Anesia Seeds / Big Bazooka💥!

From the 9th day I started adding Hesi Root Complex 1ml and 2ml PowerZyme per 1L of water. We poured out water only as needed and did not water the stem! Day 13. I increased Hesi Root Complex to 5ml/1L Hesi PowerZyme 2ml/1L We poured out water only as needed and did not water the stem!

From the 15th day I start adding half the norm of Hesi TNT Complex 2ml/L, we test with 210 ppm so as not to burn the roots. On the 18th day, I moved the plant into a larger pot and watered it with half the recommended amount of nutrients and of course, transplanted the plant into a larger pot. On the 21st day, I did LST (Low-Stress Training).

I am very satisfied with the Big Bazooka strain; it is not stressed by being transplanted into a larger pot, nor by using LST (Low-Stress Training) or main-lining techniques. It's important not to water it abundantly and to have fertile soil with proper drainage. Day 22. After LST, even though it was a bit stressed, I keep the ppm between 200-220 until it gives more nodes. Day 25 of vegetation is going well; you can see this because the soil in the pot is dry on the surface. We water more abundantly with 2 liters of water, keeping the ppm at 220 and pH at 6.2 PowerZyme-4ml Root Complex-4ml TNT Complex-6ml Day 28 3 liters of water with a pH of 6.3 and 240 ppm. PowerZyme-4ml Root Complex-3ml TNT Complex-10ml

For the next 2 weeks, I think I'll continue to shape it and wait for a stronger root system to develop. Day 34 3 liters of water with a pH of 6.3 and 240 ppm. PowerZyme-6ml Root Complex-6ml TNT Complex-12ml

The vegetation is doing wonderfully.

Great, the form is ready. We're in the last week of vegetative growth and about to switch to a 12/12 light schedule 🌿😊. On day 45, I switched the light cycle to 12/12 hours.🌸 On day 48, I raised the PPM to 300, hoping it doesn't burn the leaves. If it goes well, we'll raise it to 350 next time. pH 6.4

I'm already waiting for it to bloom; it should happen this week. I raised the PPM to 370, and it seems to be without any problems. Next time, it can be increased to 420 PPM. I will stop using Hesi Complex fertilizer and switch to Hesi Boost to stimulate flowering.

Here we are gradually moving to flowering. I've started using Hesi Boost at 2ml per liter. The PPM remains at 420, PH 6.4 On the third day of flowering, I trimmed some of the leaves and, of course, I watered it but I raised the PPM to 520. This week passed quickly, but it also consumed a lot of water. In the first week when it blooms, I love to add a bloom booster or, as I did this time, I added Green Sensation from Plagron. Next week, already without stimulants.

I've adjusted the PPM to 420💜. I've excluded all the stimulants and left only Hesi Bloom. I also add Hesi Zyme to each watering, but only half the recommended amount, which is 1 ml/l.

So, we are entering the third week of flowering. I have started adding Hesi Phosphor Plus and Green Sensation from PLAGRON. The PPM was raised to 540 and pH to 6.4. We are growing steadily and big. The last formation I made was on the 20th day. 🍭 PPM 620 PH 6,4

This time, instead of Hesi, I'm testing Plagron Green Sensation.

The plant started drinking a lot of water, but the flowering is going well. 🌸

Due to poor drainage or rather the coconut dust that accumulated at the bottom and gathered all the fertilizer. So, urgently, it was watered, dried, and then watered again until the ppm reached almost zero. In order not to lose the quality of the trichomes, I decided to cut it.

I will add the comments when I finish with the drying.