Making full spectrum THC-oil

I used 11.63 gr of cuttings, sugar leaves and popcorn buds from harvesting fat banana, Sunset sherbet and Royal dwarf👌 Filled the Cannolator glass tube with the dried and crushed weed. There is a hole at the bottom of the glass tube which lets the alcohol through but not the weed. Pressed the weed down gently while filling the glass tube. (every 2 scoops, press down!) For this i used the opposite end of the included scraper tool. (part of the cannolator set) Filled the bottle warmer halfway with water and turned it on the highest setting. Inserted the heat-resistant beaker and placed it under the glass tube that is inside the metal construction. Hang the tube of the aquarium pump at the top of the beaker. This will speed up the evaporation process.👌 Poured 6 times the weight of the cannabis in alcohol in the glass tube, over the Cannabis. I had to use 69 but i used 60 ml.. (was a mistake..😁 but nobody is counting) It is better to use this method so you do not use too much alcohol It is not only very expensive but also very useless to use too much.. the beaker gets a little bit 'cooked' if you use too much too.. //////////////////////////////////////////// Pure cannabisoil will drop down and the alcohol will now begin to evaporate. There is 4% water in a bottle of drinkable alcohol. This will only evaporate at the last, after the alcohol. Be careful and make sure that your area is well ventilated! (Open the window). Alcohol boils and vaporizes at 78°C. As long as there is alcohol in the jar, the temperature of the mix will not go over 80°C. (.. thats the temp to decarboxylate the weed..or else u wont get high..) When all the water has evaporated, small bubbles form. When no more new bubbles form and the oil remains smooth, it is ready.🙌 If you follow this recipe, your oil will be ready after 2 hours! (i always check 15 minutes before.. sometimes it is quicker and must make sure there is enough water left..) But dont forget the next, last step: