The Grow Awards 2026 🏆
Likes
Comments
Share
@BLAZED
Follow
Week 14 (16-9 to 22-9) 16-9 Temps: 19.2 to 23.2 degrees Humidity: 55% to 66% Watering #1: 700 ml. Light set to 12/12. Finally! It looks like the plants are recovered so i decided to flip to flower. Dry Weight #1: 3.5 kg. #2: 4.0 kg. 17-9 Temps: 20.4 to 23.6 degrees Humidity: 59% to 67% Watering: Both 500 ml. Dry Weight #1: 3.8 kg. #2: 3.9 kg. 18-9 Temps: 17.9 to 24.1 degrees Humidity: 61% to 74% 19-9 Temps: 21.2 to 24 degrees Humidity: 64% to 73% Watering: Both 500 ml. Dry Weight #1: 3.5 kg. #2: 3.7 kg. 20-9 Temps: 19.1 to 23.5 degrees Humidity: 60% to 70% Watering: Both 500 ml. Dry Weight #1: 3.6 kg. #2: 3.9 kg. 21-9 Temps: 18.7 to 24.5 degrees Humidity: 59% to 70% Watering: Both 500 ml. Dry Weight #1: 3.6 kg. #2: 4.0 kg. 22-9 Temps: 19.5 to 24.5 degrees Humidity: 59% to 71% Watering: Both 500 ml.
Likes
47
Share
Was a bit stressfull week the plants on the left side of the pot seemed to be dehydrated, after i gave them water twice they recovered a lil bit. As you can see the plant in the middle is huge. I will take some clones of her to equalize the canopy eventually. Monday i will switch to 12/12 and i think i will take the clones next week and start an other diary for them aswell. Big pot s a bit problem with watering but i learn as the proces goes. They need a lot more water than im giving at the moment but im looking for a sweetspot. So for now im ordering an tensiometer and an fertometer so i can properly feed them in the flower period
Likes
8
Share
@Wondrej
Follow
🚀 Week 8 Overall | Flower Week 3: Taming the Beast! 🌿 What’s up growmies! Hopefully you are enjoying your Christmas time 🎅 Today is December 29th, marking the first day of Week 8 overall and the start of Week 3 of Flowering. The stretch has been absolutely relentless! Even after my last adjustments, the girls were still pushing too close to the light. Today, I had to do some final low-stress training (LST) and bending just to maintain at least a 20cm gap between the tops and the LED panel. I’ve got my fingers crossed that this is the final week of the stretch—I’m officially out of vertical space! Recap of the recent "Rescue Mission": • Heavy Lollipopping: I’ve cleared out the entire bottom section (the "skirt") to maximize airflow and focus energy where it matters. • Canopy Management: Raised the AC Infinity net and thinned out the jungle. It was a massive defoliation, but necessary for the plants to breathe. • Organic Strategy: I’m still seeing those yellow tips from my initial soil mix mistake, so I’ve started adding Organic Silica to help the plants handle the light stress and strengthen their structure. The plants are looking much more manageable now, even with the minor nutrient burn. Now it's time to stop the vertical growth and start stacking those flowers! 🌸❄️ How's your end-of-year grow looking? Any advice for the Week 3 "stretch-ender"? One Love & Happy New Year, growers! 🇯🇲💚
Likes
3
Share
May have added more nutrients forgeting the pot already came with its own nutrients for the seed. So just add 6.5 water. I’ve decided to add Fish shit to boost the growth along the way. Don’t know if it’s needed or not. The sprout is growing its first set of fan leaves which appear to have a couple spots. I left the soil uncovered for about a week so nutrients may be for concentrated at the top of soil causing slight nutrient burn spots… I’ll just keep using decholinated 6.5 water
Likes
48
Share
@AsNoriu
Follow
Day 117. Trim jail and heavy upload session for 24 hours at least. Don't like to keep photos, so ill upload each plant separately and will delete them. Phone camera is still cracked and off-focus, but they are all nice ! Day 128. I knew that those plants will be smallest, but Mini was in centre and her buds were still not nuggy nuggy ... sadf ..... #1 67, #2 68 , #3 75 , #4 56. 266 total . 836 from 720W is good, not my best, but good, just that airy quality .... Happy Growing !!!
Likes
52
Share
@Rangaku
Follow
Pulled the second cherry Cola today and it looks and smells just like heaven , some nice pinks , purples and greens . Plants look to be around 12 oz together but we’ll see how they dry .
Likes
16
Share
I just entered flowering stage, I switched to the bloom nutrients and I've stopped putting Rhino Skin like 2weeks ago and now am adding NIRVANA to help with the phosphorus I've also gave them a well needed defoliation try to focus all the energy in the pistils I've dropped my lights as well and my I've been keeping an eye for my temp. Don't want it to go above 80° The order am mixing my nutrients are: •hydroguard •Nirvana •CalMag •Bloom A •Bloom B • pH balance to 5.8 So far their pryin' up wards after I dropped the lights the seem to respond well.
Likes
4
Share
This week was a lil tougher then usual.. ran into a bad deficiency that took me a minute to get a hold of, but everything seems to be moving along great. Getting her frost on and building to her stack 🤩 Follow my personal grows on IG where I upload only cannabis. @authenticgrow . I only have 2 plants on grow diaries but 8 others on IG😃
Likes
49
Share
@DevilsBud
Follow
New week for the 2 pineapple dream edition Both pineapple dream edition are different from each other but nothing extreme they both smell like pineapple tree the buds are rock solid and glazed with trichomes just amazing stuff it's going great there at a size that adding extra nutrients is waste and only making flushing take longer so starting to lower all nutrients and preparing for last week exited times Happy growings Growmies 🤜🏻 🤛🏻 visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter
Likes
6
Share
Finally we are done, I spent one 10 months on Durban Poison, this is my best sativa strain and im absolutely in love. So next report will be with some Clones of Durban Poison.
Likes
18
Share
Some test and fail in preflower .. Bud grow but not well ..... But Is a must in a grow
Likes
18
Share
@Mazgoth
Follow
It's going really good,I've notice today day17 for the plant that had those white thing on the leaves witch maybe caused by bug or spiders,I took the spidermite control organic 100ml bottle,I add 2,5 ml product with 120ml water and I spray the hole plant, the entire tent and the soil,I will spray again next week to,and repeat every week for the best results,so about 2/3 weeks..Tell me your opinion and if my plant looks healthy or not.(UPDATE)Day18 topping.(UPDATE)He had some damage to the leaves because of an organic product that I used for bugs, I spray the entire plant and damage some leaves,the topping is looking really good
Likes
7
Share
These 3 Gelato auto are part of a 30 plant SOG project, in this diary we will only focus on this fantastic strain as you can see, this is Gelato auto by fast buds grown with nothing but FLO (living soil blend) mixed up with the soil and water 💦, let's see what type of flavors we are going to find! Stay tuned for this one! 👨‍🌾❤️💚
Likes
6
Share
So started this in mid June/early July in my greenhouse. This was my first greenhouse grow! During the summer temps reached up to 130f. I was a little nervous with the heat during early flower but she handled the heat very well. Before the chop, temps got low as 45f at night. I never had any issues with pest (I used 500 lady bugs and 2 praying mantis). Checked every week for mold since the buds are super stacked. No bud rot or any type of issues. I will grow this again because I didn’t take clones :(
Likes
7
Share
@PapaBaer
Follow
Fuck MOLD to less Ventilation... I need to harvest bevor erveryone is going damaged.. Tomorrow I'll cut all fanleaves and the day after tomorrow I'll harvest them all. I cry about this but I've 100g Mold Buds... Better a smaler bud than no bud😂
Likes
102
Share
@Roberts
Follow
I am dropping a Ztrawberriez auto seed from Fast Buds. I will be growing her in a 1 gal Ice cream pale. The only substrate will be just course perlite. Thank you Fast Buds. 🤜🏻🤛🏻🌱🌱🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g If anyone needs to purchase fastbuds here is a link for my affiliate program https://myfastbuds.com/?a_aid=60910eaff2419
Likes
8
Share
Still waiting for that foggy trichrome and amber to follow