Recommended
Likes
Comments
Share
Very easy first grow very happy with results best weed I ever smoked and I can only get better from here so I'm excited to keep seeing more and more progress
Likes
42
Share
@Gabarram
Follow
155 days from seed and still harvesting the last big colas, and flushing for the parts still receiving light during 12 hours and processing more residual materials intracellularly, while hopefully ripening a little bit more. Like I told before, there are three or four colas like that in the video that were not completely exposed to light and they might not as ripe as they should be. I'll check that while smoking later after these colas are properly dried and cured.
Processing
Likes
12
Share
@GrowGuy97
Follow
Day 7 - Everything seems to be going ok they are all growing about the same pace! Day 8 - They are all growing pretty equal right now , extremely happy with how things are going!✌️🏼🌱 Day 11 - one plant has some twisted leaves hopefully it’s nothing serious😫 will be keeping a eye on her, other than that they all seem to be growing great! Thanks for following & happy growing friends!✌️🏼🌱 Day 13 - have a few with some weird leaves & growing a little slow, other 3 are growing pretty good! Hopefully they all do alright, fingers crossed! Happy growing friends!
Likes
2
Share
Day 62-30/01/23 #1 harvested!!! Day 64-01/02/23 #2 harvested!!! Day 68-05/02/23 #3 harvested
Likes
15
Share
@Waveform
Follow
Waiting for first signs of life … While we are, I thought I’d give you a short explanation on the software’s graphics in case you did not follow my first diary. The one to the upper left, as its headline says, is the temperature graph. Most important line is the red one, showing the leaf temperature measured with an infrared temperature sensor. As there are no leaves yet, it is pointed towards one of the pot’s wall at soil level. Air temperature from a sensor that usually hangs around somewhere around top level is violet, and the grey line is the outside temperature close to the tent, helping the software to determine if a main blower action will effectively lower temperature. As I learned from the first grow a plant day that corresponds to the natural day can cause enormous gaps both to temperature and humidity, I inverted the plant day now, starting their night at 11 a.m. So after the first day temperature will only vary around 1.5 °C, which is of course due to the low light intensity too. Humidity graph on the upper right is quite crowded. Main line is the blue one, tent air humidity, which on this first day was between excellent 65 – 70% most of the time. For the moment humidifier is electrically disabled. There is quite some excess humidity on the tent floor and no reason to push this any further. Outside air humidity is grey again and taken from the same outside sensor that reports outside temperature. The soil humidity sensors are simple analogue capacitive sensors which have their flaws. I am interpolating their measurements to have a somewhat smoother reading, but as you can see from the turquoise humidifier reservoir reading (in legend named as plant soil hum 1), they can get confused when humidity is very high and start to report random numbers for some time. The most important graph for all growing stages is the lower left one, where the pink line meaning plant VPD should be inside the green optimum range for somewhat perfect conditions. This cannot be attained all of the time – dehumidifying isn’t as easy as humidifying –, but software tries its best to do so. Outside VPD is grey again. The last graph is more for amusement than anything else. The light intensity sensor is hard to position correctly, and everything you see about illumination and DLI (orange and green, plus grey for the accumulated 24 h DLI) should be taken with some spoonful of salt. Any resemblance to real world professional instrument readings can be considered purely coincidental. The violet line is the CO2 reading from such a sensor, and you can see that its tiny peaks correspond to even tinier black peaks at the bottom of the graph, reading TVOC values which in this case, once they will be more than possible measurement irregularities, can be interpreted as smell. ------- End of week 1: All seeds germinated. I wasn’t at home most of the time, and it turned out using the humidity sensor to monitor the humidifier’s tank wasn’t good for the stability of the system. Arduino crashed, so there are no pictures yet and no graphs to show. I have the feeling light was a bit low as the seedlings grew a bit tall, but with lights now up to 20% I guess this problem is fixed. More tomorrow when I have some more data to share. Even more end of week 1 (I extended this week to 9 days as I cannot tell when the seedlings started to show): Lights are at 40%, meaning 40 W in total. No reason to give them new water until next week. As some flies showed up from the BioBizz soil, I added 2 yellow cards. So far, everything in normal ranges. I’ll switch the control to grow phase soon which will raise the VPD slightly by 0.5 kPa. It’s interesting to see the CO2 level started to climb by 50% during their last night and has not come down to baseline afterwards. I restarted the app to check if the sensor had lost its calibration, but it still sits at around 660 ppm now.
Likes
5
Share
Well it finally happened, the girls have outgrown the 4x4! Was mid week and was having a hard time keeping humidity below 65%. Thought of defoliating, but can't keep doing that weekly or it will shock them sooner than later. So I decided to move the front left plant to the 3x3 under the Photontek SQ300W, giving the girls in the 4x4 some much needed breathing room. Set about retraining the plants to maximise space in the big tent, and then flattened out the lonely girl in the 3x3. Crazy enough the 4x4 still looks full by end of week, and the one by itself is getting close to filling the 3x3! This could be a pretty big grow by the time we finish 🤞. Have the solo plant running on the older Autopot valves with 6mm hose, and already had one clogging issue. Seems really early on, in past would take 2-3 weeks so thinking maybe I didn't have the lines 100% clean to start. Either way easy fix just blow out the clog and flush the lines with a liter or so and back in business. Always remember to flush the on/off valve as well as the main valve in the tray. Otherwise raised the lights in 4x4 to their max height (5" from roof) and took all the slack out of the cables to keep them off the lights. Adjusted the ties on last day of the week, but things seem pretty set now in the big tent so will just be widening out the lone girl once she grows a bit more. I'm sure by end of week that tent will be packed as well!
Processing
Likes
10
Share
Day 15 - Sun. 7/29/18 N/A Day 16 - Mon. 7/30/18 9:45PM 1. Photo Update Day 17 - Tues. 7/31/18 2:00AM 1. Soil pretty dry, cup pretty light. Watered with 5.8 pH RO/DI water Day 18 - Wed. 8/1/18 1. Time Lapse video Day 19 - Thurs. 8/2/18 2:00AM N/A Day 20 - Fri. 8/3/18 3:00AM 1. Soil pretty dry, cup pretty light. Watered with Fox Farm Big Bloom 5.8 pH RO/DI water Day 21 - Sat. 8/4/18 N/A
Likes
70
Share
I just noticed today I’m having some top leaves yellowing between the veins. My ph is on point so I don’t think it’s a deficiency. I haven’t changed anything except the Carboload. So I think I’m going to dump my tank and flush. I really cannot imagine its the Carboload either. So I’m a bit perplexed. I decided after digging into The scrog and finding some lower yellow leaves it was a nitrogen deficiency. Upped the A&B
Likes
36
Share
happy out again this week at the shape of things. Sweet Sweeds dominant tent was down overall because of a F up on light regime. pins out of place lol. ok so all fixed. taking their topping and training like champs. merry christmas everyone. a lot of foliar spray to help the recovery. silicate a bit, algae mix.
Likes
8
Share
Yo les amis. Les fleurs commencent a gonfler et l odeur se développe
Likes
8
Share
70 gramms trimmed buds. I think we would have achieved 1 gram per watt if the third plant hadn't been hermaphroditic/ a male.
Likes
11
Share
@DogterB
Follow
Week 10 (1/12-18) Day 65 (1/12) She's getting closer and closer. When I scope her, she's mostly cloudy, with just a few ambers scattered in. I'll check her again later in the week. Her pot was still fairly heavy this morning, so she's set for the day. Day 66 (1/13) She was ready for a drink today. I watered her with some molasses and Mammoth P added in, pH'd to ~6.5. When she's ready again, I'll feed her one last time then it will be water only (maybe some molasses) until I chop her. Day 68 (1/15) Well I put the little clip on microscope on my phone and checked her trichomes. To my surprise, there seems to be a good amount of amber now. I think I'm going to call it. I'll cut her lights today and give her 48 hours in the dark, so will chop her down on Sunday (day 70). I'll give her a big drink of cold water and put some ice around her stem when I shut her down. I dry in paper bags and my last plant dried pretty quickly, as I didn't give her any water for awhile before chopping. I'd rather have a longer drying period, so I will water her up before she goes into the dark. Her last feeding was day 62 (1/9), so I'm hoping it has been long enough to work the nutes out by the time she's done.
Likes
12
Share
Was a pretty smooth week for most the girls. Showing some steady growth. I topped all of the plants around day 12 other than the slurricane 7. Ph got a little high since the nutrient level was too low to buffer it at the beginning of the week. Slurricane 7 and sugar cane are the ones that took some damage. I think they will be ok though. I upped the nutrients to 1/4 tsp per gallon and the ph has held stable since then. Should be able to start some training the middle of next week and looks like we might be going 2 more weeks on veg before flipping them to flower depending on how this upcoming week goes. Guess you will have to show up next week to find out...
Likes
5
Share
@Woodz
Follow
Well had to harvest early. bud rot was making its way through the plant had already pulled 2 heads off covered didn't want any more being affected. So it's now chopped and drying will give more of an update after she's dryed n cured... Its been a good grow right up untill the end ventilation was lacking and temps hot. I've enjoyed it tho this plants tested some of my skills on diffieciencys and training really like the strain just abit more attention to environment nearing the buds getting very dense.
Likes
20
Share
Processing
Likes
11
Share
@Yukagrls
Follow
She looks very healthy and beautiful. It was raining two days ago, so I decided to pour her some of that rain. As I said above, all I use is water and I give her light 24/7.
Likes
23
Share
@Chubbs
Follow
420 Fastbuds Week 3 Gorilla Zkittlez Auto All in all this week has been good. Look past the plants being a little droppy the lights just turned on when taking the pics. Plus I did a defoliation taking most fan leafs off them allowing the lower branches to receive more light. Started seeing a couple rust spots so I'll add a little cal-mag maybe with the next feeding. Happy Growing
Likes
5
Share
@Nemessis
Follow
Calmag enter this week, the fruit are more big. Next week im gonna enter the PK from Aptus. One of my plants has a magnesium deficiency I think, I hope that with the calmag it will be fine. The smells are already magnificent, the Glookie looks like a packet of candy! The fruits will start to grow nicely by the weekend with the high PK intake
Likes
6
Share
@Comfrey
Follow
I missed to take some fotos ore a video. So I chooses to show where the soil is made: in Comfreys garden. Unfortunately I‘m not allowed to grow there my weed. It‘s a community garden with privat owned ground but with a lot of neighbors. The German law allows to grow cannabis in your own garden for private use but not in a private garden situated in a community garden club (Kleingartenverein). But anyway I’m lucky because we have a very sunny balcony, too. Next week more fotos…