flatcap Germination in a CannaKan was super fast. After only 16 hours the seed cracked and after sticking it in a peat pellet afterwards the little guy/gal already sprouted like crazy.
Decided to just stick it in the Autopot right away at very low light setting and see what happens.
3 likes
comments
Share
Used method
Other
Germination Method
3
Week 3. Vegetation
9h ago
18 cm
Height
18 hrs
Light Schedule
30 °C
Day Air Temp
6.0
pH
Weak
Smell
65 %
Air Humidity
26 °C
Solution Temp
26 °C
Substrate Temp
24 °C
Night Air Temp
15 liters
Pot Size
Nutrients 2
Bio-Down
0.2 mll
Calmag
0.3 mll
flatcap Potted directly into the 15 litre autopot setup. I use a 47 l tank with reverse osmosis water that is regulated down to PH 6.0
As the Sonnenerde Bio Hanferde is already covering the nutrients I did not add any nutrients so far, apart from preventive CalMag in a low dose.
In the past I had some issue at the end of the grow. Probably due to nutrient lockout. So this grow I will keep a close eye on the PH levels and any discolorations.
I had some issues with fungus gnats, so I started early with some nematodes, will keep an eye on it to see if I need to add more in the future.
In the middle of week 3 I decided to top after the 5th node. Once the two branches developed fully I will try some LST to form a nice base for the canvas. I run only one plant this time, so I should have a lot of room for using a SCROG later on.