Autopot tray ph lower than rez ph?
Bdawgstarted grow question 3y ago
My rez ph is 5.8
But when i chekecked bottom of trays was 6.8. What causes this?.
Is temperature in room?
Growin in coco- pebbles 60-40
Pre washed pebbels and says ph neutral on bag.
Open
Feeding. Automatic systems
likes
Answer
Bdawganswered grow question 3y ago
Ph hardly goes up in the rez.
Its in the autopot tray itself
likes
Complain
Flyalivebeatsanswered grow question 3y ago
How many gallons is your reservoir? Are you using a submergible pump in your reservoir to keep the water moving? I had the same issue and ph would always go up until I got a submergible pump for my reservoir.
likes
Complain
Similar Grow Questions
Solved
CortezKush
Coco wateringHow often/how much is ideal water for coco coir? Example: 15L pot, 70/30 coco perlite. Aggressive veg. Should it be a daily matter? How many times if so? Is it bad to water coco in large quantities?Feeding. Automatic systems
Feeding. Schedule
Feeding. Other
5y ago
2
5
Solved
Growkong
Should I use fertilizers for an Autoflowering?Would you recommend to use fertilizers, although Royal Queen Seeds write on there website that Royal Gorilla Automatics don't really need those/ only a very few amount? And if so, which one would you recommend, that I would also find in a hardware store?Week 2
Feeding. Automatic systems
6y ago
3
1
Solved
Smeags
Watering, what don't I know?Any advice on good watering techniques and organizational tips and tricks for watering. For current and or future grows. I'm aware my pot size selection was way to large for this auto grow. Should I invest in a self watering rig for the future? Less hassle?Week 1
Feeding. Automatic systems
6y ago
4
4
Solved
GrowYourFive
The problem in plants when I supplying CO2Hello! After adding CO2, I noticed problems on the leaves of my plants. Grow in coco+perlite, water with 1100ppm solution, 1000ppm co2 in air. Drain from the right 1400ppm and 1800 from the right. Is it related to co2 and irrigation system?
3y ago
2
2
Solved
longearringboy420
Keeping nutrients longerI have a simple system with a pump that adds water to my coco pots once every couple of days but the nutrient solution starts separating (making a foam) after a couple of days.
Do you have solutions for this problem or nutrient suggestions? I am currently using canna coco a/b.Feeding. Automatic systems
3y ago
3
3
Solved
The_Stoned_Samurai
EC too high and leaf yellowEC 1.45 and some yellow leaf… I adjusted the soup by adding water to it and the new leaves seem to be pretty ok. Otherwise, all other parameters are good. It’s odd bc I followed instructions of the brand (Platinium Hydroponics) and the EC lvl is still kinda high. Suggestions?
Leaves. Color - Yellow
Feeding. Automatic systems
3y ago
1
1
Solved
FCFLOWER
Very low yield. Worth spend nutrients still?Low yield. Should I keep adding nutrients or will be waste of time and money? 6 weeks autos like this. Will I collect much more if keep with nutrients or should I save money and just water it? Not confident at this point.
Other. General questions
Feeding. Automatic systems
6y ago
1
Solved
Selkot
Nematodes attack...Hi!
(1st autopot session) Had a small infestation of nematodes; think i was able to contain with neem oil;
Would you know of any particular product against worms, and perhaps a product or trick (preferably non-mechanical) to prevent grease films on the surface of the water? THX!
Feeding. Automatic systems
4y ago
3
Solved
Bud_Wiser
Film/bacteria buildup in Autopot system with Canna nutrients?Hello. It's my first time growing in Autopot system and first time using Canna nutrient line
I am using 2ml/l a+b, 1ml cannazhym and 1ml calmag in tap water
After mixing everyhing in the bucket after an hour a layer of film appears
Is that normal or there is problem with tap H2O?Feeding. Automatic systems
2y ago
2
Solved
Maskedcucumber
How much should I irrigate the plants at this stage with my drip hydro system ? (clay pebbles, day 17 now) I think it goes bit dry in less than 48 hours. Some sites say they should be irrigated 15 mn on 15mn off 24/7
My EC is a bit low (0.4 right now) so maybe I can irrigate mor
5y ago
2
2
Solved
EGSilver
Ph drop in water reservoir (drip system)Using a drip system with water reservoir.
Last 2 weeks I have been having trouble keeping the Ph in range.
The routine is fill the bucket, add nutrients, ph down to around 6.5 if needed. But it drops to 5.5 over a few hours even when adding Ph+ it will drop to 5.5 after an hour.Feeding. Automatic systems
6y ago
1
5
Solved
cornozito
Heavy overwatering by Autopot system during vacationAfter 7 days of vacation and my first try of the Autopot system I noticed heaviest overwatering by the autopot. Took them immediately off the system. 3 of 4 plants felt and layed with weak stem on the ground/soil. When you watch the photos: go on (any tips?) or start from scratch
3y ago
3
3
Solved
xHSxMonki
Adding nutrient to autopot aquavalve reservoirI use autopots which bottom feed my plants. I am starting to feed them flower Fuel NPK 1-34-32. Its recommended to be top fed 1.5gs per 3ltrs of water. So my question is, can I add 1.5g to the small reservoir which is located where my aquavalve is instead of top feeding them?
Week 5
Feeding. Automatic systems
6y ago
2
Solved
Y0ink
humidifierMy humidifier just broke 😓
Any suggestion for a new one?
Growing on 120x120 and i was using the one that i posted
Have a good day 😉
Feeding. Automatic systems
5y ago
2
3
Solved
cornozito
Turning Autopot System on and off ?Ab welchem Tag nach dem Keimen würdet ihr das Autopot System anschalten und nicht mehr von oben gießen?. Anleitung war 7-10 Tage, aber das war bei mir nicht ausreichend.Würdet ihr das Autopot System in den ersten Wochen an und ausschalten oder immer an lassen?Week 3
Feeding. Automatic systems
3y ago
1
1
Solved
zoma_indoor
Bottom water absorption system cultivationI cultivate a bottom water absorption system in a 25L pot, but I am troubled with EC management every time. Since it is raised with 165w LED light, it is fun to determine the limit that does not burn.
Please tell us when to raise your EC.
Week 1
Feeding. Automatic systems
6y ago
3
3