Mass cloning! Not sure how many are going in the greenhouse yet but I will just give away any I don't use.

They are going amazingly not had any work need as they have done it for me just done some defoliation to them so I could open them up to show of their amazing structure A is growing like a Christmas tree B has split herself at 3rd node and again at the 5th and theirs a new nodes popping up in the middle and it looks like she going to split again C went sideways ways when she started and give herself 3 main head's and now pushing new nodes everywhere from the bottom

The bigger plant is pumping well although it could do better given its indica genetics but that's okay... I think they do not give their best because of the lighting that does not reflect well D:, next cycle I will gear up a little bit better

I apologize upfront for all the photos. It was hard to pick which ones to upload, so I picked a good variety. There is gonna be between 4-6 pounds once dried/cured. These were all super dense and very little larf. This was a higher temp/higher humidity run with lots of co2 and they blew up big. It’s been a minute since I’ve grown a cola or 2 that were bigger than my arm…this time there was dozens of them. Each plant was only topped one time. The temps were usually mid 80’s and humidity in the mid 60’s during flower. This might seem high to some, but learning to apply VPD to a grow should not be trial and error, in other words, this was intentional. It’s not risky either. During the first 6 to 7 weeks of flower it is very important to not let your night time temps to go below 75 degrees. POWDERY MILDEW=LOW TEMPS AND HIGH HUMIDITY. Take one of these away and there will not be any powdery mildew! Do not let your temps go below 75! The last 2 weeks I dropped the humidity to 40% and my night temps to mid 60’s for resin production. A couple of thing one should have to create large buds is a temperature gun(for leaf temp), a par meter and co2. Keep the stomata open and feed lots of co2=huge buds. Learn about VPD and not just a quick google search! When it’s dry and cured I’ll be back for an update on weight, taste and effects. Currently the plants are drying in the room at 60 degrees and 60% humidity until I can get in there to trim them. Might be 2-3 weeks. Thanks again for all the likes and comments!

In the end she went longer than expected but that's cool 😎 super dense buds . I really enjoyed this strain. Very nice smoke. Gromie's use the promo code GROWEED for a 15% discount on any Fast Buds purchase.

I forgot to refresh diary. Plants are growing well.

So overall, very good strain. Can't wait for drying and curing of this one. Definately gona do again. Thanks sensi seeds for the strain and the win. I'll update on the smoke Happy growing👊

Been brewing my ewc tea with as many other ingredients including ewc,kelp,fishbone meal, oyster shell, crab meal, glb fish, and makos. Fed them the tea in the morning and they loved it. That being said fourth node was developing so I topped. After doing some research I may have topped to early but they seem to be bouncing back just fine actually. I did six of the seven. Last one has been slow from the start so probably won’t have much of a yield. Plan on using tea often

Second week in stretch training a bit more with the net.

First time running dwc. So this should be fun and interesting. I’m ready 🌱💪🏽

***Mar 22 Week 2 of flower, looking really good. I made sure to give the reservoir a little extra ppm this time around, because last week the plant ended the week hungry. I put a little extra Plant-Prod in this week, hopefully the extra 300 ppm will be enough this week! I went in and took off some leaves that were blocking the inner nodes, but I didn't take off any small bud sites on the inside *YET* ...I want to wait til stretch is done before taking anything major off, just in case it catches up by then. I will say that it is looking a lot more open now that I took a handful of leaves off. Most of them were overlapping other leaves, or just straight up too big. Others that didn't seem like much of a threat, just got tucked under other branches or leaves. I'm trying to be as hands-off with this grow as I can. Freakshow doesn't seem to like being played with too much. PPM is at 1850 and PH is at 6 Lots of pictures to start this week off, and also a small video to better detail how to plant is growing. I may have to switch CalMag brands by the end of the grow, unless the bottle will last me (I'm sharing my nutrients with my partner), but I don't think that would make too much of a difference, but it's worth noting. I also would like to note that I have not topped, LST'd, or any other training method to be precise, other than taking the top two leaves off as they get too big, I have not done anything else to make this girl get so wide. The canopy has been doing it' all on its own. The roots have been growing around and over the bubbles in the water, making them spread out almost like a cup (my partner has a theory that may be why the plant has been getting wide instead of tall... He believes the plant tends to take on the shape of the container it is it; aka the shape of the roots). I can now confirm that she is a female, as shown in the picture, you can see 2 long pistils coming out! ✊ I think I have the smallest amount of powdery mildew starting, because of the humidity being so high, BUT I have taken all other plants out of the tent, so this freak is all on her lonesome inside the tent now. I have seen an immediate improvement this morning, so I am not concerned over it. Beautiful start of the week, and can't wait to see how it goes the rest of the week! Should expect to see a lot of bushing and hopefully some trichome production by the end of it. Have a wonderful week everyone! 😻 ***Mar 24 Already drank 2 full cups of water (around 2L) and down from 1850ppm to 1600ppm ... oh boy!!! She's so hungry I wonder if I'll be able to keep up hahaha. She's looking really happy and healthy. Roots are still growing like mad. I wanted to trim them, but going to hold off a bit so I don't stress it out. ***Mar 26 ...The amount of water she is drinking is outrageous. I actually had to feed a little bit more nutrients (Plant-prod 15-30-15 about 0.3 tsp to bring the ppm from 1200 to next to 1500 to get through til monday/tuesday) and a sprinkle more of soluble seaweed. I did a little lollipopping tonight as well! Looking much more open and I took out a lot of the small bottom bud sites and leaves that weren't really getting any light. Everything is looking super good, and still no health issues. Doesn't seem to be missing any nutrients, but also doesn't seem to be bothered by having extra nutrients either.

Strain: Fast Buds Mixed Auto Grow Type: Outdoor Pot Size: 5 Gallon Medium: Coco Coir & Perlite Nutrient Line: Athena Harvest Update This Mixed Auto exceeded my expectations super frosty and dense, especially for an outdoor grow. After a full dry and cure, the buds turned out beautifully. The smell is rich, and the trichome coverage is impressive. The smoke was flavorful and smooth, making it a very satisfying experience overall. I didn’t get a chance to take much footage, but for an outdoor run, she really delivered easily one of the highlights of this grow. Drying Climate Conditions Temperature: 20–22°C Humidity: 50–55% Until the next one stay lifted, and remember to use my code ISLANDT for 15% off your next order at Fast Buds!

At least one if the ladies is ready to harvest. Just made a final check with the microscope and i think she is ready. I could wait a bit more for more amber heads but i think thats ok.

Day 37. Bigger girls got bottom trimming, still will do lolipoping in 10 days or so. Two smallest plants, which now stand in shade will go to greenhouse, just have no space for them. One Blackberry went purple already. Strawberry Banana grows nice too, BUT IT SMELLS LIKE STRAWBERRY BANANA in real life, just touched the best plant and was blown by sweet fruity smell !!! All Orange Sherbets grow small. No feed all week. Happy Growing !!!

Woche 4 – Blüte beginnt 🌱 Mit dem Start der 4. Woche habe ich die Beleuchtung auf 12/12 umgestellt. Damit ist jetzt endgültig die Blütephase eingeläutet. Bei der Z42 und der Biscotti ist bereits ein deutlich stärkerer Stretch zu beobachten. Beide legen ordentlich an Höhe zu und entwickeln sich momentan ziemlich dynamisch. Die Papayton macht ebenfalls einen guten Eindruck. Sie bekommt immer kräftigere und ordentlich entwickelte Triebe und füllt langsam ihren Platz aus. Insgesamt wirkt die Entwicklung sehr vielversprechend. Jetzt bin ich gespannt, wie sich der Stretch in den nächsten Tagen weiter entwickelt und wie schnell sich die ersten richtigen Blütenansätze zeigen.