Ready for harvest

Did a top dress of some grow powder dry nutes from botannicare. Just giving her rain water for now. Again—- temps, humidity, and clouds have been aalllllll over the place. One day it’s 86 and the next is 66 with nights in the 60s or 40s—- humidity and rain have been 100% down to 50%. All within a week.

unfortunately😂😂 I do not have much to say the plant is healthy and has an excellent fragrance no problem detected ....

Had a little hint of root rot the other day so I’ve been adding Hydrogen peroxide. I took off a few fan leaves and increased light power 5%. Everything is going ok.

Esa familia , ya va quedando menos para cortar estas hermanitas skunk de Zambezaseeds, tienen algo de sobre fertilización de las últimas semanas pero llevamos solo agua 2 semanas. Ph regulado en 6,5 . Humedad por debajo del 40% , temperatura algo alta al trabajar con sodio pues en esta época sube vaya. Así que esto tenemos y las flores se ven bastante compactas. Nos vemos la semana que viene fumetillas.

2/6: Amnesia 3 is just about 6 inches tall now. Trainwreck is only a couple inches behind. Still keeping the temps between 73-82 and the humidity in the mid to low 70s. After thoroughly watering the very healthy, young tomato plant that coesxists in the tent, the tips of some of the leaves turned yellow. That makes me wonder if soaking the soil for the first time since transplant caused a bit of nutrient burn. I'm going to avoid any nutrients the first time I water Amnesia 3 and Trainwreck fully, to avoid the same potential issue. They're not looking too thirsty yet though. 2/8: Amnesia 3 is tall enough and has a thick enough main stem to start slowly low stress training with a rubber coated gardening wire. I pre-drilled holes in my buckets for this occasion, and the wire fits well. Each day for the next week I'll gently pull the wire to slowly bend the main stem downwards, similar to how braces work on teeth: a long, slow procedure. 2/9: Woke up to Trainwreck's leaf tips pointing downwards, so I took it as a sign to go ahead and give it its first watering. I siphoned up a bit of the runoff water, and it came back at a PH of 4! That's not good; however, after researching a bit, it's likely that I could have siphoned up a pocket of low PH nutrient-filled water, making my reading way off in terms of the PH of the whole slurry of runoff. If the leaves don't bounce back, I'm going to take that as a potential sign of Nitrogen toxicity and will monitor more closely. Will probably make plans for a flush if it progresses any worse than downward leaves. Nitrogen toxicity can cause fragile, dark green leaves that point down in a shape similar to a claw, among other symptoms. 2/12: Watered Amnesia 3 for the first time since transplant. Getting taller and less bushy in some spots, so I may turn up the lights from 60 to 75% tomorrow, to see if I can increase some more growth. But before, I want to make sure this watering doesn't cause any nute burn from the soil.

Simplemente una de las mejores Super Silver Haze o muy parecido que probado! Una pasada de sabores cítricos y terroso a la vez...hay que decir que sabor a Lemon predomina! Una gozada Farmers.

It was a easy strain to grow and was happy with the several watering she needed! I was feeding her every couple of days and she rewarded me with some immense dense buds! I have one more of this strain that might be heavier! I just got done with my 2nd plant and she was a big one! Got 792grams or 27 Ozas Wet weight! My best so far with a 5 plant limit this is the weight of only 2 of the 5 I grew..

Transferred them in 4x4 flower tent

This week I added a new controller to handle up to 8 functions. I installed a new heater, my old humidifier and some LED strips to the controller. Targeting a VPD at 1.0 day and night. Trying to keep the nutrient ppm under 900 and ph at 6.0 in the reservoirs. Ordered a second ph pen because I don’t trust my readings. Will be here by Thursday. Friday: Checked the ppm in the reservoirs and it’s at 1,000. Added more RO water with extra nitrogen to bring the ppm level down to 925. Saturday: I installed an updated AC Infinity controller 69 Pro Plus (controls 8 pieces of equipment) which allowed me to add a humidifier, corner LEDs and a heater to the controller. Overall I’m extremely impressed with this AC Infinity equipment. My VPD is within the range I want to achieve (.8-1.1). I programmed it to maintain 78 degrees and 67% humidity during the day, 73 degrees and 63% humidity at night. Charts posted also show the impact of an open tent compared to the closed environment. The heater is constantly pushing fresh air into the tent, so I don’t need to cycle the exhaust fan often. Rewired the tent again and moved the controller later that night. I mounted the controller on the wall. Added Mars Hydro UV/IR lighting to fill out all 8 slots on the controller. Sunday: I checked the ph in the reservoirs (6.8….i had filled it with 6.0 ph) and the ppm (1200 ppm…I had filled it with 900). So evaporation and possibly a mismeasurement of ph. I topped ff reservoirs with slightly stronger nutes and adjusted ph to 5.8 in the reservoirs. Poor magnesium absorption could be driving some leaf yellowing. Effective tomorrow, I’m switching over to Heads Formula which consistently feeds GH Flora series nutes at Micro (6ml/g), Bloom (9ml/g) and cal mag (3ml/g). Turned on the UV/IR lights for 3 minutes every 8 hours. I’m easing the plants up to 5 minutes every 6 hours which will provide the recommended 20 minutes of IR per day. This will help the plants stretch a little more. Monday: checked ph and ppm in reservoirs. 6.1ph and 880ppm. VPD remains stable except when I open the tent. Tuesday: checked ph (6.4) and ppm (880) in reservoirs. Added .5ml of ph down to two reservoirs. Still see slight yellowing between the veins but it’s not getting worse (might be improving). Adjusting ph down to 6.0 target might have solved this. The plants grew by 1-2” last night…..is the infrared light working already? Decided to mix up fresh nutes for the reservoirs following Heads formula. 6ml Micro and 9ml Bloom per gallon of RO water. Added 5 ml of CalMag too. Ending ppm was 1080 which is too high, so I diluted down to 880 with RO water. 6.0 ph. Wednesday: plants grew another .75 inches last night. I topped above the 5th node. Thursday: added RO water with heavy cal mag to reservoirs to increase amount of CalMag available.

Hello to my growmies, friends and visitors 👋👋👋 This was a happy week for me and the Blue Cheese, the plant has grown a ton, and finally started producing normal looking leaves :D The plant branches lovely with a little LST and under the bright Mars Hydro TS 1000 lamp which is set on 70 watt and kept about 27 cm from the plants, both of the plants look really happy under the Mars Hydro TS 1000 lamp :) I wanna thank Mars Hydro again for supplying me with this excellent equipment 😇😇😇 That is all for this week friends, growers and my grower friends...hopefully will see each other diaries next week... Bless, bless, bless 🙌🙌🙌

The plant is monster even though I topper at the 6th node she is 51in tall and smell nice fantastic but requires support the plant grows very tall even before having lots of weight in the buds it requires support . today I brought them outside the tent to give them a good water down in order to drain out any excessive buildup in the soil. I will continue to update but thank you for reading have a happy grow.

Heavy defoliation reduced a lot of yield