Bubblelicious AUTO Stealth LED

I reused most of the stuff from my previous setup, but now with a bigger tent and with 2 girls in it. 😎 # Ventilation ######### I have a 100mm, 150 m3/h (practical capacity), 165 m3/h (technical capacity) carbon filter, paired with a 100mm, 2 speed motor, 150 m3/h, 180 m3/h, in-line circular duct fan. The fan is set to the slower, 150 m3/h speed, so it doesn't sucks more air than the filter can support and so no smell bypasses. Air inlet is bigger, 125mm, so the extractor fan is not overwhelmed. Air and light filtration is done with the usage of a black pantyhose, perfect for the job, but must be cleaned regularly. Air circulation assured by silent, big airflow, PC case fans. # Medium ####### My medium is coco + clay pebbles. 4-5 cm layer of clay pebbles at the bottom of the pot, beside the Autopot filters. Added enough clay pebbles to ~12l of coco so that it could fully fill both 8.5l pots. I used coco bricks and this time I also added CalMag to the water when flushed, as it's recommended that way. I didn't add nutrients, only just a little around the girls after planting them. # Nutrients ######## Hesi Coco Starterbox. Going to start with half strength, cuz AUTO, except the Root Complex, PowerZyme and CalMag. Because of my tap water's alkalinity, I adjusted the PH to the lower end, as I had PH problems and iron deficiency in my previous grow. # Irrigation ######## I'm using the "Autopot - 2 pot system kit" from my very first grow from 6 years ago (no diary about that). I'm hand watering at the beginning though, as recommended by Autopot, until the girls establish. 😁 # Lighting ####### Started out with CFLs, because autumn is here already and the additional heat helps, while also hard to burn them this way. 😉 ʕ•ᴥ•ʔ