Chat
RecommendedRecommended

budnet aeroponics

2
13
5
1330
5 years ago
Follow
2
Indoor
Room Type
Topping
weeks Technique
Defoliation
weeks Technique
83 L
Pot Size
Grow Conditions
Week 8
Flowering
40.64
cm
inch
Height
12 hrs
Light Schedule
13+ conditions after
Login
Nutrients
ml/l
ml/gal
tsp/gal
1+ nutrients after
Login
Commented by
zerobane zerobane
5 years ago
###12/14 update#### PH 5.7 PPM 1300 CO2 500 Temp 72F cycle time 4mins-off/11seconds-on Light cycle: 12on/12off Traveling for work; so another 2 week jump Overall growth looks great; no real issues. Nutrient levels seemed to jump up a bit from 1000 to 1300; might cut back to 800ppm to see if it levels out a bit. Couple snaps of the clone tent; using a ultrasonic mister and a low ppm solution (200-300ppm). Interesting hair like root growth.
Similar Diaries
Sour Diesel Barney's farm
18 weeks
Sour Diesel Barney's farmaleshka
Sour Diesel
7 minutes ago · 3 comments
purple skunk auto #2
2 weeks
purple skunk auto #2biggerbud420
Purple Skunk Auto
13 minutes ago
Grow Strong Cup
11 weeks
Grow Strong CupFamilytrees19
Kyle's Skywalker OG
2 years ago · 4 comments
First coco grow
8 weeks
First coco growmedicinal
Barney's Farm - Bubba Kush
2 years ago
My Forbidden, Runtz Auto
12 weeks
My Forbidden, Runtz AutoOmisan
Forbidden Runtz Auto
2 years ago · 15 comments
Newbie & Candy Store R1
4 weeks
Newbie & Candy Store R1JadeGolemsMM
Candy Store R1
a year ago · 6 comments
Beginner Auto Grow! 4 strains RIP
10 weeks
Beginner Auto Grow! 4 strains RIPSeedler
+2 strains
2 years ago · 10 comments
Outdoor Auto White Widow
10 weeks
Outdoor Auto White Widowhooolian
Auto White Widow
2 years ago · 1 comment
Grow Questions
zerobane
zerobanestarted grow question 5 years ago
Leaves are fanning upwards and undergrowth is huge in flowering phase. Should i be worried about the upwards fan, should I trim on this point or just leave as is and just remove dead leaves?
Solved
Leaves. Curl up
like
DWCHC
DWCHCanswered grow question 5 years ago
When mine get to this point, I deleaf anything that doesn't have trichomes showing or are laying ontop of another bud..the flower auxins are in abundance and allowing a higher par down deeper into the canopy can really help out lower bud development. One rule I follow is to avoid removing more than 30% of the canopy on any day, usually followed up with a light nute application and a few days rest before another selective deleaf. To this end, I've reduced workload during trimming and have had less popcorn buds. On a side note, resin production is a defence mechanism of the plant to discourage browsing by pests. When the right amount of leaves are removed, the plant will respond with an increase in resin to counteract the browsing.. I don't know of any science study's that have been done in this area, but my trials have shown a noticable difference.. Cheers
Comments
Login

Show by Week
Sort by
popularity
popularity
newest
oldest
Ferenc
Ferenccommentedweek 25 years ago
Nice system mate @zerobane
zerobane
zerobanecommentedweek 95 years ago
Thanks @dwchc and @Cannibalgardens Harvest in next 48-72 hours pending time with holiday; i'll update the journal with results. I did 2 experiments for this grow that support both comments. Keeping a consistent canopy seems key for yields, i'll go little more "cutty" with reducing canopy towards middle of bloom to increase light on next grow and run a control with no canopy cutting as a test. 1. the green crack on right side - 1 plant no trimming, 1 plant moderate, 1 plant heavy trimming throughout grow to keep a solid canopy. I'll weigh out results, but so far the the heavy trim is showing the largest colas. 2. The left side is the ak47 - it has 1 clone growing in back and 1 re-grow on same plant that was harvested on my first grow in front. Curious to see the yields and strength on re-grow. One thing I did notice was the nutrients starting spiking on return res; 800 on feed / 1200 in return. Even when i dropped to 200 for flush, the return was still showing 600-700ppm. Interesting; not sure on the "why" or what nutrient is coming back at such a high level.
CRiSPrGrow
CRiSPrGrowcommentedweek 15 years ago
"Cycle time: 7 seconds on / 5 minutes off " for the top feeding right? very informative 👌
CRiSPrGrow
CRiSPrGrowcommented5 years ago
@zerobane, very interesting !
zerobane
zerobanecommented5 years ago
@CRiSPrGrow, Thanks! Will add more info on setup for week 2. Using a mistking repeat cycle timer; the 7s-on/5m-off is the spray cycle for the aero nozzles. The aim at top of rootzone and spray a 50 micron mist.