The Grow Awards 2025 🏆
Recommended
Likes
Comments
Share
@Ciocanna
Follow
I've adjusted the PPM to 420💜. I've excluded all the stimulants and left only Hesi Bloom. I also add Hesi Zyme to each watering, but only half the recommended amount, which is 1 ml/l.
Likes
18
Share
week intel: we reached the peak of flowering stage and need to cause a little more e.c stress from this week so e.c stress is twice a week i reduced the amount of Nitrogen and calcium and stopped feeding silicate in other hand i raised the amount of base nutrient and booster short story version: more K & P - less N stresses : a little E.C stress around 1.6 and 1.7 twice a week from this week feeding: i feed them 3 times this week with this order : day 1 : i feed them high with base nutrients(calcium & micros (half dose) + Bloom) about 822 ppm - 1.6 e.c to cause a little stress. day 3 : i feed them low dose of Top-Max + B-52 around 525 ppm - 1 e.c to let them recover a little but not fully recover still a little stress will caused. day 5 : i feed them high dose of Feeding Booster around 850 ppm - 1.7 e.c to cause e.c stress again guide of the week : from this week we can cause more E.C stresses. e.c stress if done correctly is one of the very few ways to increase quality in all aspects ( color , aroma , taste , bud structure , resin contents ) but if you over do it , listen carefully brother : it can reduce quality in every aspect so always look for signs and never reach the red line.
Likes
4
Share
Harvest time and these smell wonderful hints of gas and sherb terps
Likes
18
Share
week intel: we reached the peak of flowering stage and need to cause a little more e.c stress from this week so e.c stress is twice a week i reduced the amount of Nitrogen and calcium and stopped feeding silicate in other hand i raised the amount of base nutrient and booster short story version: more K & P - less N stresses : a little E.C stress around 1.6 and 1.7 twice a week from this week feeding: i feed them 3 times this week with this order : day 1 : i feed them high with base nutrients(calcium & micros (half dose) + Bloom) about 822 ppm - 1.6 e.c to cause a little stress. day 3 : i feed them low dose of Top-Max + B-52 around 525 ppm - 1 e.c to let them recover a little but not fully recover still a little stress will caused. day 5 : i feed them high dose of Feeding Booster around 850 ppm - 1.7 e.c to cause e.c stress again guide of the week : from this week we can cause more E.C stresses. e.c stress if done correctly is one of the very few ways to increase quality in all aspects ( color , aroma , taste , bud structure , resin contents ) but if you over do it , listen carefully brother : it can reduce quality in every aspect so always look for signs and never reach the red line.
Likes
18
Share
week intel: we reached the peak of flowering stage and need to cause a little more e.c stress from this week so e.c stress is twice a week i reduced the amount of Nitrogen and calcium and stopped feeding silicate in other hand i raised the amount of base nutrient and booster short story version: more K & P - less N stresses : a little E.C stress around 1.6 and 1.7 twice a week from this week feeding: i feed them 3 times this week with this order : day 1 : i feed them high with base nutrients(calcium & micros (half dose) + Bloom) about 822 ppm - 1.6 e.c to cause a little stress. day 3 : i feed them low dose of Top-Max + B-52 around 525 ppm - 1 e.c to let them recover a little but not fully recover still a little stress will caused. day 5 : i feed them high dose of Feeding Booster around 850 ppm - 1.7 e.c to cause e.c stress again guide of the week : from this week we can cause more E.C stresses. e.c stress if done correctly is one of the very few ways to increase quality in all aspects ( color , aroma , taste , bud structure , resin contents ) but if you over do it , listen carefully brother : it can reduce quality in every aspect so always look for signs and never reach the red line.
Likes
8
Share
8th week! The plant has a slight guava scent, very interesting! Nice growth rate and no problems so far.
Likes
18
Share
week intel: we reached the peak of flowering stage and need to cause a little more e.c stress from this week so e.c stress is twice a week i reduced the amount of Nitrogen and calcium and stopped feeding silicate in other hand i raised the amount of base nutrient and booster short story version: more K & P - less N stresses : a little E.C stress around 1.6 and 1.7 twice a week from this week feeding: i feed them 3 times this week with this order : day 1 : i feed them high with base nutrients(calcium & micros (half dose) + Bloom) about 822 ppm - 1.6 e.c to cause a little stress. day 3 : i feed them low dose of Top-Max + B-52 around 525 ppm - 1 e.c to let them recover a little but not fully recover still a little stress will caused. day 5 : i feed them high dose of Feeding Booster around 850 ppm - 1.7 e.c to cause e.c stress again guide of the week : from this week we can cause more E.C stresses. e.c stress if done correctly is one of the very few ways to increase quality in all aspects ( color , aroma , taste , bud structure , resin contents ) but if you over do it , listen carefully brother : it can reduce quality in every aspect so always look for signs and never reach the red line.
Likes
7
Share
@Naujas
Follow
well, she spent a week in the growing pot :) it seems the girl was not stressed :) hi, she looks healthy, a bit more leafy, but that's normal, after all, she came from the balcony :D every day I remove a few leaves, because there are a lot of them, she still has a week left and will be cut off: (I would like to give her a little more time, but I'm going on vacation and I don't have anyone to leave such work :) so I'd better cut it earlier :).
Likes
7
Share
@Naujas
Follow
well, she spent a week in the growing pot :) it seems the girl was not stressed :) hi, she looks healthy, a bit more leafy, but that's normal, after all, she came from the balcony :D every day I remove a few leaves, because there are a lot of them, she still has a week left and will be cut off: (I would like to give her a little more time, but I'm going on vacation and I don't have anyone to leave such work :) so I'd better cut it earlier :).
Likes
6
Share
@Naujas
Follow
when I came today, I didn't recognize her, she was eaten by snails, but she put out new branches, which grew rapidly :) she is already showing signs of rain :) or it is already the beginning of flowering:).
Likes
5
Share
@Naujas
Follow
the girl looks healthy, she's not big, but she doesn't look bad at all :) it's very hot outside this week, 34° :)
Likes
Comments
Share
Likes
11
Share
@Jacks_Pot
Follow
The 3th week into the 12/12 cycle went smooth. I've got the impression that the Pineapples aren't stretching much. The pre-flowering stage has changed into the actual flowering stage. I think it will take about 10 weeks of 12/12 to get these Pineapples ready. I've done some final pruning and removed some leaves above the screen that were blocking light for lower shoots. Smell is coming in so this week I've placed the carbon filter in the tent. It's still the Can – Lite 600pl filter that did a great job in my previous run. This was the feeding shedule of this week. Day 1 → Each 1100 ml (0.29 gallon) tapwater with Plagron nutrients (see above for which and how much) Day 2 → Dry Day 3 → Each 1100 ml (0.29 gallon) ph adjusted tapwater (ec 0.46– ph 6.1) Day 4 → Dry Day 5 → Each 1150 ml (0.30 gallon) tapwater with Plagron nutrients (see above for which and how much) Day 6 → Dry Day 7 → Each 1200 ml (0.31 gallon) ph adjusted tapwater (ec 0.48– ph 6.1) The week started with the cobs still at the same height and power as last week ended. That was 240 watt and 46 cm/18.1 inch → (PPFD 750/DLI 32.4) On day 54 the power was raised to 252 watt at 45 cm → (PPFD 789/DLI 34.1) Temperatures stayed between 20 – 26.5 °C ( 68 – 79.7 °F) and humidity levels between 50 – 65 % Till next week! Do you want to grow this strain? 👉 https://www.barneysfarm.us/pineapple-chunk-weed-strain-15 👈
Likes
4
Share
Harvest time and these smell wonderful hints of gas and sherb terps
Likes
12
Share
@Jens_420
Follow
Lst hat glaube was gebracht, also auf jeden Fall ist alles gut in die Höhe gewachsen, ich hoffe die anderen Blüten an den ehemaligen Seiten Trieben bilden sich auch noch schön, sonst alles prima
Likes
5
Share
i germinated all of this grow directly on the soil . I'm using a one side broken Lumatek ATS200 100% from early veg to flower . and then im just putting water with ph 6.5 until early bloom . I put my homemade scrog in this week 5 early flower
Likes
27
Share
Day 112 Day 69 Flower 18/07/24 Thursday So I have checked I'm seeing more amber's now and hardly any clear!! So now she is going 24hrs in dark and no added water so she will dry out more over last 24hrs. The smell is incredible. Pungent gassy ice cream smell.
Likes
5
Share
i germinated all of this grow directly on the soil . I'm using a one side broken Lumatek ATS200 100% from early veg to flower . and then im just putting water with ph 6.5 until early bloom .
Likes
184
Share
#seedsman420growoff and #SeedsmanSeeds 📆 Week 12, 13-19 July 2024 13-19 July - Observed and let the plant grow. 📑 This has been another good week for the Pineapple OG! She is rapidly eating nutrients and I am having to change solution about every 4-5 days now. In DWC when your original nutrient solution starts off at 12-1300 PPMs and then drops below 400 PPMs within 4-5 days, it becomes hard to understand what nutrients the plants has taken up, as this number may never get below 2-300 PPMs. So when to change solution outside of a schedule depends on a few factors, but most of all - observations, and records of the individual plant. You have to look for the subtle differences. Is it getting a little light green before changes. How does it respond to an early change, etc. The more you observe the plant the more you will learn about it. So far she has been exceptional! There are still a few more weeks to go! 🍶 17 July nutrient solution changed 🍽️ 17 July feeding schedule updated 💧 Using reverse osmosis water with EC/TDS at 0 🐉 Nutrient Solution EC 2.4 at 74 degree F 🔆 Light power at 75%, DLI 45 canopy coverage at 12hrs 😤 Using General Hydroponics, HGC728040, Dual Diaphragm Air Pump, 320 GPH That is it for this week. Thanks for the look, read and stopping by.
Likes
Comments
Share
Likes
Comments
Share