Chat
RecommendedRecommended

AutoPot - Think Different & Auto Amnesia

5
40
19
4461
4 years ago
Follow
5
Grow Conditions
Week 2
Vegetation
2.54
cm
inch
Height
24 hrs
Light Schedule
12+ conditions after
Login
Nutrients
ml/l
ml/gal
tsp/gal
Commented by
jokgga jokgga
4 years ago
Week 2 was a little stunted. Think I underwatered or over watered. Added another Think Different and Seedsman Amnesia Haze to the mix.
Similar Diaries
Apple 🍎 Glitter ✨
3 weeks
Apple 🍎 Glitter ✨braxat420
Apple Glitter
9 minutes ago
Indoor 4th Quarter
3 weeks
Indoor 4th QuarterTHC_NY
+1 strain
25 minutes ago
Some Cookies!
4 weeks
Some Cookies! Lebowski
Gorilla Cookies Auto
3 years ago · 7 comments
Episode 4: A New Dope
18 weeks
Episode 4: A New Dope2Byte
Green Gelato
3 years ago · 27 comments
Sour Diesel auto
9 weeks
Sour Diesel autoBnV405
Sour Diesel Haze Auto
3 years ago · 10 comments
OG Kush auto
6 weeks
OG Kush auto BnV405
OG Kush Auto
3 years ago · 15 comments
Orange sherbert dwc
6 weeks
Orange sherbert dwcExtraordinary_dankness
Orange Sherbet Auto
3 years ago · 19 comments
Grow Questions
jokgga
jokggastarted grow question 4 years ago
I am noticing that all three plants have leaves that are curling down and specifically my Think Different 1 (right) is a dark green with some weird leaves. Not sure if this is pythium, nitrogen toxicity, or light heat? Anyone have any idea what this may be and what I can do?
Solved
Leaves. Curl down
like
FreshCoastOrganics
FreshCoastOrganicsanswered grow question 4 years ago
This symptom is almost always caused by an excess of Nitrogen! Too much nitrogen causes dark green, clawing leaves and sometimes but not always burnt tips. I’d back off the nutrients and just use plain water until you see her recover a bit!
jokgga
jokggastarted grow question 4 years ago
Seeing some leaves dying at the bottom. I have been lightly defoliating; however, being careful as I do not want stunt during flowering? Should I not defoliate at this point?
Solved
Leaves. Color - Yellow
Techniques. Defoliation
like
Burmese
Burmeseanswered grow question 4 years ago
Hi there, You should only defoliate if there is a good reason.Like do some defoliation to lower down tent humidity,to make a good air flow if too bushy.Defoliate some leaves If they are damaged or shaded below the canopy.May be some lollipopping if there are too many pop corn buds underneath.Other than those, I wouldn’t do.Happy growing... ✌️
jokgga
jokggastarted grow question 4 years ago
I am seeing a ton of mycelium on all of my autopots. Because I have a bottom feed system, it is hard to keep my top medium wet without getting mold. Is this going to effect my end result if I do not do anything about this? Should I leave it alone or put sand on it? Thanks all
Solved
Other. Mold
Other. General questions
Setup. Ventilation
like
FreshCoastOrganics
FreshCoastOrganicsanswered grow question 4 years ago
I don't think I've ever seen that much Mycelium without mulch or purposely trying to do that! I would just leave it alone and maybe put some barley mulch on top of it. Damaging it could cause more of a problem than a solution!
jokgga
jokggastarted grow question 4 years ago
My leaves are yellow but some are turning green. Do they need more nutrients or lockout? I have not gone above 1EC but have seen both strains handling 1.5EC+ in other diaries. All three plants are drinking the water in trays. Res/Tray@ 6.0PH/653PPM. Coco slurry @6PH/500PPM
Solved
Leaves. Tips - Burnt
Leaves. Color - Yellow
Other. Mold
like
Shagrath
Shagrathanswered grow question 4 years ago
Hi! I think everyone missed the thing that you are growing in coco and perlite mix and not in soil. Coco is soilless media and it needs to be treated like hydro pH wise. So you need to follow the rules of hydro grow with the pH, but nothing else has to change. So the optimum pH is 5.5-6 for good nutrient uptake. You might have and pH lockout going on if you have followed soil guidelines and also I personally think that 1 Ec is actually quite low 'cos I've found that in my hydro the sweet spot seems to be ~2ec. OFC every grow setup is their own and mine does not necessarily work for you, but you could lower the pH and if that does not help, give slightly more nutes. Also coco "sucks" calcium and magnesium so you need to add those a bit more when growing in coco.
jokgga
jokggastarted grow question 4 years ago
I am seeing so many of my leaves curling / dying.... I know these leaves will all get yellow towards the end of flowering but should my plants look like this at Week 9?
Solved
Leaves. Curl up
Leaves. Dropping off
Leaves. Color - Yellow
like
HighAltitudeOrganics
HighAltitudeOrganicsanswered grow question 4 years ago
No, they should not look like that. You are either under feeding, have a nutrient lockout, or other pH related issue. You’re plants are showing some deficiencies for sure. What are your environmental conditions? If VPD is way out of line it can explain this too. So there are a number of possible causes and I don’t have nearly enough info from you to provide anything further. Good luck
jokgga
jokggastarted grow question 4 years ago
I am running 4 gal autopots on 50 Coco/Perlite with Jacks 321@80% strength (800PPM), up from 650PPM previous week. Have been seeing curling and leaves dying although the bottom area is green. Res/Tray@ 6PH/800PPM. Coco slurry @6PH/800PPM. Temp 81, RH 55% Should I flush?
Solved
Leaves. Curl up
Leaves. Color - Yellow
Leaves. Color - Mottling
like
HighAltitudeOrganics
HighAltitudeOrganicsanswered grow question 4 years ago
Try dropping you pH to the low end of the recommended range (5.7) Looks like you’ve got an N lockout or some type of salt build up even though you said it’s not a bottom up yellowing issue. I would flush. Good luck
jokgga
jokggastarted grow question 4 years ago
Should I harvest now or wait a week? Think Different Sativa is 11 wks to harvest and I am at wk 13. Still seeing new buds/pistils and straight white pistils. Around 40-50% brown hairs and cloudy trichomes but no amber. Using Coco/Perlite in 4 gallon autopot. 76F/47%RH. No flush.
Solved
Other. Harvest - Drying
Other. Harvest - Curing
like
Troy_Farms
Troy_Farmsanswered grow question 4 years ago
Flowering times and harvest time depends when the plant starts to flower. You want to give each plant a good 8 weeks flowering typically. She looks close, Will get a little more chunky but overall just gonna ripen up for a great harvest in a week or so. You should be flushing already and getting ready to harvest, but depending how heavy of a high you want you can let it go more or less. Right now Looks mostly cloudy, so you can harvest in like a week for slightly more uplifting high, or let it ripen up more and let her go for like 2 more weeks for a stronger heavier high. Analogy; Like Bananas will go from green to all yellow, (Yellow representing cloudy trichomes), then they will start to get black spots and eventually turn solid black. So people like more black dots then others. (like Amber trichomes) Ideal banana would be one with some spots but mostly yellow, right now your 'bananas' are nice pretty yellow, but would be best to let them ripen up a touch more. If that makes sense at all.
Comments
Login

Show by Week
Sort by
popularity
popularity
newest
oldest
Ferenc
Ferencweek 7
Happy Flowering:) @jokgga
jokgga
jokgga
@Ferenc, Thank you friend!
Ferenc
Ferencweek 8
Happy Growing @jokgga
amon_grows
amon_growsweek 1
I would let it dry out a bit so that although the rockwool cube is moist, it shouldn't be heavy with water and dripping wet. Keep a humidity dome on it to maintain 80-100% humidity the first week or two. I keep a heating mat under my seedlings to make sure the base of the rockwool cubes are sleightly warm but not cooked. If your temp is 80 degrees I would try to keep it a bit lower and probably not use a heat mat if you are struggling to keep the temp below 80.
jokgga
jokgga
@@amon_grows, thanks for the advice!
DreamOn
DreamOnweek 9
Nice job, looks great! Good luck with the rest of the flowering and have fun! 🌱😎
Blacksheep
Blacksheepweek 9
I’ve grown Think Different 6 times. I’m currently growing 4 of them. I believe it is nut burn for sure
jokgga
jokgga
@Blacksheep, Do they handle EC over 1.0 very well? Any suggestions on how to fix this? I am bottom feeding through an autopot with coco/perlite. Flushing at this point seems to be a bad idea. thanks
Ferenc
Ferencweek 13
Enjoy ;) @jokgga
Inganjawetrust
Inganjawetrustweek 11
Good looking grow best of luck with the finish 🌱✌️
MasterKushOG
MasterKushOGweek 9
Looks amazing 😍 Keep going in same way 💪🏽🔥💣
DreamIT
DreamITweek 9
Enjoy growth 🤟😎🍀
Stoner_INDICA
Stoner_INDICAweek 9
It looks beautiful👌😍
SuggaShane
SuggaShaneweek 8
I wouldn’t say nute burn. I would say up your nutes back to at least 80%. I feel like it’s a deficiency.
SwedenX
SwedenXweek 7
Looking great! Nice work! Keep it up
iHateSativa
iHateSativaweek 13
Happy Smoking Friend
Blacksheep
Blacksheepweek 13
Wow. What a great 1st grow. I love Dutch Passion for sure. I am currently growing several of them. I have grown think different 6 or 7 times now. Love growing it! Dutch passion has solid genetics. I’ve used them for years. Continued success!
Inganjawetrust
Inganjawetrustweek 12
It's going to be a nice harvest 👍 that new growth and white hairs looks to me to just be some foxtailing and of no concern. Happy Holidays Peace ✌️
heizen
heizenweek 11
Nice grow mate, plants are looking good, keep it up, imma follow this one upclose.