I kill your pain - 1:1 CBD GrowerStuffer

😰Now it's time for a series of long-awaited final posts. And for a tragic reason, it comes sooner than it should. Painkiller, according to early tests, is ready to eliminate both pain and stress on its way, but, alas, it was unable to cope with the mold on the cones. At the moment of taking a photo, my eyes caught on a light fluff sticking out behind the trichomes, which seemed extremely strange to me. Approaching, and after a careful examination, I found pockets of mold infection on several stakes and the bush was immediately put under the knife. ✊The Killer spent the last 10 days on ripen, which was planned for another 4 days, and then FlashKleen from T.A. As a result, the wedge did not take place, however, during the ripening, the cones still gained density and were abundantly covered with sugar. Most of the trichomes are cloudy, some remain transparent and some amber, I think the ratio is about 60 / 20 / 10. 👉 Options: Air temperature: 20.3° Solution temperature: 18° Humidity: 45% Plant height from substrate to top: 70cm Distance to lamp: ~8-10cm 👉 Solution: Water 190ppm, ~8.5l Ripen ~4.5ml per liter. Total 6.4 pH, 890ppm