Likes
5
Share
This lady has grown up for real what an awesome strain guys, the leaves are exactly the same lookimg on each pheno of runtz muffin, I got 3 plants, and this pheno #2 as you guys can see it's a beauty! I CANNOT WAIT TO TRANSPLANT HER! follow me on this beautiful journey guys! 💛❤️💚
Likes
19
Share
What a fun run this was ! These Ogreberrys finished up from 81 days to 102 days with nice hints of gassy , sour purple , sweetness and glistening with frost! These ladies will cure up for a month an will be ready to test out ! So much fun , I highly recommend this strain if your looking for some oooy gooohy resiny grape smelling nugs !
Likes
34
Share
@rhodes68
Follow
11/15 Week 13 And things are finishing fast... almost FF10 nuets taken to near max as she is building well and want that to continue. FF9 on water only beginning to get her ready FF11 Fading well it has a few days Again we can expect about 200 grams a plant... or so we hope 😋 Some camera problems ordering another 11/16 FFt-10 Building buds like mad and soaking up the nuets, increased bloom to 12ml/gal ea Pk remains as is see no reason to increase plant wants more Nitrogen and CA FFt-9/11 Continue to finish on PHed water no rush girls just fade away slowly 😏 11/17 Very surprising amount of bud building on the FFt-10 at this late stage. It was the last strain to go into the tent prob a week behind the FFt-9 but still not close 11/19 Bud pics FF10 moving closer still keeping feed as is for now Colors on the FF9 nice surprise good purps and pinks without loofy buds cause those suckers are hard FF11/9 looking good the 9 will go longer than the 11 but there is no rush on either. Nice what you can do when nothing is pressuring you to harvest. 11/20 Will be harvesting a plant every three days now, first will be the FF11-1 (was first in the flower tent) then FF11-2, then FF9, finally FF10 should be ready by then 10 days or so depending on weather. Was going to give them longer but weather is dictating a lot right now and that first FF11 is just ready, all trics white with a few amber Dropped FFt-10 Feed to 10ml/gal ea Bloom A/B 10mk/gal PK will continue to drop it every few days 11/21 Harvest day for FFT-11-1 975 grams wet into dry 11/23 FFT-10s showing no signs of slowing leaving nuets as is Next up is the FF11-2 harvest tomorrow.
Likes
2
Share
So I still don't know I'm about 80% sure it's a male but it hasn't flowered or produced seed so I'm stuck. 🤞🏾 it a 🤰🏽 we will see
Likes
14
Share
D43/V39 - 13/05/23 - Changed water , added nutes until EC=0.9 D44/V40 - 14/05/23 - Defolation - Added water EC= 1.1 pH 6.5 D45/F01 - 15/05/23 - Start flowering. Monitoring water from maximum to above, for the week out D46/F02 - 16/05/23 - Continuing LST. Flowering stage is now clear D47/F03 - 17/05/23 - EC= 0.9, Added nutes until EC 1.1. pH 6.4 (added some drops of pH-) D48/F04 - 18/05/23 - Added water and nutes EC=1.1, pH 6.5 D49/F05 - 19/05/23 - Nothing to report
Likes
5
Share
Soaked the seeds in water with hydrogen peroxide 10 drops per 200 ml. GHS gave root first both varieties, CG waited 3 days and decided to add a second seed, after 24 hours both gave root :) Solucion - local Argentinian manufacturer. Coconut substrate - Plagron. Water : 110 ppm + 0.5 (HV+HM+HM)=350 ppm. Wanted to twist the sprout with a Lemon Orange spiral because it stretched out, but broke it in half :( 26.06 - 2 Marshmallow and Milky Dreams. P.S. the biggest one is Milky Dreams. Puse las semillas en remojo en agua con peróxido de hidrógeno 10 gotas por 200 ml. GHS dio raíz primero ambas variedades, CG esperó 3 días y decidió añadir una segunda semilla, después de 24 horas ambos dieron raíz :). Solucion - productor local argentino. Sustrato de coco - Plagron. Agua : 110 ppm + 0,5 (HV+HM+HM)=350 ppm. Quise retorcer el brote con una espiral de Naranja Limón porque se estiraba, pero lo rompí por la mitad :( 2 Marshmallow y Milky Dreams. PD: el más grande es Milky Dreams. Замачивал семена в воде с перекисью водорода 10 капель на 200 мл. GHS дал корень первым оба сорта, CG ждал 3 дня и решил добавить вторую семечку, через сутки оба дали корень :) Solucion - местный Аргентинский производитель. Кокосовый субстрат - Plagron. Вода : 110 ppm + 0.5 ( HV+HM+HM)=350 ppm Хотел скрутить росток спиралью Лемон Оранж, потому что он вытянулся, но сломал его пополам :( 2 Marshmallow и Milky Dreams P.S. самый большой это Milky Dreams
Likes
46
Share
Hello growers and tokers! 👋 👩‍🌾 🧑‍🌾.🔥💨 Well! Their time has come, this was their last photo shoot after week 10 of life cycle and right before harvest. We've come to an end of this balcony experiment. Had loads of fun watching these two ladies grow in my balcony. They only received 5 hours of direct sunlight each day. (09h - 14h) So to be honest I wasn't expecting this size and density with such little hours of direct sunlight. This strain is easy to grow and doesn't need much attention. Chopped them on day 73 of life cycle (day 52 of bloom) Both have a nice dense cola, one is thicker while the other smells much more potent. Decent amount of trichomes given the circumstances and blazing heat these past weeks. All in all they look gorgeous, smell great and I'm satisfied with the results. Now to dry and get cured. Then comes the taste testing. I'll update this diary with final weight, photos and all that good stuff as soon as they're done. Stay tuned, stay safe and happy growing! 😃
Likes
10
Share
Likes
9
Share
Likes
11
Share
Entramos en la 9 semana y seguimos con heladas en el exterior , las mínimas con luces apagadas son de 15º y las máximas con luces encendidas
Likes
8
Share
@Theia
Follow
The tropicana cherry is a magnificent plant. Its stocky and stout with really great node space. I love how solid she is and i just see such a good foundation for stretch. A really explosive week of growth. I pushed PPFD up to 310umols. Dimmers are at 60% which is drawing 224w plus 18w of DRRB. I have alos started Emerson effect ... Another The Emerson effect is triggered by the simultaneous exposure of plants to light in the deep red and far-red spectra Deep Red 660 nm /Far-Red 700 nm . A bit of boring science that explains why you need both far red and deep red in order to trigger Emerson. The effect occurs because photosynthesis is driven by two distinct pigment systems working in series:Photosystem II (PSII): Absorbs energy most efficiently at shorter wavelengths (higher frequencies), like 680 nm (441 THz). Photosystem I (PSI): Absorbs energy most efficiently at longer wavelengths (lower frequencies), specifically 700 nm (428 THz). When you provide only the higher frequency (deep red), PSI becomes a bottleneck. When you provide only the lower frequency (far-red), PSII is not sufficiently excited to provide electrons. Providing both frequencies simultaneously allows both systems to work at peak efficiency, resulting in a rate of photosynthesis that is greater than the sum of the two lights used individually. To understand the Emerson Effect, think of photosynthesis not as a single engine, but as a two-stage assembly line. What is the Emerson Effect? Discovered by Robert Emerson in 1957, this phenomenon shows that plants perform photosynthesis much more efficiently when they are hit by two specific types of light at the same time: Deep Red (660 nm) and Far-Red (700+ nm). If you give a plant only Far-Red light, photosynthesis is very slow. If you give it only Deep Red, it's better but still limited. However, when you give it both at once, the total rate of photosynthesis is significantly higher than if you just added the two results together (1+1=3). What is Happening? (The "Assembly Line") Inside the plant's chloroplasts, there are two "workstations" called Photosystem II (PSII) and Photosystem I (PSI). They work in series, meaning the first one must pass "parts" to the second one. PSII (The First Station): This station is tuned to catch Deep Red light (660 nm). It harvests electrons from water. PSI (The Second Station): This station is tuned to catch Far-Red light (700 nm). It takes the electrons from the first station and uses them to create energy (ATP and NADPH). The Problem: If you only provide Deep Red light, the first station works fast, but the second station can't keep up because it isn't being "powered" efficiently by that specific frequency. This creates a traffic jam of electrons. The Solution: By adding Far-Red light, you power up the second station. It now "pulls" the electrons from the first station much faster, clearing the traffic jam and making the whole assembly line run at full speed. The Benefits for The Grow Because i am using the Biotabs water-only method, my plants already have a steady supply of organic nutrients. Implementing the Emerson Effect offers several distinct advantages: Increased Biomass: Because the "engine" is running faster, the plant produces more sugars and carbohydrates, leading to heavier fruits or flowers. Faster Finishing: Plants often reach maturity sooner because they have more surplus energy to complete their life cycle. Better Light Penetration: Far-Red light is very good at passing through the upper leaves. This "wakes up" the lower parts of the plant that would otherwise be shaded, allowing the whole plant to contribute to growth. Enhanced Secondary Metabolites: In many crops, this synergistic light can stimulate the production of terpenes and antioxidants, improving the "quality" (smell, taste, and potency) of the final harvest. The "Sunrise/Sunset" Trick I am using 4x Invisible sun Far red/Deep red bars,they use high-quality Samsung LH351H (660nm Deep Red) and specific Far-Red (730nm) diodes for 10–15 minutes at the start or end of the light cycle. This mimics the natural shift in light at sunrise and sunset, "waking up" the photosystems or signaling the plant to go into "sleep mode" faster, which can further optimize the flowering cycle. Enviromentally i am chasing a VPD of about 1,1kpa. My room seem to sit nicely at lights on at 24c with no real drama and a little help from a 220W greenhouse bar radiator. Its using abot 4kw/h a day atm because my room is attached to the side of my house and its been -5c.. I have had to add some humidity as its also very dry atm. Im aiming for RH of 65% with my 24c but it is more around the 62s.. VPD is crucial and is the focus for this grow for me. The autopots and Biotabs make it so easy ican really just focus on perfect enviroment. A VPD of 1.0–1.2 kPa provides enough "atmospheric pull" to move calcium and magnesium up from the roots, which is critical for the rapid cell division happening now.. Plants will be flipped on Saturday which is their week 5 as im a bit behind.. As this happens i will push PPFD upto 4-500umols. by week 2 of flower. Thats the plan anyway..
Likes
11
Share
F1 youngest of them all, will try to just leave it be without lst or topping or anything... Maybe.
Likes
15
Share
So I just transplanted them into one gallon pots before they go into the growace aircube. The one that the helmet took off some of the leaf is starting to actually wanna live and still growing she’s a little runt as you see in the pictures but I have faith in her. I think they will sit in these pots for a week then into the ebb and flow system. Can’t wait to see what that system has to offer once I know I will have a 10% off link for anyone who’s interested in buying one. Until next week happy growing. So glad I got a garden back man it was driving me insane not having any plants!
Likes
10
Share
@Miketama
Follow
Day 86 ​❄️ Northern Lights Auto – Harvest Update (Fresh Frozen & Dry)This specific plant was grown all by itself in its own pot (unlike the other pot where I had 2 plants sharing the space) ​Total Wet Weight: 190g ​Dry Flower: 91g of unexpectedly dense buds have been set aside for a traditional dry and cure for smoking. ​Fresh Frozen: 65g of prime material went straight into the freezer for a future bubble hash extraction run. ​Waste: The remaining weight was trim and non-resinous fan leaves. ​Final Thoughts: Totally surprised by the incredible bud density on this run! I am extremely satisfied with the results of this cycle, especially considering the dialed-in light hours and my setup focused on recycling the soil and organic nutrients. Can't wait to see how the dried flowers smoke and how the fresh frozen performs in the wash.
Likes
4
Share
@KhaVigga
Follow
now im start to using many kind of sugar till harvest, beer-fpj-molasses-coconut water...