Air umidity is getting high, I'm a little concerned about mold. I took some leaves. Let's try getting to achieve more 15 days till chop it.

SUMMARY: I flushed the NL with tap water straight from the hose. I’ve heard you’re supposed to flush with 3x the container volume, however that would be around 57 litres for a 5 gallon pot which seems absurd. I didn’t record the amount but I took my time and flushed with at least 30 litres. I will now continue to flush until harvest on 10th April by which point she should have faded nicely and used up any residual nutes. I read that the each time you water/irrigate you draw oxygen into the root zone and this promotes growth and in turn helps to increase yield and so I will endeavor to water her twice per day now until harvest. DAY 86 ----------- Sunday 28th March I flushed the NL with tap water straight from the hose. I’ve heard you’re supposed to flush with 3x the container volume, however that would be around 57 litres for a 5 gallon pot which seems absurd. I didn’t record the amount but I took my time and flushed with at least 30 litres.

Hola a todo el mundo!!!. Esta semana solo regué con agua, ya que he visto las hojas no muy bien. Y mañana ya comienzo con el lavado de raíces. Espero ansioso el corte🤪🤪🤪😅😅😅

Soo week 2 girls seem to be doing good ! Been faffing around with temps and humidity as struggling to get a stable reading for both especially with the weather getting more hot! But will keep trying to get this spot on l. Will be re potting The zkittles this week I reckon ! Update : With the addition of the RAM 5L humidifier the plants are loving it and the temperature + humidity is very stable and normally reads between 50 and 60 during the day and 40-50 when lights are off following this with the the temperature during day between 27 and 29 when lights are off stays between 20 and 23 I made some adjustments such as going down to 400 watt on my ballast and it works well when it’s like an oven outside so quite happy with these readings as before my temp was over 30 and humidity would not get past 35! Week 3 slowly commences where the nutes will be introduced I have opted for plant magic ! Price was reasonable and after reading reviews it does bring results , I didn’t fancy spending too much on nutes as I’ve spent a load on everything else haha but hey we shall see how it goes Happy growing 😜🤩

There were alot of super small fruitflies in the soil, Anyone tips? Right now i am just killing them all.

All seems to be progressing nicely had a bit of a heat issue because of the weather i got got in at the minute but apart from that all is well

Flowering day 22 since time change to 12/12 h. Hey guys :-) Another great week that is over. They all develop exactly as it should be 💚. Since the last leaf and substrate application against tripse, I finally haven't seen any of the little biters 👍. Watering was done twice this week with 1.3 l each time (see table above for nutrients). The lowest shoots were removed so that the energy is not wasted in the lower part :-) . Otherwise, as always, everything was cleaned and checked. Fresh osmosis water was filled with stale tap water in a 100 L tank for the coming week 👍. Have fun and stay healthy 💚🙏🏻 👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼 You can buy this Nutrients at : https://greenbuzzliquids.com/en/shop/ With the discount code: Made_in_Germany you get a discount of 15% on all products from an order value of 100 euros. 👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼 You can buy this Strain at https://pcg.international/shop/pcg-int/ Water 💧 💧💧 Osmosis water mixed with normal water (24 hours stale that the chlorine evaporates) to 0.2 EC. Add Cal / Mag to 0.4 Ec Ph with Organic Ph - to 5.8 - 6.5 MadeInGermany

Ok, so day 46, i see a lot of “hairs” turning dark/brown/yellow, so i gave it fresh water no nutes. But it is only the top buds, so maybe i will feed 1-2 times more before flushing. Thats for lsd-25. blueberries, on the other hand needs more time. Day 47: very beautiful colours, and the sweetest smell ❤️

Hello my friends 🌲👨‍🌾, This week was good, the last week✂️✂️! I've just given 1 time water Sunday, only 2.5l clear water PH@6. I've removed lot of dead leaves dpend the week, she had a well senesence, almost all leaves was yellow, Taste should be nice, fruity flower smeel, and so frosted ❄️❄️❄️. I'll publish the full harvest in few minutes. Thanks to all for supporting spend this grow 👨‍🌾👩‍🌾👊❤️❤️, Thanks to Mars Hydro for the TS1000 and Royal Queen Seeds for seeds ❤️❤️ https://www.mars-hydro.com/ts-1000-led-grow-light https://www.royalqueenseeds.com/autoflowering-cannabis-seeds/537-mimosa-automatic.html

2024-05-09 Directly after the Photoshoot, i topped them. they had a super progress and you can watch them growing big steps every day. All will started Indoors under SANlight Flex 25, and move Outdoors. Only one Plant stays indoors, to see the performance under best Conditions because my Outdoor Garden is hard^^ So i started with letting them soak, and then the seeds will move under a humid Kitchensponge unil i see a sweet Taproot. then they will go into the Final Pot, filled with lovely TerraPreta mj mix the grow will be supported with Biotabs fertiliser Breeder Information Fatso GMO F1 Auto is a feminised hybrid strain that is the result of crossing two autoflowering strains, viz. Fatso Auto and Cotton Candy Auto. This Cali-derived, slightly sativa-leaning, easy to cultivate strain will please growers with its big yield, solid THC content and its sweet, candy and fuel palate. Fatso GMO F1 Auto will grow well both indoors and outdoors. It has an above-average resistance to mould but will still benefit from good ventilation, especially where humidity levels are quite high. Resistance to plant pests and other pathogens is excellent. While plants will remain quite short at around 100cm or less indoors, they can grow a little taller, reaching a height of 130cm, outdoors in open ground. The entire cycle is completed in a maximum of 75 days from germination through to harvest and although yields are said to be average this is still pretty impressive for an autoflowering strain. The combination of high resin production and high terpene levels make Fatso GMO F1 Auto a very good strain from which to make cannabis extracts. The terpene profile is sweet and funky with savoury scents of Skunk with pine and floral notes. The taste is like sweet candy with hints of fuel. THC production is high, reaching 24% while CBD is low. The effect is uplifting and well-balanced.

Well we are at the end of week 2 and this gorilla cookies is doing well. I topped her on day 10 and it didn't slow her down at all. I attempted to start a little training on day 13 and that didn't go as planned. One of the mains snapped clean off as soon as I put pressure on it. Oops! She wasn't ready... Oh well, we are still early enough in the game that she should be able to overcome my brutality 👹. Other than that she is growing well and looking pretty happy. I'm hoping to get them moved into a better room in the next week or so when I can free up some space. Still giving them 24 hour light and 24 hour irrigation.

Hi guys its week six and the girls are doing great. The two on the left stopped stretching and beginning to fatten up. The two on the right seems to have another week or so to finish stretching.

Last week was very challenging, two girls got really tall below the white light, while the other two below the blurple spectrum ended up being smaller and bushier, both looking fantastic. Last week I also probably went too far defoliating the shaded smaller girl which stunned it a bit for a day or two but its flowering vigorously again. Although the unexpected stretch which led to uneven light coverage overally the platns are looking solid, smelly and sugary :)

this coming wednesday the banana purple punch in the same tent will be going for an extended darkness period so from that point on these two will have the tent to themselves so will have a lot more room

Another week down. I'd say 3 more to go for a majority of the plants here. One of the zkittles phenotypes is about ready and her immune system is starting to fail so I harvested her. She was an early flower most likely due to root bound stresses. Not a fan of this pheno for structure and mold/stress resistance. The others are looking awesome. Barely any mold

Mar 26 - 794ppm / 5.97ph +defoliation/pruning (lolipopping) +added homemade Co2 Mar 28 - 763ppm / 6.16ph Mar 30 - 853ppm / 5.98ph +added 150ml Massive to rez Apr 1 - 929ppm / 6.00ph