition. I will grow completely organically in soil and will watercure my buds to get the best possible medicine for me. But there are no cultivation rooms to be displayed here, so I continue with what is most important. I am very excited to see how the new growroom will work and how this CBD Fast Eddy plant from Royal queen seeds will turn out. CBD Fast Eddy Automatic is combining Cheese x Juanita la Lagrimosa x Ruderalis, Fast Eddy is a rapid growing, flavourful, and CBD-rich auto strain that goes from seed to harvest in 8-9 weeks, produce generous yields, and induce a clear, mellow, and most importantly, functional high. THC: 9% CBD: High Yield Indoor : 400 - 450 gr/m2 Yield Outdoor: 80 - 130 gr/plant Height Indoor: 60 - 100 cm Height Outdoor: 80 - 120 cm Flowering: 6 - 7 weeks Harvest month: 8-9 weeks after sprouting Genetic Background: Cheese x Juanita la Lagrimosa x Ruderalis Type: Sa 50% In 40% Ru 10% Effect: Clear, Painrelief Climate: Mild ----------------------------------------------------------------------------------- 2017-09-18. Week 4 starts and she is in flower. She is 36 cm high and looking really healthy. --------------------------------------------------------------------------------------------------------------------------------------------------------- 2017-09-19. 2 new fans is installed in the grow room. Added pic and video. --------------------------------------------------------------------------------------------- 2017-09-20. Kl 10.00. New video. The girl is 38 cm high and doing great. Kl 23.00. Did some massive defoliation, added video and pics ------------------------------------------------------------------------------------------------ 2017-09-22. The girl have recovered well after my massive defoliation. She is 39 cm high now and have received 2 liters of water and nutrition today.

This week I assembled the new 48x48x80 Mars Hydro tent and installed the new FOHSE Aries 600W LED light. I set the dim to 75%, but after two days, it was clearly too much, especially for 20 hours per day. I will dim it way down and shorten the hours until the plants appear to be doing better.

hello guys..its bin a long week but my girls are here at week 5,,week 5 will be the last final week of veg an hopefully the results will be good as they look healthy right know...its my first time doing everything what am doing here and i have learn allot,,,GG4 is a stable strain just don't top lower then 5 sprouts you will get a slow growth...with the HESI NUTRIENTS,,, I AM FEEDING EVERY 2 OR 3 DAY,,,and i am still going with NO BURN...the only stress they pass was HEAT in the first 3 weeks of veg,TOPPING and LST....lets see what week 5 brings guys..as i always say feel free to ask anything about my grow anytime..😏🙏🙏🙏💪💪💪😎😎😎

This week i flush the roots with tap water ( PPM : 310 , PH : 7.5) after i add water with 0.7 grow powder and 0.1g of Booster PK+ to reach 720PPM and adjust PH to 5.8 ---------------------------------------------------- -Daytime temperature: 27°C -Night temperature: 23°C -Humidity: 45-65% -Lamp: Mars Hydro FC3000. intensity 80% at 40cm from the top leaves -Room: Mars Hydro 100x100x180cm -Extractor: Mars hydro 402 CFM Max. power 2/10 -Substrate : 70% coco, 25% perlite, 5% vermiculite. My instagram : https://www.instagram.com/p/CuMhQ_BsjRP/?utm_source=ig_web_copy_link&igshid=MzRlODBiNWFlZA==

At the start of the week I fimmed a few high blooms to slow growth. Humidity kept climbing untill I added a carbon filter 4inch on a inline fan as an exhaust, added a 2nd fan to circulate more. Checked pH around 4 times a day due to.such a small tank. At the end of this week I defoliated and also took around 40 cuttings which I will post separate to this dairy, they will be in a DWC setup.

At this point I realized the plants wouldn't fit under the lights footprint. I have another light on the way so I decided to take the smallest one and put it outside and then topped all of its branches. Outdoor plant is being moved off of its bloom nutrients and back to neg because it will re-veg now. Indoor plant doesnt have any pictures but is continuing OK.

3th week begins! BBM #1 was transplanted!