1/14: This morning, I did a foliar application of big bloom and fulvic acid, then about 5 hours later I watered them with about a half-gallon of rainwater each and added armor si, humic acid, endoboost myco/tricho, liquid molasses, and a bunch of cal-mag. Today, I also I wired up and mounted my new samsung sun board strips (660nm/730nm) and my Solacure FlowerPower UVB fixture. I'm running the deep red/far red bud boosters a few hours per day right now, but will run them for the entire photoperiod once I start flowering them. I'll run the UVB for 4 * 15-minute sessions a day for the full flowering cycle, and if they don't protest too much I'll increase each session by 5 minutes and evaluate again. Some strains are more forgiving than others and I've got 5 different strains in this space...so really not sure much time I'll get away with exposing them to the deadly rays without damaging them too much...😈 1/15: I received one of the rapid led/growmau far red initiator pucks today. With the placement of my UVB light, I'm realizing I'll need another far red puck to have even and intense far red coverage, so I'm ordering another with Prime delivery and waiting to start flowering until I receive it. I sprayed them down really well with ph adjusted rainwater tonight to rinse off nutrient build-up from foliar applications. 1/16: I'm really excited to try flowering under 14/10. I grew photos indoors on an off for 15 years before I semi-retired. If I added up all the additional flowering time I could have done through the years if LED technology existed, I'd have had an extra truckload of bud to smoke. I did another application of Axiom Harpin a|b Proteins this evening, right before dark. I'm expecting a big growth burst this week, leading up to the flower stretch. I really need them to trigger under 14/10 within 4 or 5 days🙏 ...if not, I'll switch to 13/11 and wait a few more days🙏😟..if still no pistils are poppin, I'll go to 12/12 and chalk it up as bad luck or varietal indifference to Pr and Pfr manipulation. 1/17: I fed each of them about 3/4 gallon of full strength veg nutes. This will be the last. I'll go with half-strength veg and half-strength bloom for a week, then go with full strength bloom nutrients until I start flushing them in 6-8 weeks. 1/18: I installed the second far-red flowering initiator today and got all my timers configured for flowering: ========================================= timer#1 - power strip with qb's and red boosters   10:00am -12:00am  timer#2 - (dual/independent setting)             sideA- 3-way cube with uva bars                   10am - 3pm                    7pm - 11pm             sideB- flowerpower uvb                    1pm - 1:15pm                    4pm - 4:15pm                    7pm - 7:15pm                    11pm - 11:15pm timer#3 - far red pucks   11:00pm - 12:15am timer#4 - sub-canopy tube   10am  - 1pm    3pm  -  6pm    8pm  - 11pm ======================================== I also did some testing on the timers and sealed myself into the closet to check for any light leaks. All good.👌 1/19: Looks like the FIM job didn't take on one of them..but she's got perfect symmetry. WIll probably have to just top her again next week...gonna be a tall one I think. Tonight is their first long night. It's ON!👍 1/20: I watered them today with about a half gallon each. I'm seeing calcium and magnesium deficiences here and there, so added some boomerang and heavy cal-mag-Fe along with liquid molasses, humic acid, and endoboost myco. I also foliar fed with big bloom and fulvic acid. That's it for week 4-

Todo resultó bien, pero hubo una semilla que a pesar de que germinó de manera exitosa no logró enraizar correctamente. Quedando con 14 semillas de 15 en total seguimos ...

Damn this strain is something else I’ve never smelt anything this potent and exotic! Ripper seeds really out did themselves with this one .. I would say that the only downside is that one of the pheno’s came out looking too regular for me .. I’m strain hunting so finding something truly perfect is my goal and in this run I can’t say I found any keepers but I would definitely recommend trying this strain ! I promise it’s like nothing you have ever tasted or smelled before!

Bonjour à tous, 👑.Le 17 Mai 2021...Jour N°107.👑 🌻.Flowering Day 32.🌻 5ème semaine de floraison pour mes trois Hulkberry Feminisées. Les plantes vont bien, les bud commencent à libérer des odeurs très agréables, les feuilles n'ont pas encore changer de couleur. 💉..Je leurs donne que du Calgreen. 🔦..Lampe Led MarsHydro Tsw 2000 à 100% de puissance et à 20 cm de la canopé. Cette lampe c'est de la balle, regardez mes plantes comme elles sont magnifiques et tout ça en organique..😘 www.marshydro.eu www.mars-hydro.com Voilà c'est tout pour l'instant mes amis, merci à vous d'être passé par l hésitez pas à Sub et je vous suivrai en retour. Prenez soin de vous et de vos proches. Je vous souhaite que du bonheur avec vos chéries..😘 ..À bientôt..💨💨

Transplanted blueberry clone 3 to a 5 gallon, amnesia auto 3 has had a burn spot on the leaf for a while, she is also the smallest auto, any help appreciated! Update, starting using GHE flora series nutrients. Saved blueberry clone #3 finally I do believe.

It’s hard to believe this amnesia haze is only in week two of flower! She is kicking butt and LOVING the HLG 550v2 as are her neighbors. I got a little stretch out of her but it appears that’s about it. The colas look like they’ll be about 8-10”. I moved the light down for a day and gave them 85,000 lux and while they are still reaching I don’t think they liked it as much as 65k so I brought it back up. I did take a few of her pie plate sized leaves of just to let a little extra light to the lower sites as well. Thanks for looking and happy growing!

harvest time soon. Maybe making hash or some cookies out of her. Smell is very intensive right now. Unfortunately I repotted her way too late she didn‘t got dense buds. take a look at my other diaries for good plants haha :)

End of the grow is near. plants are showing end of the flowering phase. and asking for a cut and trim. we let them ripen for a week or a day of 10. and then its harvest time.. can not wait to taste this Lemon Dream

Still have these ladies in there Solo cups will most likely pot these girls this week Finally moved these ladies over to there pots looking good for now Oh yea no nuts just yet still going with PH bal water

End of Week 9, the Trichomes on the Painkiller Loopings ready to Chop. The Blue Dream needs 1 more Week. Bald wird geerntet !

this is the first week of the flowering i hope my plants will get bigger the same I turn off the ventilation and i get +5 cm height 💪

the buds are getting fat. it likes lots of nutes. showing slight fade now on the super green leaves... cant really say ive done much this week. the buds smell a bit rank though if im honest but getting super dense!

Harvested some buds earlier and others a week later. Ended up with around 200g wet / 120g dry

I had a pretty stressfull week. Same as my Lady. Trained her every day with LST. I think she looks beatiful and I am pretty happy with her.

So after our first attempt went down hill pretty fast, we wasted no time in putting another bean to sprout.Here we go! Attempt #2 11.08.2020 - bean started showing first sign of life 12.08.2020 - she started opening up. 19.08.2020 - leaves started burining at the tips again.maybe i removed himdity dome too soon so it was placed back on 2 days ago

FLOWERING STARTS In the the new marshydro set-up 120x120x200 4'x'4 FC-4800 lamp Pubes are showing on all of them happy days in the absolutely amazing marshydro tent 👌🏻💯👌🏻 and no balls in the room yet so that's good at least i know that first grow i had issues with hight but with my 120x120x200 that not going to be end problem so stretch like ya never stretch before 💪🏻 i am prepared now lol the FC-4800 is a beast and still tweaking hight dimmer don't want to burn them but also want to utilize the lamp as much as I can but will get under control 🤘🏻😎🤘🏻 1/11/21 Did some last defoliation and spread the plants out bit Tru the tent got lamp dialed in dimmer around 55% and hight around 45cm above the plants and every week will bump up the dimmer with 5% they are looking very good healthy and i am very proud of the results so far gave the proper nutrients and the normal watering in between everything cool in the hood Will be updated soon happy growings Growmies visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation. And some tent info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter

Forgot to defoliate whole way through so lost a lot of yield

Everything is going great, the planta are very healthy, waiting for the the bloom season.

Another week of flower in the books. The Afghani x Mac1 auto is finally starting to get some terp production and smelling like exotic fruit...papaya leaning. She's drinking water multiple times a day, and I've honestly stopped measuring. I give her water when she's light, and that's about twice a day. She was also top dressed this week with 1tsp of 284 bloom and 1tbsp of guano.