By continuing to use the website or clicking Accept you consent to our cookies and personal data policy and confirm that you are at least 18 year old. For details please see Privacy Policy and Terms
First time growing, will appreciate any advice.
It took a long time until root showed up. About 2 weeks. But at the end it was a success. Then the seed was placed in a small pot and it took about a week until the plant came out
1. I’m not sure if the lamp is too close to the plant, it’s 8inch away. But it seems that plant like it. It’s only 200W and picture is added 2. When I’ll change the pot for bigger, can I dip the plant few more inches into the soil, I’m worried that the stem is too long and thin
Digging plant in, wont harm now, but in later stages max 1cm add on for 3 weeks,later you can add new layer.
Now stem issue wont go away, you need wind , not direct, but constant. That makes stems strond.
Oscillating fan is what you need.
I had to dig the plant about 2.5 inches to the ground because of the weak base of the stem. About 4 hours during the day my plant is outside under the sun and wind
Hello. Do I need to dig my plant deeper to the ground? If yes up to what leaf ? Looks like base of the stem still thinner than the middle. I’ve already dig it about 2.5 inch a week ago
No, your plant is fine as it is. You can dtrengthen your stem with silicate. I personally use rhino skin by advanced Nutrients and I've seen it make a difference.
Good luck with the rest of your grow.
I think the plant is getting to hot.
Tacoing of the leaves like in your pictures is caused by heat and light stress as well as low RH.
Your temps seem to be in check on the diary 24c but leaf surface temp is different then air or medium temps.
The light height might be the issue, 200W at 8inch away is to close.
Don't see any notes on RH, might need to raise the RH as well if its to low.
Good Luck!
I had an issue with my plant at the beginning of the week. Because my lamp is not strong enough (60w as I found), I took my plant outside about 5 hours every day. And it was really hot one of the day and the plant burned. You can see it on the picture “Taco leaves”. But it healed and continues to grow beautifully
Hello. I have a question about my lamp distance. I’ve changed the lamp to MARS HYDRO 2023 TS600 LED a week ago and a distance to the plant was 18 inches. During this week a plant grew and the distance became 12 inches. I lifted the lamp to 13 inches. What distance I have to keep?
if she coped with smaller , now increasing a lot in one step will make her run. either gradually, every 2-3 days raise an inch max or just daily maintain those 12-13 that you have now.
my plants sometimes brush mars lights, never had any issue.
One step at the time! My plant got a new house. I love this tent! Also it keep the smell inside. Now it’s time to guess if it’s a boy or a girl! I bet for a girl 💖
Hello. If it’s normal that lower (fist) leaves started to turn yellow and brown? I also have a taco leaf turning yellow and soft inside (it was normal for weeks, only edges were burned). Last 3 pictures
Usually nitrogen deficiency starts yellowing at bottom and working it's way up. In your case I think it is potassium needed. It also causes discoloration
I have a lot of questions this week.
1.My plant started to get yellow/dry leaves on the lower layers. I start to add new nutrition “Big Bud” Advanced. Start to give less of the other nutrients. Re potted to the bigger planter with adding fresh “Indicsnja” soil. Looks like no more new leaves getting yellow, but still worry.
2. Also my plant grows really tall, and the distance to the lamp is only 3 inches now. Have no idea how to solve this problem
3. I started to give less day light hours, because I have a feeling that my plant is not auto. From 18 hours I’m at 14 during this week and my plan to keep at 12 light hours a day
1.My plant started to get yellow/dry leaves on the lower layers. I start to add new nutrition “Big Bud” Advanced. Start to give less of the other nutrients. Re potted to the bigger planter with adding fresh “Indicsnja” soil. Looks like no more new leaves getting yellow. Last pics
I use soft garden tie, easily found at a grow store, Walmart or Lowes. I also use 3D printed LST clips. Just make sure not to bend too much at one time as it could break the branch/plant, noting wrong with bending her down over a couple days time. Google LST for cannabis and check out some videos.
It’s a girl! Or maybe hermaphrodite. My girl grow way too tall, I keep tie it down. Seems like she doesn’t mind. I found that my PH was a little higher 7.2. Now I add PH down with every watering. It drops dorm to 6, but day after it’s up to 7 again. Also old leaves split on a stem, what can be a reason (last picture)
I found this week that’s plant is a hermaphrodit. The issue with yellow leaves is completely solved. Growing nice and pretty. I have to band it every day to keep under the lamp
The plant is growing beautiful! Start to create crystals on the buds ☺️
I keep tie it down every day, and remove Grow nutrients to slow down the growth
My snowy plant ☺️ she has dozens of buds! She stopped to grow and now only the buds are getting bigger. The smell is getting stronger, but still okey. Not sure if I have to cut more leaves or I cut good enough already.
Also before I was sure she is hermaphrodite, but now not sure anyone . If it’s a boy flowers on my marked pictures?
Hello. I have a question about the nutrients.My plant is on week 6 after blooming started. I add Advanced Nutrients supplements about 3ml/l : Big Bud, Micro, Bloom and Bud Candy. I also add HP lower. When I should stop to add nutrients? How to know how long it will bloom?
Pouring recommended dosage of PH perfect Grow, Bloom, Micro without diluting till desired ppm is just wrong. It will make EC about 2.5. This is the fastest way to poison your plants with excess of N and buying a new set of bottles. Grow component in PH perfect GBM is actually Potassium, not Nitrogen, so you need it for flowering anyways.
For the most part of flowering I would simply adjust all three components by NPK values to get flowering NPK, using as much Micro as possible (although it’s the main N part).
As we speak about 6th week of flowering, you can just add twice less or as little as possible Micro, normal amount of Grow, Bloom, and add BigBud, then anyways dilute till desired ppm. Budcandy is rich on magnesium, rising ppm as well, so don’t just add this supplement without checking ppm.
Last week with Big Bud nutrients. Looks like it’s time to switch it to Advanced nutrients? I found only 8 male flowers on whole plant. Not sure if they were removed in time, but if I’ll have some seeds I’ll be happy. This plant is gorgeous
I can see that I’m really close to the harvest. She smells soooo good
Hope I can wait few more weeks to get but fatter. Do I need to cut any of the nutrients?
Keep checking my girl every day if she is ready ☺️
Buds getting bigger. Trichomes are still clear! 🌿
Have a problem with humidity. It goes up to 80. I started to keep tent 1/2 opened and it went down to 75. At night I keep it fully opened and humidity is 70.
Also stopped with Micro nutrients and cut other down to 2ml/l
My lady smells so good ☺️
Looks like it’s time to harvest. Will need some help to identify. Buds became fat and heavy.
Some leaves start to get dry at the tips, it’s on my pictures. Don’t know if I have to do anything with this.
Also my popcorn lower buds are not ready for sure. Can I cut only half of the plant and let the bottom buds grow more?
If my plant is ready for harvest? I got a pictures of the top buds. Main bud is the darkest and I left a comments on the pictures.Also some leaves get dry at the tips. If it’s normal at that time or I have to find a problem
Ich würde vielleicht maximal noch eine Woche warten bis die ersten Trichome leicht ins amber gehen.
Bei den Blättern brauchst du dir keine Sorgen machen solange es nur einzelne blätter sind. Du kannst diese blätter auch abnehmen.
Um generell größere Knospen und auch mehr Ertrag zu bekommen, kannst du deine Pflanze das nächste mal in der zweiten Woche In der Blüte etwas beschneiden.
Man sagt das man so das untere ⅓ wegnimmt. Also überall da wo nicht mehr genug Licht rankommt und es nur kleine popcornbuds ergeben würde. So bringt die Pflanze ihre gesamte Energie in die oberen ⅔ der Knospen.
Ich wünsch dir viel Spaß und Glück bei der ernte💚🍀
I’ve decided not to harvest my girl yet and it was a great decision. Buds still are growing! Finally I can see amber trichomes ☺️ I think to start flushing it in 3-4 days and harvest at the end of the next week
I’ve cut top buds. They were way too amber. But it was only about 1/5 of the plant. The rest of the buds still with 50/50 clear and cloudy trichomes.
Today is day 6 of drying process, looks like half way is done.
I got the weight almost a day after I cut the buds, they were heavier for sure.
As I said before, I cut some of the buds that were ready to harvest a little more than a week ago. They are dried already and the weight is 32 grams.
A week after, I cut some more buds, they are still drying. The rest of the plant is not ready yet. You can see it on pictures, some trichomes are ready and some buds with clear trichomes.
There are still a lot of them growing, my plant looks like I’ve never trimmed her!
From the second cut I got 105 grams wet , looks like the same amount as I cut before.
This plant is a lot of fun! If anyone has the same experience of harvesting? ☺️
So, it’s done!
131gm dried product!
It took forever to grow this plant! I had to cut my plant 5 times, with about 1.5 weeks in between . I think it’s supposed to be outside plant and need stronger lamp. But, it’s done super well! Unfortunately before I was done with drying the last part, my first jar was almost empty. That is why on my last picture you can almost 1 jar missing lol
The_garden_of_Vixen
