Checkout my Instagram @smallbudz to see the Small budget grow setup for indoor use, low watt, low heat, low noise, step by step. 21/12/2019 - Fed her 1.5l of 6.4PH water with 0,5ml of each: Grow, Bloom and Max, and 1ml of each: Heaven, Alga-mic and Vera, noticed almost no run off, I use about 1/3 of the nutrient dosage on the chart, to achieve about 200/300PPM (500 scale). Did some light pruning also.

They seem to be packing it on now

Had to do this for the contest so I didn’t screw up my other diaries!

🍈 Melonade K — Week 4 Flower Mel is absolutely cruising. Stretch is wrapping up, flowers are stacking, and the frost is already coming in heavy. ❄️🍈 Started Green Sensation and added UV this week. She’s still pulling an 18–19% daily dryback and her root zone is staying beautifully balanced. Latest: 5.9 / 350 ppm in → 5.7 / 373 ppm out. Now we stack and swell. 🔥

Hi people 🤗 A lot has happened this week 😄 The 3 Blue Cheese and 2 Kosher Tangie Kush which have been in the flowering tent for 1 week have become very bushy 👍 Unfortunately I just noticed that I completely forgot to take pictures of the Blue Cheese Phenotype # 3 🤦‍♂️🏻 The picture will be given later. The rest of the Vegi tent is also progressing very well. They are repotted in 11 liter pots this week, and then come to the flowering chamber die the following week The next week there will be new pictures, until then I wish everyone a nice start into the new week 🙏🏻💪🏻 Let it grow 🍀🌱

10 September Harvest - see pictures. While some growers leave the plant whole when they cut, I do not. It is a personal preference and situational convenience if your a home grower. I chose to cut large, long branches, and remove any whole water leaves, as long as it doesn’t interfere with the bud formation. I don’t trim yet. This is done for a few of reasons: 1) It’s my last good close-up look at her until another 5 days or more, 2) I don’t want wet leaves drying on my buds if I can help it, and 3) I occasionally like being able to shine a small LED flashlight on the flowers while its drying. Mold is our greatest problem as growers, it can destroy a beautiful grow right up until the end process. Then I hang it in a dark closet, provide circulation and ventilation. Light and heat, anything above 80 degrees F, will start a break down in cannabinoids during the dry, it is ideal to stay away from both. I’m fortunate that a humidity level of 50- 55% and temperature of 65-70 degrees F is fairly consistent and easy to maintain. Anything below 60 degree F will prevent the adequate drying out of chlorophyll. Almost all my flower routinely take 5-7 days, some a little longer, to properly dry out. 15 September Trim - see pictures. First you’ll notice the buds have shrunk up to half their original size. This is just a fact that we growers have to deal with. Due to evaporation without uptake of water, it takes about 3 days for the chlorophyll to dry up, then slowly go through a chemical change. Along with the leaves, cannabinoids also begin a chemical change after 3 days called decarboxylation. A slow process where the THC level increases while curing. You want the leaf to be dry so they can be hand trimmed easily, but you do not want that bud so dry that it starts to fall apart in your hand. Try to handle carefully by the main stem to avoid touching the bud all together. A lot of these cut leaves will be covered with trichomes, good for making oils, or other products, it’s an option worth looking into keeping it. After trimming, I do separate a few premium flowers for my first smoq. Then loosely fill wide mouth quart mason jars with about 1 oz/28 gr of product per jar. I seal the lids for a few hours to determine what relative humidity they are at, see hygrometer pic, before making a decision to put in a 62% humidity control pack of my choice or to wait, then place in secure in a cool dark place with stable humidity and temperature. It is very important to then observe/burp or exchange the air as needed, up to several times a day, until 62% rh is achieved. Once your close to to your mark, put in your desired RH level control terpene shield. If you have a problem getting there: 1) it has dried out too much, no real solution, try to put several large cut stems left over from harvest into the jars with the buds to try and increase humidty, 2) it has not dried out enough, in this case no problem, just remove and dry out a little more. This is also a personal choice, some people like it drier in the 50% plus range. Whatever you do, research and preserve. At that time burping is no longer required. Cannabis will reach its peak potency potential at about 40 or so days into the cure. The finished product should be a perfect grind when cured correctly without clogging up your grinder, this could take a month. Now that I’ve said that, I’m sure someone has grown something that they have not been able to grind. It can remain in this state for an easy 6 months with little change, locking in all the terpenes and potencies. All you need to do is occasionally check the product to ensure there are no molds. If your grow/harvest/cure techniques are good this should not be an issue. It would not be uncommon to find many cannabis strains will last, with small degradable change, for up to one year after being stored this way. Using an airtight glass container, controlled relative humidity, maintained low temperature, and kept in darkness will equal maximum shelf life. Always avoid direct sunlight and temperatures above 80 degrees F. The reasons I’ve ultimately chosen Deep Water Culture as a grow medium. Each has their own pros and cons indeed. I found the most efficient, less maintenance and ideal solution for my situation was DWC. Burdens to overcome depend on size up set-up; initial equipment cost, size of containers, ph monitors, air pumps, type of water to use-reverse osmosis, RO cost/set-up/maintenance, ways to transfer/change water and nutrients, what nutrients to use and schedules, takes several grows to learn and understand, a 1 year learning curv, easy to nutrient burn. The Benefits of growing in water; no dirt, no bugs, no diseases, rare nutrient deficiencies/toxicities, steady and rapid growth that enables the plant to reach its genetic potential. After harvest, there is about a 1 hour equipment cleanup, sterilization and turn around process before replanting. Cannabis will perform in so many different ways and mediums, no one way is the best and the best way is the one you are using, right. Chose what works for you in the long run. There will always be an initial cost in set-up. My advice if one were in need to cut corners, I would not recommend cheap lights. This single factor is the most critical, afford for the best. The notion that organic and water has a different taste, flavor and potency effect is absolutely debatable. The more we learn the better we grow and experience is always the best teacher. This is what works for me and my methods of growing in general from beginning to end. A BIG “Thank You” to everyone who stopped by to take a look. My next diary will start at the beginning of October 2023 with a Forbidden Runtz Auto. There will be minor differences during the grow. I enjoy Auto strains simply by what can be achieved in a short time. No matter the strain they will unveil one thing in common, the demand for attention. Many times over it is the anecdotal gardener that surmount plant scientist. Last should I mention, do not forget to stop and enjoy the fruits of your labour...

Off to the races. So were 10 days into flower and they are still stretching. Had to pluck a leaf here and there. As always they have pretty much filled the tent. All is going as planned and looking forward to their final heavy defoliation and enjoying the first signs of buds. I sure tested the limits of the Skywalker yesterday. Starved her to much. Health issues arose and I was out of commission and lost track of time. I was worried because it took her several hours to recoup her strength and get those leaves standing back up.

Hello happy growers! All was fine this week, stretch still in progress and impressive, I've down 2 pots because plant start to be too big. My lamp is now to 100%, Outside weather start to be better, so temperature inside box a bit too much. I've given this week, start week, 2l water + easy grow tab rqs + sugar royal Today (end week) 2.25 water + easy bloom tabs rqs + canna boost. I hope grow continue like that, Have a good week my friends, See you next week 👊👊😍😍

So yeah I put them into 15 liter pot😊😏 and she is loving it 🌱🙏🏻😎 Really great start and big tnx again @Fast_Buds to make this happen 😎👌🏻🤙🏻 ---‐---------------------------------------------------------- 1x LemonCherryRuntz - Fast Buds 1x GG4 Sherbet FF - Fast Buds 1x Wedding Cheesecake FF - Fast Buds 1x Purple Cookie Kush - SensiSeeds 1x BlueDream - Zamnesia -------------------------------------------------------------- Marshydro 100x100x180 tent Marshydro fc3000 @ 60% G-tools 125mm with fancontroller 420m3/uur Day temperature: 24.5°c - 25.0°c and 50-63 % Night temperature: 18.0°c - 20.5°c and 55-65 %

willkommen zu meinem Superfreakigen Obstsalat_ grow ich habe vor ein paar wochen ein paar Stecklinge geschenkt bekommen Und zwar 😻Strawberry Bubbles ( bloom seed Co) 😻Strawberry Guava ( boom seed Co) 😻#1 Stunna F2 ( relentless genetics) 😀Bens+ Cherry ( Nine Weeks harvest und ich habe 2 Samen vor noch längere Zeit in die Erde gesteckt 😁Supafreak von Humboldt 😬und Stoopid Froot auch von Humboldt Vielen dank dafür ( Oim, El schifo, und chuck) Im Moment mag das GD system noch nicht die straineinträge ich werde das nachholen die Damen sehen ein wenig gefleddert auf den Fotos aus, da ich viele Clone geschnitten habe und sie dann in die Blüte geschickt hab aber ich bin sicher die Ladies werden hier zeigen was sie können.

Flowering day 35 since time change to 12/12 h. Hey everyone 😀. Both phenotypes continue to develop very nicely :-). The buds are getting bigger and bigger and the sweet smell starts to waft through the tent 😍. It's very much in the Skunk direction 👍. It was watered twice this week with 1.2 l per watering per plant. The tent was cleaned and everything checked for health 👍. We'll see you again next week :-) Until then, I wish you and your families a Merry Christmas 👍😀🙏🏻. Stay healthy and let it grow 🍀 You can buy this Strain at : https://sweetseeds.es/de/sweet-skunk-f1-fast-version/ Type: Sweet Skunk F1 Fast Version ☝️🏼 Genetics: Sweet Skunk Auto (SWS34) X Early Skunk 👍 Vega lamp: 2 x Todogrow Led Quantum Board 100 W 💡 Bloom Lamp : 2 x Todogrow Led Cxb 3590 COB 3500 K 205W 💡💡☝️🏼 Soil : Canna Coco Professional + ☝️🏼 Fertilizer: Green House Powder Feeding ☝️🏼🌱 Water: Osmosis water mixed with normal water (24 hours stale that the chlorine evaporates) to 0.2 EC. Add Cal / Mag to 0.4 Ec Ph with Organic Ph - to 5.5 - 5.8 .

Well well she looks might fine and healthy so that extra dose of Nitrogen really helped. The trichomes production is crazy she is so frsoty already. Strong healthy plant and ready to flower nice and sweet.👊🙏🙏😍

Frosty af, smells like berries or something like that. I need to press rosin from this one.

Day 49 to 56. I'm not going to hide that I'm in a hurry to finish the run. The mold arrived at the end of bloom because of me, it's depressing... Thanks for your comments these last weeks. :) This 8th and last week of bloom for the Kum Zuat 1. I continued to rinse the plant all week with power clean at 5ml/l. The Kum Zuat was harvested at 56 days of bloom with 1 week of rinsing. I still found some mold on some buds of several plants that I immediately removed. My yield will be affected, I still have this pretty Kum to cheer me up! All the photos and videos on this update are about Kum Zuat 1. The other plants have been fertilized normally for this 8th week, you will find them in pictures next week. I enter the 9 th week of bloom and I have 4 plants left which will be all cut on day 63 of bloom also with 1 week of rinsing. 1 kum zuat 1 kosher cookies 2 gmo x animal cookies Can't wait to start this new run.... I'll tease you a bit: Sanlight of course <3 Ebb & Flow Botafarm / Blueberry muffin Advanced Nutrients Are you interested in following this?