1° DWC Hulkberry Auto

We are 15 days after sowing. Yesterday I was going to clean the red basket with clay because that white jelly is still visible but to my surprise I saw that a small root came out of the basket and ended up in the DWC. I am happy that little root has come out despite all my mistakes but I really don't know how to permanently remove that white jelly. Will I have to keep it forever? Certainly some gelatine ends up inside the DWC creating some problems of EC and PH. Among other things, the PH continues to rise constantly and a lot, perhaps also because until yesterday I was watering the clay and rockwool from above (which have high PH and this affects the PH in the DWC?). And part of the problem is certainly the high temperature of the solution, 25 ° - 26 ° [Day 15] - 15/6/22 - TS1000 = 50cm away and 80% dimmer; - TEMP is fixed around 29° and does not go further only thanks to the humidifier that manages to keep the humidity stable around 58%. I just can't do more, I would like to keep the temperature lower but it's impossible given the heat here. When AND IF I ever raise the TS1000 to 100%, inside the grow box will become an oven; - I'm thinking of sticking with this configuration: 50cm away, 80% dimmer (120 watts) until flowering begins. If possible, at that moment I will switch to 100% power but I will have to lower the hours of light to keep the temperatures low for as long as possible, so 18/6. What a mess! - Despite everything the plant continues to grow and I am happy :) - Tomorrow I change the solution to the DWC! - At the moment I suspended H2O2 because perhaps it kills the ROOTBASTIC which contains both minerals and organic material. I wonder, I also have ATAZYME that I should start using from tomorrow and it is composed of Enzymes and organic stuff, also in this case the H202 is problematic? Help! (Same problem with BLOOMBASTIC during FLOWER stage); [Day 16] - 16/6/22 - TS1000 = 50cm away and 80% dimmer; T. 28° C - R.H. 65% - Last day with the rootbastic solution. Today I wash the DWC buchet, then prepare the new solution with RO Water, plus A + B + H2O2 and this evening I add it to the DWC bucket. EC 0.6 PH 6.0 - Unfortunately I have absurd oscillations of the PH. At 4 pm it was PH 4 and to help raise it I replaced 0.5lt of solution with 0.5lt of water at PH 7.5. Despite this, after half an hour the PH had dropped further to 3. I really don't understand what's going on, I probably carry some mistakes from the past with me. The white slop continues to come out slowly and probably ends up in the DWC, in fact the EC level rises a lot. [Day 17] - 17/6/22 - Lamp, temperature and humidity as usual. - Day after day I am learning something. I started this run just to learn from my countless mistakes. Slowly I am managing the temperature and I am starting to have less strong PH swings, but they are still there. Many things I understood thanks to some users of this site, I'm really happy to have started a diary here. Thanks guys, really! [Day 18] - 18/6/22 - Lamp always 50cm from the plant, 80% dimmer; - Temperatures: 28 ° / 29 ° C during the day and about 25 ° C when it is dark; - RH: On average on 60% which is not bad but I have several peaks on 70/80% due to the humidifier turning on when the temperature exceeds 29 ° C. Unfortunately, when it is dark it does not go below 65/70%, between a few at most this situation will have to be fixed in some way. Today I should install the two total 10-liter Co2 tanks with sugar, yeast and fresh fruit. This will allow me to better manage the high temperatures, thus trying to lower the humidity a few points. - In the DWC there are currently about 6 liters of solution prepared yesterday with EC 0.8 and PH 6. Plant is growing but the EC is not decreasing, I guess it will take a few more days to notice big changes in the EC. The solution has quite high temperatures, around 26 °, maybe 27 ° at times. As soon as possible I will start putting some refrigerated plastic popsicles in the DWC once a day. I don't know if it will be enough, but better than nothing. To buffer this situation, I have turned up the force of the air pump in order to oxygenate the DWC bucket more. - Last thing, once a day I have to check the red pot in which there is the clay as from the many roots that sprout out there are some covered with that white slop and that ends straight into the DWC. In the next 10 days I will try to do something like this to improve the situation: I will pour 0.5 LT water (EC 0 - PH 6) over the clay, being careful not to wet the central part and letting the liquid flow in another bucket. I hope that after 2-3 times the situation can continue to improve. [Day 19] - 19/6/22 - Lamp 45cm from the plant, 80% dimmer; - Temperatures: 28 ° / 29 ° C during the day and about 25 ° C when it is dark; RH: 45%/55% - Plant is tall 7 cm from the clay - Added n. 3 five liters tanks with water, mashed banana, yeast, sugar and baking soda for CO2 booster [Day 20] - 20/6/22 - Lamp 45cm from the plant, 80% dimmer; - Temperatures: 28 ° / 29 ° C during the day and about 25 ° C when it is dark; RH: 50%/60% - Plant is tall 8 cm from the clay / Added 1ml/lt of H2O2 to prevent any shit in the pool [Day 21] - 21/6/22 - Lamp 45cm from the plant, 80% dimmer; - Temperatures: 28 ° / 29 ° C during the day and about 25 ° C when it is dark; RH: 50%/60% - Plant is tall 10 cm from the clay - Added 1 lt of solution: A+B+Hydro Booster+H2O2 - Third internode is forming. The plant grows slowly but grows every day. I also added 1ml of Hydro Booster to 6 liters of solution to give her a nitrogen boost. EC max 0.8. - I am no longer having problems with PH oscillations, it remains stuck between 6 and 6.5 (pure yellow chemical test) and I don't want to use too much PH down now that the situation is under control, I hope it grows well in this range of PH. I just use 2-3 drops of PH DOWN every 2 days and I'm doing well. (this stability is certainly due to the use of demineralized water, it is saving the life of my plant and also mine, but I will need CAL-MAG very soon). - Today is the last day of the second vegetative week. From tomorrow I start adding Mineral Magic.