#1 is the one that had most growth in the the lower branches the week before she is still doing well being that she is in the same condition #2 I moved her to a different location running extra light and with the lst....she took off now she's the one with the most growth Till nxt time #happy growing

9/8 D65 Seems our "good" weather is ending and if the forecast is correct for the next three days, only three of the last ten were sunny. That aint good folks not sure what can be done about it outside of artificial light and that would go on the ATF if any were available. Ah well learning is fun She looks good just needs some blasted sun Zombie is thriving, go figure Full feed yesterday 9/10 Sunless days continue, maybe two hours sun today then the rain moved in and the temp dropped... global warming my arse The forecasts were correct now I can only hope that continues as it is forecast for much better the next 2 days and then right back to this mess. 9/11 Yep today was a big improvement glad to have it 9/13 Day 70 New vids, top dressing seems to have triggered a new run of bud building on both Gloria and zombie Quasimodo (cant kill some of these Mex Air plants). The moster crop growth pattern is interesting as hell just letting it grow. Gloria looks to be building a basketball bud on top :) Weather degrading harvest in a couple weeks max trics say same

Plants still stretching. I cleaned the bottoms from small branches and leaves, to give more energy to main buds.

Week 12 and we're still not there yet! However, the ladies are growing thicker every week. #2 & #3 are growing so thick, they can barely support the weight of their own buds. Really have to be careful when handling them, the risk of snapping a branch by accident is way too high right now. The reason for that is probably due to the crowded space in the growbox, in which there isn't much airflow despite having the little fan running nonstop when the light is on. Looking at the trichomes they can all take a few more weeks, just have to be patient now! This is plant #1/3. Still thickening slower than the other ones, but she's pretty fine otherwise!

Hope

This grow cycle was one of my best from start to finish I had 5 females 4 of which were brilliant all shown colour all fruity gassy and amazing only the one was bland and green in colour and smelt different really good nug atructure but the smell wasn't there for me ... this is around my fifth grow and I'll be running these strains again to get it down to one pheno of these genetics

Started to dial down the nutrients, can already see a slight colour change in the leaves as they start to turn autumn colours with the reduced nitrogen Did a flush/refresh of the roots using florakleen 0.5ml/Litre and left it in the reservoir for 2 days before dumping and adding fresh nutrients. The roots look bright white afterwards where they were nutrient stained a reddish brown before. I swapped the side light from the left side to the right side to promote some more bud development on that side lower down Happy with how the plants are looking but I had hoped that the buds would be a little fatter by this stage. Clear winner so far is the bruce banner which has by far the biggest and most dense buds, then the gorilla glue next, then the blue dream although her buds are tall and skinny, then the gsc comes next with the critical last, most of the buds on the critical are still very small (it's the shortest plant and furthest away from the light)

Week 2 was simple. Transplanted the rooted clones in to 500ml plastic cups (Clear - helps to see how the roots are developing) Used unattended coco perlite 70/30 mix and Inoculated with GHF BioEnhancer as well as foliar feeding. Just tried to be gentle and turned the wattage down on my ballast to 250W. Getting the ladies cozy and comfortable in their new environment.

Day 84..today I cut..

Rückblickend war zwei mal düngen mit 100% ein wenig zu viel. Die Blattspitzen waren hier und da etwas mitgenommen. Es wird wohl in Zukunft auf zwei mal die Woche mit 75% hinauslaufen und mal gucken ob die Ladys das besser verkraften. Das erste PH-Messgerät was den Wert nicht korrekt angezeigt hat war letztendlich nicht die große Hilfe. Das passiert in Zukunft auch nicht mehr. Aus den kleinen Fehlern konnte man doch recht viel mitnehmen :) Trotzdem haben die Ladys alles gut überstanden und haben einfach riesig viel Spaß gemacht.

This week went very well! One will be getting cut an hung to dry while the rest finish up with one more week of flush ! These ladies are smelling so lovely I hope you all enjoy! Stay tuned for next week! Cheers 😤💨💨💨💨💨

My girls are doing fabulous in their new tent. I'm so excited about this grow, man... 6/20: So I topped GDP2... she's just entering her 4th week. She's growing so much faster than GDP1 and BK at this point. I was having watering issues during this point with them 2. I'm thinking I am just going to top 2 more times and not LST. Honestly I just don't feel like adding another LST lololol 😅😆😆 6/23: So I learned that I accidentally fimmed Lil GDP2 when attempting to top. Had my question answered pretty quickly and he was very helpful. So instead of creating 2 new colas, looks like I created 3... #winning 😊😊 It's only been 3 days since I topped GDP2 and her 3 additional colas are already growing in really well.

02/03/25 Short facts: - 58cm high - Light is @80% but in a distance of 24 to 35cm - 600 to 740 ppfd - VPD increased to 1.0 but I only do get it up to 0.9 - Defoliated again --------------------------------------------------------------------------------- She has grown significantly again, becoming taller and producing more leaves. I had to defoliate her once more, but she has already regrown some leaves, so I'll probably have to defoliate her again this week. I'm really impressed, she's doing so well!

The cannabis strain Grape Guava can be a purple strain, depending on its specific phenotype and genetic makeup. While not all phenotypes of Grape Guava are purple, some variations, such as the Zatix Grape Guava, are noted for their striking purple appearance due to the genetic expression of anthocyanin pigments. https://www.youtube.com/watch?v=cKdVmdoKJ5k In a garden of green, Grape Guava gleams, With its fruity aroma, enchanting dreams. Clusters of grapes, guava's sweetness ignite, A strain so divine, in purple and white. Euphoria whispers, a lush fruity haze, Grape Guava's embrace, a tranquil daze. Off and away.@1400ppm. The increased CO2 allows plants to thrive at higher temperatures, which in turn necessitates higher humidity to maintain the ideal VPD for healthy growth and transpiration. 80F -5F = 75F LST with 70% RH = 0.72 kPa. Higher temperatures and humidity promote rapid growth, nutrient uptake, and photosynthesis while maintaining a lower stress level. Temperature influences the rate of enzymatic reactions involved in aerobic respiration. Enzymes, such as those involved in glycolysis, the Krebs cycle, and the electron transport chain, work most efficiently at an optimal temperature range. In low temperatures, enzymatic activity will slow down, thus reducing the rate of aerobic respiration. In high temperatures, enzymes can become denatured, thus impairing their function and stopping the process of aerobic respiration. Glucose is the primary fuel for aerobic respiration. The rate of aerobic respiration increases with the availability of glucose, as it is the starting point for glycolysis. If glucose levels are low, cells may rely on alternative energy sources such as fatty acids or amino acids , but these processes may yield less ATP or be less efficient. To determine this effect, carbon dioxide volume was measured (as carbon dioxide is an output of aerobic respiration) 18/6 with the 6 being IR. The near infrared (IR-a) borders around 700nm up to 1400nm @ photon par flux density of 1.8 instead of darkness, keeping temps overnight a neat 77F-80F. Think of my tent as a lung. What goes in must come out. When the rate of air going out exceeds the amount of air coming in, it creates a negative pressure. Tent concaves (bends in). If set up correctly, your RH will begin to drop slowly to the desired level you set, and the extraction turns off when it reaches desired% RH. The plant, as it performs cellular respiration, will always be releasing more water into the air, so the RH% of the tent overnight will always increase, so long as oxidative phosphorylation is occurring. As soon as the RH% creeps back up to 55%, the extraction turns back on, over and over. This creates a strong pressure differential which will work wonders on your grow. Replicating high and low-pressure fronts in nature. Critical for oxygen diffusion at the critical time of peak cellular respiratory function.. Moisture will not transfer from a saturated atmosphere to another if that air is already at or above its saturation point, meaning the air can't hold any more water vapor. Once I understood that water is produced as a by product during cellular respiration, specifically at the very end of the electron transport chain (ETC) where electrons are finally transferred to molecular oxygen, the higher the RH of the air, the more resistance there is for more moisture to be added to that environment, and effects the ease with which it does so. But none of that water comes from the pot; it's pulled from the air. If you run high daytime RH, your medium/pot is 100% reliant on transpirational root pull to move water. ZERO evaporation happens across the atmosphere if the tent air has high RH%, the medium cannot release its water through evaporation. Once a canopy develops, light no longer slowly wicks and evaporates from the topsoil. The Soil-Plant-Atmosphere Continuum (SPAC) describes the continuous pathway and process of water movement, driven by a gradient in water potential, from the soil, through the plant's roots, stem, and leaves, and finally evaporating into the atmosphere through transpiration. There is evaporation, there is transpiration, and then there is evapotranspiration; Evapotranspiration (ET) is the combined total of two processes: evaporation (water lost directly from soil and surface water into the atmosphere) and transpiration (water released from plants to the atmosphere through their leaves). Evapotranspiration represents the total amount of water that moves from the medium into the air. There is no such thing as a medium with too much water, only a medium that retains too much for too long. The water must always flow efficiently from one atmosphere(Medium) to another(Air) in a timely manner. Moisture is a critical factor for bacterial growth and decay. Dictating how long it's allowed to sit in any one location for any given period is a key preferred control. To ensure a net reduction in a bacterial population, the rate of removal (ET) must exceed the rate of bacterial growth (decay rate), which is often modeled as a growth rate for the specific bacterium under the given conditions. By optimizing daytime VPD, we also optimize conditions for bacterial growth to explode exponentially above 77°F.. If water is allowed to sit in a medium without an escape within a timeframe, nothing good will happen. IF High RH is maintained overnight as well as during the day, placing 100% of water movement at the behest of daytime transpiration, roots can only pull where they can reach, and if soil is compressed above a certain point, moisture will become trapped in a medium with no way of moving day or night. This will begin the countdown for decay to take hold. When water stagnates in a medium, it loses oxygen, creating anaerobic conditions that foster the growth of harmful microorganisms like bacteria and fungi, which can produce toxins and disease vectors. Thigmomorphogenesis, the process by which plants respond to mechanical stimuli like touch by altering their growth and development, results in significant morphological changes to improve survival against mechanical perturbations. This complex response involves sensing touch and initiating physiological and genetic responses, leading to changes in form and structure over days or weeks. The process is triggered by physical forces such as wind, rain, or touch. Plants adapt to these stimuli by changing their shape and structure, which may include slower growth, thickened stems, or altered leaf development. Plants possess sophisticated mechanisms to detect even subtle mechanical stimuli and initiate responses. A variety of molecules, including calcium ions, jasmonates, ethylene, and nitric oxide, are involved in signaling these mechanical inputs. Touch can induce the expression of genes that encode proteins for calcium sensing, cell wall modification, and defense mechanisms. A plant exposed to constant wind may become shorter and sturdier. A plant that is touched frequently might grow more slowly to conserve energy and develop thicker cell walls. These changes increase a plant's resilience and ability to survive in harsh environments. Let's get Thiggy with it.

had big bud over the weekend, The soil was very dry when I came in on Monday so give it 2 litres hopefully last the next day or 2. Still very tempted to defoliate but unsure if it is the right time or what to remove. Decided to try and defoliate it a bit. see if it has any impact. still a bit worried about things like this what wiht it being my first plant