Durch das eher schlechte Wetter in letzter Zeit hat sich die Pflanze sehr gestreckt aber dennoch hat sie ein super Wachstum

Did a full leaf strip on everything this week, the pics and videos were taken 2 days ago I just havnt got around to uploading them. Everything bounced right back after the strip but the pots arent drying out as fast and humidity went down a little bit. Use the code bangdang for 10% the following sponsors.. @greenbuzzliquids @rainscience_growbags  @gorilla_grow_tent  @growlightscience.led

Day 50 since Germaniation. Genetics are really nice and strong. Even against high amounts of nutritions. Rqs never disappoints but this genetics i like the most so far. Cant wait to see the result

Leaves are green, no nutrients deficiency, she does what she’s good at, shape is clean, she’s doing so good that i’ll let her listen to some Four Seasons from Vivaldi this afternoon.

Sie wächst immer noch in den unteren Seitentrieben weiter, obwohl sie schon gut blüht. Leider hat der Grauschimmel sie nicht verschont und ich musste ein kleines Stück eines Buds entfernen. Der Ventilator im Folientunnel weht auch sie nun direkt an um die Luftfeuchtigkeit in den Blüten zu senken und die Wasserversorgung wurde heruntergefahren. Hoffentlich schafft sie es bis zur Ernte in ca. 3-4 Wochen. Auto Cinderella Jacks benötigen etwas länger, dafür wachsen sie auch stärker. Sie ist die größte meiner diesjährigen Autoflower Pflanzen. Leider habe ich auch an ihr etwas Bud rot gefunden und sofort entfernt. Ich vesuche den Autoflowers den bestmöglichen Platz unter dem Ventilator zu geben. Der durch Schneckengewicht abgeknickte Zweig hängt zwar, aber er wächst bereits sich biegend nach oben. Bis nächste Woche! --- It is still growing in the lower side shoots, even though it is already flowering well. Unfortunately, gray mold has not spared it, and I had to remove a small piece of a bud. The fan in the foil tunnel is now blowing directly on it to reduce the humidity in the flowers, and the water supply has been reduced. Hopefully, it will make it to harvest in about 3-4 weeks. Auto Cinderella Jacks take a little longer, but they also grow stronger. It is the largest of my autoflower plants this year. Unfortunately, I also found some bud rot on it and removed it immediately. I try to give the autoflowers the best possible place under the fan. The branch, which was bent by the weight of snails, is hanging, but it is already growing upwards. See you next week!

The bubble og plants are very much middle of the ground there not the greatest so far but they are still doing great. All 3 plants are still looking almost the same. One of them has recovered more it has praying leaves all day. The other 2 plants when the lights come on there leaves sag to the dirt but when afternoon comes around there praying really well. I hate plants like this. It's so hard to tell what they want. On the other hand these 3 plants already have a very strong dank smell going on This past week all the plants did great dealing with getting repotted and topped in the same week. I definitely took a Rick doing that seeing i only left each plant with 4 leaves. This past week was also a struggle to keep the vpd in a decent range. The Temps outside have been below 32 for a few days with Temps dipping down to almost 0 at night. With the space heater running it's pulling the humidity down. I think I have figured out the solution to that problem so I won't run into that next time it gets cold again. All the plants have really started to grow their new branches sense being topped. A few of the plants are a little smaller than I'd like but I'm gonna keep em alive for now.

Посмотрите на этих красавиц

explosive groth this week under the sanlight LED. looking good so far.

Also a fastbuds purple lemonade in a 11 litre pot (30grams)a a original cheese in a 2 litre pot(experimenting)which is not ready yet. Strawberry pie.....wow so impressed with the yield but also the looks are amazing and smells like strawberries... who’d of thought it lol. Recommend to everybody will defo grow again. Fastbuds are killing the auto game!👊🏻

16.02 First day of the fourth week of flower. Defoliated a little bit again. This time around I’m picking smaller amounts of leaves every day in comparison to one major defoliation on one day. Also I ve added pk booster at 100 ppm.( 0.2 ec) will gradually raise it over the next weeks. Lowering the base nutrients. I think they finally stopped the stretch and they are barely fitting in the tent. I ve added some swirski ulti mite . Predatory mites as prophylactic measure for thrips. I’ve noticed some tiny damage on a couple of leaves. And a couple of larvae.

really this girl could of gone longer ideally. due to my other plant finishing so quickly and using the tent for drying she had to come down at the same time. she went 65 days and was showing ambers. this was my first organic grow and first time using soil. I defiantly learned a lot and cant wait to get on to my next grow. highly recommend barneys farm for seeds.

3/14: Came back from a 4 day vacation to a lot of dry, wilted, dead leaves on Amnesia. Trainwreck is super starved as well. My automatic watering system didn't kick on, and the humidifier ran out of water within 24 hours, so there's that. It may be for the better though, as the PH of the nutrients had risen to 7.5. I tossed that mix, and made another 2 gallons of half strength nutes, molasses and epsom salt. I watered them both to runoff, and now I'll wait for Amnesia to prioritize which leaves she thinks are worth saving, and then I'll defoliate the dead ones. Hopefully trainwreck will just bounce back to green. She needed to be defoliated anyway, so this situation makes it easier for me to find the dead leaves. Edit: Came back to feed the last of the nutes and decided to pluck the crispy goners. I found that pulling the leaf stem downward will make the most dead leaves fall right off, allowing me to test a majority of the leaves and give Amnesia a major haircut. Luckily I left a lot of leaves from prior defoliation, as Amnesia REALLY sucked them dry. 3/15: Amnesia looks no worse for wear than last night. Trainwreck as well. Went ahead and pulled as many dead leaves off Trainwreck as I could. Some leaves were a mix of crispy brown and healthy green, which I think is pretty goofy, so I avoided taking any green fans but removed the crispy ones. The colors of the leaves around the buds are really fun to look at. 3/16: Amnesia is starting to SHED her dead leaves, allowing me to pick the leaves with almost no effort. I tested as many leaves as I could, giving another haircut. I would say this isn't a good thing, but since it's my first grow, I'm rolling with it. As long as Amnesia keeps the buds and its nearest leaves alive, it will slowly grow, albeit stunted. I'm not sure if this condition will cause it to finish sooner, but I'm going to need to watch the trichomes under a microscope every couple of days just in case she's ready for harvest. Trainwreck looks about the same as it did before. No new leaves are ready to be removed there yet. 3/19: Amnesia is still shedding leaves, but also bulking up. Trainwreck is slowly bulking up, and turning purple as well! Going to keep an eye on Amnesia's trichomes. Edit: because amnesia is yellowing so much, and because it's been 5 days, I'm going to feed both plants a quarter strength nutrient mix just in case I've been overfeeding them somehow.

Excited to see the pistols keep coming and coming I have such tight spacing that the buds will probably start connecting by the end of the week on the Royal Gorilla Day 19- Tomorrow I will tie some branches down to open up the plants more. The LSD plants needs it the most!

Buds are starting to put on a little weight now and from now on that’s all these plants will focus on scrofula seems to be perfect

Gorilla Runtz Seedsman Day 54 Day 6 since 12/12

9 Dec - 15 Dec. Was her last week. She her at her glory before getting choped and dried.

FOR EVERYTHING MARS HYDRO VISIT: www.mars-hydro.com www.marshydroled.ca PROMO CODE: rocknroll VISIT THE ALIEXPRESS STORE: @marshydro_aliexpress Instagram: @marshydropenny REMO NUTRIENTS 👍 Thanks for taking the time to read and check out my diary🤜🤛 TS3000 FEATURES: WIDEBAND SUNLIGHT FULL SPECTRUM LED GROW, Infinite close to natural sun light, suit for all plants whole stages indoor growing, rapid plant response from seed to flower, achieve maximum quality and quantity, much better than traditional HPS grow systems. HIGH REFLECTIVE & NOISE FREE-Fanless LIGHT BOARDS design will make your growing life easy and quiet, quickly heat dispersing material aluminum reducing light lost to aisles and walls, increase the light intensity up to 20%, allowing your plants receive more energy and without burning your plants for maximum headroom. HIGH EFFICIENCY ENERGY SAVING PLANT LIGHT, high-power NEW LED grow, Compares to traditional 3000 watt HPS lamp and other brand led grow light while only 450 watts true output with 1016 LEDs, more scientifically and energy-efficient! Perfect for 5' x 5' veg stage, 4' x 4' bloom stage, higher intensity in a MARS HYDRO grow tent, reflective area, or by crossing over using multiple TS3000. BOOM YIELD LARGE GROW LIGHT, NEWEST SMD LED technology provide highest PAR/LUMEN output(1095.6umol/), makes you get 30% higher yield compare OLD led lights, can get max yield at 2.5g/watt, less pay but get more yield, bring a amazing grow trip to any home grower as it beams huge amounts of light energy to plants below. COMMERCIAL LED GROW LIGHT, Updated easy dimming & daisy chain function, main light controlled, especially come with two waterproof and dimmable Mean Well Drivers, auto sensing power supply works on both 120VAC and 240VAC and 277VAC, suit for Large Rooms and Commercial Setups. Low Energy-Consuming LED Grow Light: Consuming 300w and also mounted with 1016 chips, TS3000 has the ability to replace a 450w HPS light while reducing 40% power intake. High Efficiency LED Grow Light: With overall light output PPF 343umol/S as well as amazing PPE 2.3 umol/j, it's 50% even more photon efficient and can assure a 30% more return than the old HPS/MH lights. Patent Highly-Reflective Hood Shape: The reflector design on TS3000 is patented, which can effectively gather the light dispersed in all directions to enhance its light intensity as well as assist plants in absorbing more light. Full Spectrum Plants Favorite Spectra: By the unique mix of spectra that makes most light in the 400-700nm waveband, incredibly conducive to plant photosynthesis. Adequate IR(730-740nm) is additionally consisted of in the range to generate larger buds. Dimming And Daisy Chain Feature Available: Upon an independent dimming button on the external driver, backing 0-100% settings adaptation and up to 30 LEDs daisy-chained in a group, it supplies different light levels for various plant stages meanwhile saving energy. Safety Certifications And Service Warranty: CE, ETL, RoHS, UKCA security certifications accepted, 50,000 hours durability, 5-year service warranty, and local after-sales repair 5x5 GROW TENT: LOCK ALL LIGHT INSIDE MARS HYDRO Indoor Grow Tent interior is made of diamond mylar which is highly reflective. (Other brand's mylar and reflective rate is as low as 50%, won't provide efficient light. )MARS HYDRO 1680D canvas, being double stitched, it is tear proof and has perfect light locking. Mars Hydro's grow tent keeps 100% lighting beams inside and helps your plant absorb more lights. EXTRA-THICK --No light leaks or rips at all DURABILITY GROW TENT Stable metal corner adapters and poles are the trustful supporters of the tent, standing sturdy, neither rusting nor paint-falling, quick easy tool-free installation. Mars Hydro's heavy-duty metal zippers, with double layer black lining, are the best on the market which create a light-proof seal EASY OBSERVATION FOR YOUR PLANTS. Special observation windows are made by double layers of cloth. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The observation window also serves to dissipate heat and ventilate air AUTOMATIC 6 INCH EXHAUST FAN KIT W/ CONTROLLER: Mars Hydro 6'' Inline Fan uses a mixed-flow design to maintain peak performance in a high static pressure environment. GROW TENT FAN: MARS HYDRO inline fans are designed to ventilate hydroponic grow rooms, transfer heating/cooling, cool AV closets, and exhaust odors. EFFECTIVE VENTILATION: Variable speed controller for easy fan speed adjustment. Optimal ventilation for your planting. LOW NOISE LEVEL: Durable plastic fan housing and blades for extremely low noise(32dB-A); create a truly quiet growth environment. EASY INSTALLATION: Removable duct ends with locking tabs for quick removal and easy maintenance and a cord length of 4.9 feet for hassle-free setup. This grows tent fan with a controller for easy fan speed adjustment. BASIC PARAMETERS: Ventilation exhaust fan size: 6” | Dimensions: 315mm*225mm*210mm. | Weight: 2.7. | Airflow: 402CFM | Noise: 32dB-A | Bearings: Dual Ball.