First time growing

Digging plant in, wont harm now, but in later stages max 1cm add on for 3 weeks,later you can add new layer. Now stem issue wont go away, you need wind , not direct, but constant. That makes stems strond. Oscillating fan is what you need.

No, your plant is fine as it is. You can dtrengthen your stem with silicate. I personally use rhino skin by advanced Nutrients and I've seen it make a difference. Good luck with the rest of your grow.

I think the plant is getting to hot. Tacoing of the leaves like in your pictures is caused by heat and light stress as well as low RH. Your temps seem to be in check on the diary 24c but leaf surface temp is different then air or medium temps. The light height might be the issue, 200W at 8inch away is to close. Don't see any notes on RH, might need to raise the RH as well if its to low. Good Luck!

if she coped with smaller , now increasing a lot in one step will make her run. either gradually, every 2-3 days raise an inch max or just daily maintain those 12-13 that you have now. my plants sometimes brush mars lights, never had any issue.

Usually nitrogen deficiency starts yellowing at bottom and working it's way up. In your case I think it is potassium needed. It also causes discoloration

Sounds like youre on the right track. I personally don't start bloom nutes until I notice the stretch is over.

I use soft garden tie, easily found at a grow store, Walmart or Lowes. I also use 3D printed LST clips. Just make sure not to bend too much at one time as it could break the branch/plant, noting wrong with bending her down over a couple days time. Google LST for cannabis and check out some videos.

Pouring recommended dosage of PH perfect Grow, Bloom, Micro without diluting till desired ppm is just wrong. It will make EC about 2.5. This is the fastest way to poison your plants with excess of N and buying a new set of bottles. Grow component in PH perfect GBM is actually Potassium, not Nitrogen, so you need it for flowering anyways. For the most part of flowering I would simply adjust all three components by NPK values to get flowering NPK, using as much Micro as possible (although it’s the main N part). As we speak about 6th week of flowering, you can just add twice less or as little as possible Micro, normal amount of Grow, Bloom, and add BigBud, then anyways dilute till desired ppm. Budcandy is rich on magnesium, rising ppm as well, so don’t just add this supplement without checking ppm.

Ich würde vielleicht maximal noch eine Woche warten bis die ersten Trichome leicht ins amber gehen. Bei den Blättern brauchst du dir keine Sorgen machen solange es nur einzelne blätter sind. Du kannst diese blätter auch abnehmen. Um generell größere Knospen und auch mehr Ertrag zu bekommen, kannst du deine Pflanze das nächste mal in der zweiten Woche In der Blüte etwas beschneiden. Man sagt das man so das untere ⅓ wegnimmt. Also überall da wo nicht mehr genug Licht rankommt und es nur kleine popcornbuds ergeben würde. So bringt die Pflanze ihre gesamte Energie in die oberen ⅔ der Knospen. Ich wünsch dir viel Spaß und Glück bei der ernte💚🍀