Processing
Likes
9
Share
Following full strength full line of Cyco Nutrients feeding chart now and they seem to be growing Healthy and at a steady pace finishing up week 2 of feeding chart
Likes
28
Share
@Bongman
Follow
Hi All, I think I must have missed a week, don't know how I did that but I switched on the 16th OCT and this should have been the fifth week of flowering. Anyways I will change that over the weekend. Weekly update: *What's happening in the garden. So starting the fifth week of flowering and the buds are starting to bulk up. I still think the canopy is too dense but I am going to pretty much leave it and see how it plays out. Maybe I will thin out one large colla and see if that's going to grow a lot better but I don't know how meaningful this will be going forward. *On-going problems 1. Top canopy leaves still showing red stems. (I am almost to a point where I think this might be genetics) 2. Sweating problem - I've tried to lower temps, thin out canopy and dimming light. So I've done all that with limited success UNTIL I moved two dehumidifier into the room and lowered the RH in tent from low 70's to low 60's and I directed the top fan directly at the canopy rather than blowing slightly above the canopy. That seemed to help the plant sweat without leaves pointing up and tacoing. 3. Brown goo in reservoir - I am seeing some brown goo started to grow again but less than before. So I am going to increase the cannazym, hydro guard and PH at 5.5. *Neat trick to slightly increase your grow tent area. Since this is a monster mother plant in a 2x4 tent. I've been having trouble keeping her in check especially on the perimeter of the canopy so I actually added a input fan to decrease humidity and increase air flow and also created a positive atmosphere in the tent so the tent basically increased 10- to 15% in volume especially in the middle of the tent where my canopy is at so this gives her more room to bulk up the buds.
Likes
7
Share
Mixed nutrients today. Last night I added 2 ml of oxy science h202 to 18L of Kamloops City water filtered through our homes water filter, no idea what it does exactly lol. I put an air stone over night and let the water bubble off any chlorine and the rest of the h202, I use microbial mass so I just wanted to sanitize the water but not kill my soil. Mixed in bases first into 21.7 C ph 8.1 Water in the morning. Important not to mix concentrated solutions, I used syringes that I rinsed well between products. I find that with this product you just follow the instructions and it’s pretty awesome results.
Likes
9
Share
7/18/25 chopped and hung. Will update with more pictures and videos and dry weight in 5-7 days Check out my YouTube channel for more behind the scenes that aren't on here. https://youtube.com/@aestheticgenetix?si=sKoIKf9kAmFlIWQo
Likes
27
Share
@Bncgrower
Follow
Harvest done, I believe the result would be better if it hadn't suffered so much. But it's within expectations, let's see how it turns out after the drying and curing process..
Likes
5
Share
@LAShugars
Follow
She stretched on me. Turned up the light a little . I made a mound with the coco around her to keep her up right. I purposely don’t fill the grow bag to the top for this reason. She’s already strong enough to hold her self up now. I’ll add a bit more coco for extra support. Added some dynomyco
Likes
119
Share
How much I like to grow guys help me.... I would like to have those fucking sheds in front of me to SLEEP IN.... together with all my girls.....Ahhh...I hope one day someone powerful from America finds my fucking wasted talent and comes to save me😎
Likes
43
Share
@Pearl
Follow
She's steadied out on the stretch for now She has taken her own weight throughout, a nice feed of silicon gave her the boost she needed.
Likes
179
Share
💩Holy Crap We Are Back At It And Loving It💩 👉FOLKS WE R ALMOST TO THE FINISH LINE👈 Growmies we are at DAY 70 and she's just killing💀it👌 👉We are in full flowering mode and she's doing great 👈 Everything is looking good even the Tiny Cup 🥤 So Shit , I gave them just a tad to much nutes at the start of feeding 👈 But I have since fixed it So I'm still doing some low stress training 🙃 and some defolation 😳 Lights being readjusted and chart updated .........👍rain water to be used entire growth👈 👉I used NutriNPK for nutrients for my grows and welcome anyone to give them a try .👈 👉 www.nutrinpk.com 👈 NutriNPK Cal MAG 14-0-14 NutriNPK Grow 28-14-14 NutriNPK Bloom 8-20-30 NutriNPK Bloom Booster 0-52-34 I GOT MULTIPLE DIARIES ON THE GO 😱 please check them out 😎 👉THANKS FOR TAKING THE TIME TO GO OVER MY DIARIES 👈
Processing
Likes
26
Share
Everything is going well The big blackberry is in livingsoil so water & urb only Blackberry #2 is growing strong Smoothie looks great too
Processing
Likes
3
Share
@camo420
Follow
NEW BOX: 130x60x120 DIY: storage shelf, solid sheet metal ELECTRO ################################ thermometer top thermometer bottom hydrometer wlan ip cam (+ir filter) ---------------------------------------------------------------- input: x2 USB PC fan exhaust: x2 USB PC fan circulation: x2 USB fan ---------------------------------------------------------------- led panel 1: 300W ASUNDOM LED (Veg/Bloom/Full) led panel 2: 300W XHGrow Reflector-Series LED (Full) ---------------------------------------------------------------- studio light 1 (vegetation): 36W TaoTronics LED Gold studio light 1 (vegetation): 50W Balai LED full studio light 2 (vegetation): 8W VINGO LED blue ligh studio light 2 (vegetation): 50W Balai LED full ---------------------------------------------------------------- studio light 1 (bloom): 36W TaoTronics LED Green studio light 1 (bloom): 36W TaoTronics LED Gold studio light 1 (bloom): 50W JADIDIS LED IR full studio light 2 (bloom): 36W TaoTronics LED Green studio light 2 (bloom): 36W TaoTronics LED Green studio light 2 (bloom): 36W KINGBO LED Deep red 660nm 3x PLANTS ############################### FastBuds Girl Scout Cookies pots: 14L soil: plagron grow mix
Likes
198
Share
@DevilsBud
Follow
FLOWERING STARTS In the the new marshydro set-up 120x120x200 4'x'4 FC-4800 lamp Pubes are showing on all of them happy days in the absolutely amazing marshydro tent 👌🏻💯👌🏻 and no balls in the room yet so that's good at least i know that first grow i had issues with hight but with my 120x120x200 that not going to be end problem so stretch like ya never stretch before 💪🏻 i am prepared now lol the FC-4800 is a beast and still tweaking hight dimmer don't want to burn them but also want to utilize the lamp as much as I can but will get under control 🤘🏻😎🤘🏻 1/11/21 Did some last defoliation and spread the plants out bit Tru the tent got lamp dialed in dimmer around 55% and hight around 45cm above the plants and every week will bump up the dimmer with 5% they are looking very good healthy and i am very proud of the results so far gave the proper nutrients and the normal watering in between everything cool in the hood Will be updated soon happy growings Growmies visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter
Likes
14
Share
@GRow_M8s
Follow
* 20/24 lights (4h/day rest) for 3 days.after that we continued with 24/24. * Add some extra advanced formulations from this week. ⚠️ Stay tuned 👇 🗓️🔜 week 7 --> we'll make a review to the progress of the different strains inside the tent with photos and vids.
Likes
16
Share
Got the newly released FC-E3000 by Mars Hydro! Gonna grow my first Mephisto strain as well. Can't wait to share my progress with everyone! Edit. Day 6 and everything is looking good.
Likes
4
Share
@KhaVigga
Follow
i went to work like 2-3 days not coming home and she is nearly dry out to dead but luckily i came back in time and fix it.
Likes
23
Share
MATARO BLUE by KANNABIA Week #17 Overall Week #3 Flower This week she's looking good 👍 starting to make some nice looking buds however it's still hot here so hopefully that doesn't have a adverse effect on this lady!! Stay Growing!! Kannabia.com MATARO BLUE
Likes
22
Share
In the final week, highly resinous flowers that I cannot wait to sample from the 3 phenos. Had more pics and vids but the site won’t let me upload. Hope everyone has a great week! GHL