Likes
Comments
Share
Ladies and gentlemen, today is day 27, and this girl is doing great.. i just gave her a feeding around the rim of the pot .. she's leaning a little bit because my eternity grow plant is taking up all the tent, and this poor little girl is struggling to get light.. She's looking good though she will prevail and I believe end up being a great plant.. Kannabia seeds much appreciated. You guys are great genetics, so far doing great as well.. God bless everybody and happy growing ✌️. P.s i'm unable to upload the maxibloom nutrients in the general hydroponic silica that she's getting as well..
Likes
12
Share
Temps have been good and RH has been steady between 60-65%. I have good airflow all around and don’t worry too much about it the higher RH at this point in the grow. Transplanted the ladies from their starter pots to their 2 gallon pots. They did not seem to have any transplant shock. A few more weeks and we will go to their 4 gallon final pots.
Likes
12
Share
@Shinobi
Follow
Kvety sa rozbehli😉zatiaľ všetko vyzerá OK.držte 👍👍
Likes
9
Share
Over all Cosmo is doing well. Seemed a bit slow taking off but she is progressing nicely at this stage. Day 7: Cosmo showing second leaves coming in. Still slightly yellow, might be hungry or slightly over-watered. Will feed nutes in the next few days and see. Temp: 75º RH 75% PPFD: 300 VPD: .41 kPa Day 8: Just misting no water or nutes yet. Looking good. Temp: 75º RH 75% PPFD: 300 VPD: .41 kPa Day 9: Fed 2ml Cal-Mag, 2 ml FloraMicro, 1ml FlorGro, 1ml FloraBloom PH 6.2. Temp: 75º RH 70% PPFD: 400 VPD: .72 kPa Day 10: Responging well to nutes. Looking much darker green today, must have been hungry for nutes. Temp: 70º RH 75% PPFD: 400 VPD: .72 kPa Day 11: Growing and looking darker green today. New leaf growth. Temp: 77º RH 55% PPFD: 500 VPD: .67 kPa Day 12: Cosmo looking a little top heavy, leaning to one side. Gave her a little prop up with a stick. Temp: 73º RH 62% PPFD: 500 VPD: .67 kPa Day 13: New leaf growth. Temp: 75º RH 60% PPFD: 500 VPD: .62 kPa Day 14: New leaf growth. Fed 4ml FloraMicro, 6ml FloraGro, 3ml FloraBloom and 2ml CalMag. Temp: 78º RH 61% PPFD: 500 VPD: .76 kPa
Likes
16
Share
Day 22 of Flower! Did as much lollipopping as I can in a Days work.. will continue through the next 2 days to touch and clean up the bottom of the canopy. After that..no touching the plants..will let them slide through flowering with just feeds.
Likes
490
Share
Day 69: harvested today will update day after day how the drying goes! Day 70: dont have a rh meter hahaha so i hope its not to dry in there. Seems like Day 72: hahahahaha fucked it up today! Had the humidifier on without my controller!!!! So 99%rh in drying tent when I came home… good job..😂🤦‍♂️🏽🤦‍♂️🏽🤦‍♂️🏽🤦‍♂️🏽 Day 74: still drying but had to take my tent down so had to cut the plants as well! So trimmed them to speed the drying up a bit! The buds look really yummy, but doesn’t smell any good yet hope that change in the upcoming days Day 77: the buds just taste better and better 😁 This is the light that I’m using for this grow! Mars hydro SP3000 High PPFD at 2.8 umol/j, average yield at 2.5g/w, increasing your yield 50% or more compared with old blurple and HPS lights, 300 watts output. Dimmer knob added, more convenient to adjust the brightness. Up to 30 lights can be daisy-chained and control together on just one light, or just have one lamp in 120x60 tent is perfect for light. https://www.instagram.com/marshydro_aliexpress2/
Likes
3
Share
Pflanzen kamen bei mir an. Alle gesund und haben den Transport gut überstanden. Selbst in den Tagen darauf keine Anzeichen für Stress. Bei mir sollen die jetzt nochmal nen Schub machen, getrimmt werden und dann in die Blüte geschickt. Licht läuft momentan auf R49 W99 B99.
Likes
17
Share
Week 4 Not Much Difference From Last Week A lot More Stickier and More Thc Showing On Both Plants
Likes
41
Share
The smell in the tent is amazing right now. This girl just reminds me of being in Amsterdam. That haze smell is unreal! She is fattening up nicely! It won't be long till she will have a little extra space in the tent! She is in autopilot right now.
Likes
14
Share
@Smokwiri
Follow
Welcome to the 7th week of my Royal queen seeds Royal Gorilla diary Development is very good, this week i've added some guano tea to the watering, leaf is looking good she's liking the outdoor weather, i'm impressed with the growth responded very well after the HST the shape is nice and a bit strange ofcourse, i don't need the stealthy look, but i like it
Processing
Likes
13
Share
las cepas de royalqueenseeds van creciendo muy bien !! impecable hasta ahora todo funciona excelente se notan sanas y muy pequeñas para tantos nudos , esto se ve esperanzador seguimos aprendiendo y si definitivamente el living soil es lomejor ! solo vean esas nenas como están de felices , natural, organico, barato y reciclable
Likes
198
Share
@DevilsBud
Follow
FLOWERING STARTS In the the new marshydro set-up 120x120x200 4'x'4 FC-4800 lamp Pubes are showing on all of them happy days in the absolutely amazing marshydro tent 👌🏻💯👌🏻 and no balls in the room yet so that's good at least i know that first grow i had issues with hight but with my 120x120x200 that not going to be end problem so stretch like ya never stretch before 💪🏻 i am prepared now lol the FC-4800 is a beast and still tweaking hight dimmer don't want to burn them but also want to utilize the lamp as much as I can but will get under control 🤘🏻😎🤘🏻 1/11/21 Did some last defoliation and spread the plants out bit Tru the tent got lamp dialed in dimmer around 55% and hight around 45cm above the plants and every week will bump up the dimmer with 5% they are looking very good healthy and i am very proud of the results so far gave the proper nutrients and the normal watering in between everything cool in the hood Will be updated soon happy growings Growmies visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter
Likes
8
Share
@Rko41
Follow
Jolie buisson les têtes s’agrandissent vite c’est une fast version vivement le changement de couleur
Likes
4
Share
@pzwags420
Follow
On day 1 I changed out my reservoir. I lowered my nutes to 650 ppm(25% reduction). I adjusted the PH down to 6.1. My left plant has some burnt tips from either PH shift or over fertilization. My hope is that the lower ppm will help to resolve the issue before it spreads. On day 2 I adjusted the reservoirs PH from 6.3 to 5.9. On day 3 the reservoirs PH is 6.0. I installed my new 200 watt HLG Rspec. I adjusted PPFD readings to 700-1300 PPFD on all tops. On day 4 I adjusted the reservoirs PH from 5.8 to 6.2. On day 5 I adjusted the reservoirs PH from 6.4 to 6.0. I diluted my nutrients in my reservoir by removing one gallon of nutrients from the rez and and adding 2 gallons of straight tap water to the rez. This brought the nute concentration from 770 ppm to 540 ppm as the plants will be entering the ripening stage in a few days and they have too much nitrogen judging by the extremely dark green leaves and burnt leaf tips on some branches of the left side plant. The buds seem slightly smaller then my last run which may be due to an excess of nitrogen and maybe not enough light as some of my tops are taller then the others making proper PPFD challenging. All in all the girls are coming along nice and I look forward to the final weeks of flowering 😀 On day 6 I adjusted the reservoirs PH from 5.9 to 6.2. I think I have halted the nute burn as I haven't seen it progressing any more on the leaves. I will continue to monitor closely during these final weeks. The trichome production is increasing with some trichs on top of colas starting to go cloudy. The pistils are turning brown with roughly 40-50% are turning brown all signs I'm getting closer to the harvest window 😆. I dimmed my light to give 600-1000 PPFD to tops. On day 7 I reduced my temps to 75 during the day and 68 at night. I adjusted the PH of the reservoir from 6.6 to 6.1. My reservoirs ppm was too high so I diluted the rez with 2 gal of tap water. This brought it down to 480ppm. The average ppfd to all 14 tops is 604 with no top receiving more than 1000 ppfd
Likes
12
Share
Harvest time for amnesia lemon haze. Intense lemon smell, tall stretchy girl with big sticky buds! While her height almost became an issue, she managed to finish with minimal light stress and just a few signs of foxtailing. Will update in 7-10 days with initial smoke and dry weight. Thanks for tuning in to this grow 👽🌳🔥💚 Update - 79 grams dried, minus a couple grams for the smoke test. Buds have a lemon smell and a lemon fruit flavor when smoked.