Update 18/04/2022 (Day 64)
It took them a little longer than expected but I think it's safe to say they are in flower now.
you see some light burn on the tips of the leaves. light is at maximum height right now +-55 above the canopy.
The new FC4800 is at 70%. think that is enough first day it was on 100% and that's were the light burn tips are from.
as you can see 1 plant is shorter than the others. but since i'm using the autopot system it's not possible to raise the pot.
Update 23/04/2022 ( Day 69)
Girls looking good :D
Well I managed to raise the smaller plant.. so it's at the same height as the others now. the difference really affected the the grow so I had to do something about it.
I've also put the trellis net up, the stretch of these girls is insane and they will need some kind of support once the buds are starting to get fat and heavy😎
@Ganja4Show, Yes sir 😁 I know, not a lot of them on GD. FastBuds Auto Mix and Critical condition after Orange Punch are my autopots diary 😁
Autopots are the best 💪 💪 💪
Plants are looking nice though the leaves are starting to look like they are ribbed a little I would keep an eye on the cal mag you may need to add a little more each time I use to just add 1 teaspoon per gallon every time I changed my buckets I grow in dwc system it wasn't enough so I started adding 1 teaspoon of cal mag each time I add water about once every 3 to 4 days just keep an eye on your leaves if you see the leaves turning purple or lighter green between the veins of the leaves
@Weedman46,
Funny enough I started to measure the EC value of my water before adding calmag and I ended up doubling the amount of calmag to reach 0.4 EC value.
the timing that you mentioned this i was alraidy looking to calibrate my meter and i actually had to go buy some EC buffer/solution since I ran out haha
@Weedman46,
Thanks for the Tip, I am indeed looking closely what to do with my Cal mag.. I've also bought Canna Calmag Agent to add instead of the Biobizz one.
these ladies are thirsty as hell.
Nice👍..
For your humidity flutuations look at an INKBIRD R.H and Temp controller,
you can find them on amazon, I highly recommend, gives you complete control
of the enviornment in your tent. I have a heat inkbird to keep my heat mat at the right temp
and I have a couple just for humidity control in both my tents.
Later!!
