Likes
Comments
Share
Its running perfect, but my Photos want to flowering. 🌼🌸🌺 I think the pineapple and papaya needs round about 10days to harvest. 🍍 The trichomes are currently still in the milky stage. 🥛✨
Processing
Likes
10
Share
@Dunk_Junk
Follow
Day 77 - She's growing well this week. Starting to show her trichomes 😍
Likes
24
Share
@Zegr8
Follow
Harvested a week early because of bud rot caused by calcium deficiency. I did a triple wash with hydrogen peroxide, baking soda and plain water to rinse. Note for future Coco needs a lot of calcium and magnesium. With constant drip system you need way less nutrients in solution. Check PH if you use calcium sulfate or silica!!! Once cured the weed has a good nutty smell with a little berry. It’s not very resinous, it has a good mind numbing effect but doesn’t lost more than one hour for 3/4 puffs, this is because of early harvest for sure because my previous crop was lot more potent.
Likes
12
Share
@Xpie77
Follow
✂️ Oogst & Droging Aantal planten: 5 Verwachte opbrengst: ±30g per plant Totaal verwacht: ±150g droog gewicht Status: Hangend te drogen in een donkere ruimte, 18–19°C bij 55% RV Verwachte droogtijd: 7–10 dagen, daarna start de curingfase De geur is tijdens het drogen al zeer intens: een combinatie van zoete bessen, kush en gas. Toppen zijn compact en rijk aan trichomen. --- 🔜 Wat volgt Zodra de toppen voldoende gedroogd zijn (stelen breken met een ‘snap’), start het curingproces in glazen potten. Dit zal het terpenenprofiel nog verder verdiepen. --- Eerste conclusie: Zeer sterke run met Blue Zushi. Alles wijst op een premium eindproduct, met een goede balans tussen geur, smaak en potentie. Eindbeoordeling volgt na curing & testsmoke!
Likes
1
Share
Absolutely blown away by the new 2025 setup, prev ran 3 tents 😂, switched to AC Ifinity 2,4 x 1,2 single tent, 3 x 150 or 6“ fans. Fans all port outside, 2 exhaust with yet uncoupled carbon filters, 1 inlet with pollen filter. 6-7 air push fans (not all yet on 😂). SpiderFarmer 16L humidifier, inkbird RH control, inkbird heat control, heater, trotek dehumidifier (12L) with drain line and reservoir. Blumat system with RO fed 20L water butt, each pot with 3 long ceramic blumats. Data logger from SensorPush including WiFi hub and 4 sensors. One in cellar room (lung room), one above each plant canopy. Setup logger n sensors and track VPD. System running itself
Likes
44
Share
@UKauto
Follow
doin gooood 👌🏻 Responded well to the topping and LST. First sign of pistils today. Should turn out great, hoping for a nice stretch soon 🙏
Likes
21
Share
Bushy little mama. Removed the tobacco plants as they were taking over the tent. She is on her lonesome now so she can make full use of the space available. Looking like she needs some defoliation pretty soon. 3/10 Gave her a radical defoliation. Took away about 85% of all the larger fan leaves and some lower canopy growth. I want all the plants energy to go into flowering and developing large kolas. Don't expect the auto clone to get much bigger, so won't be potting up, but she may produce a decent kola.
Likes
7
Share
@HisHope
Follow
Easy harvest she did well despite being heavily affected by the gnats in seedling/early veg. Strong strain guys but it did hurt her More after dry
Likes
9
Share
@Coopmc
Follow
Kings line doing fine
Likes
52
Share
Ne Obliviscaris. Humidity Day 40-45%, Night 60-65% Internodes are very close together. was hitting 450umol at seedling level making it absorb more than it can use, reduced to 280-300umol @18 hours as expected vertical growth increased. During the 18 hours of daylight the first 9 is highly saturated in blue, 5000 kelvin, the 9 hours thereafter are closer to 3000 kelvin. Last 9 hours dosed 280nm. Height is too far to cause damage. UVB light is not detected by plants in the same way other wavelength/colours are. UV cannot be measured using umol as it doesn't drive photosynthesis. The plant has tiny little sensors that get set off to even little amounts, dimer salt bridges, the UV decays these salt bridges, which initiate response. You don't need large/long exposure doses for the plant to recognize UV is present. What's an enzyme? Think of it like a multiplier, you can add an enzyme to any particular biological process to vastly increase its proficiency at a particular process. Cannabis plants take blue/violet light and use it to create an enzyme called "photolayse". This allows the plant to repair UV damage done to the plant using a process called excision repair, this repairs the damage at a much much faster rate than it could by itself. Repairing 100% damage. The key is the plant needs time to build a reserve of the repair enzymes before using it. This is replicated in nature as, by midday UV levels peak, the generally cooler mornings allow lifetime to build up. The problem I encountered was dosing with 280nm lights on or 1 hour after the lights were on. Photomorphogenesis, the plant plans for the future of its growth, if the wavelength is not present during growth then how can it plan accordingly? The very presence of UV changes parameters with which the plant will grow, light itself dictates the growth pattern of the plant. Not only that it can dramatically alter the regular terpene profile of a strain in unexpected ways. Gran daddy purple grown using 280nm can triple already high terpene linalool. Linalool is terpene best known for lavender, largely responsible for its beautiful smell. Trouble sleeping you say? Having tried Durban poison from a dispensary and reading about its levels of tetrahydrocannabivarin. I've always wanted to taste the difference UV would make to such an already stand-out strain such as Durban.
Likes
22
Share
@Zengrower
Follow
The Titan is growing as I had hoped. The many side branches are growing larger and in the center is a nice main cola. Beside the LST clips a few weeks ago, no more training is needed it seems. I did some defoilation to optimize the airflow and to give the developing buds in the side branches more light. More pics and updates coming later this week. The Titan is developing a really nice flowery/citrus like smell. I added some Bio Tabs Bio PK 5-8 to the mix to support the many buds she is forming.
Likes
4
Share
@Andres
Follow
She growing strong and healthy...
Likes
7
Share
@fabialien
Follow
Lunes 11 de marzo 7 am de 2024: Se dejaran hidratando las semillas por 24 hrs. Martes 12 de marzo 7 am de 2024: pasamos a papel dejamos por 24 hrs. Miércoles 13 de marzo 10 am de 2024: revisamos las semillas y vamos preparando macetas pequeñas para transplante. Miercoles 13 de Marzo 3:30 pm se traspasa a tierra. Viernes 15 de marzo 11:47 pm 2024, ya que abrieron bien se pone bajo lámpara 100w a 30 cm de distancia, tienen domo protector! El lunes en la nueva semana subimos el avance, hasta el Lunes... Sábado 16 de marzo 2024, de las 3 semillas la 1 ya abrió completamente, 2 y 3 están por abrir completamente.
Likes
70
Share
@MrJones
Follow
Sky Walker ~~~~~INDOOR~~~~~ DAY 141 Above Dirt 💬SUNDAY 01.13.24 - So this is the update that I did not have time to do over the weekend, the girls are bouncing back from the hard time I put them through last week, and the flowers are starting to chunk up along with more foliage, however, there will be no more defoliation until we are close to completion, for now, its just water, and wait, allowing the Gaia Green to do its thing, the light is at 100% and the girls love it. ~~~~~~~~~~~~~~~ 🌱Sky Walker 👨‍🌾🏽Sativa Jones 🌤️@Medicgrow420 SeedBank Seeds 📝@gaiagreenorganics 📝Bokashi Biochar ~~~~~~~~~~~~~~~ 📝 Skywalker OG Strain is a top-shelf Indica dominant hybrid. It is a cross of Original Amsterdam Blueberry, OG Kush, and the indica strain Mazar from Afghanistan, and is best known for its super potent effects and sky-high THC levels.
Likes
29
Share
***Note that I started to count the days when I placed the seeds between paper towels. The seeds were planted 3 days later and sprouted from the ground 2 days after being planted. D80 (13/05/2021): I'm looking at the trichomes every other days. Glue Gelato is starting to show amber on top buds. No amber for Banana Kush and Gelato. This time I will chop them all at the same time so the one I will rely on is the Glue Gelato. As soon as she is ready, I will harvest them all. Banana Kush and Gelato would probably need more, but in term of logistic, I need to harvest all my plants at the same time. D83 (16/05/2021): Not ready yet. I'm checking trichomes closely! 😬 - Light: the lights are at 100% and at 12 inch form the plants. - Temperature: during the day: 24-25C ; during the night: 20C. - Humidity: the humidity is maintain around 46-48% all the time. - Air circulation: There is an oscillating fan on the ground, one fixed fan pointing on top of the canopy and one fixed fan to help cool the lights. - Water: I gave water every other day or when the ground feel dry or the pots feels light. - ***IPM: I never mention it but I'm using nematodes pouch as an integrated pest management. I had trouble with pest in my first grow and I learned from it. That's the only thing I do for pest and of course watching closely and regularly at my plants 😊
Likes
50
Share
13 hours and 33 minutes of daylight when I took these photos and this video on August 27th. I've been slacking this month on uploading, having to play catch-up with this just like everything else in my life. I'm so glad it's going to be September in a couple days. The weather is cooling off thankfully🙏 So, I cover most of the situation in the video, but basically GG (Good Girl) is looking great and her flowers are coming along nicely, whereas PC (Problem Child) is still continuing to be a Problem. Child. First of all, PC is a much heavier feeder than GG. I have to give her almost 2x as much food as I give the other plants for her to have the same color. And since I've been running around all August and haven't had much time to tend to my beauties, I haven't been feeding as much as I could have. The other photoperiods are fine, They're still getting nutes from the soil and hopefully the mycelium from the substrate blocks have moved into the root system and are acting like good roommates and doing their part to support the soil foodweb. But this isn't enough for PC. Her flower development is definitely behind and her color is a brighter green than the other plants. Hopefully I'll have time this month to just put the groceries to her and encourage those flowers to bloom because now I'm worried about the frost that will start coming in early October. Frost and ripe trichomes don't mix very well. My apologies for repeating myself in the video😬
Likes
14
Share
@danwho
Follow
9/15/2024 Stretch is moving along nicely. Only bummer is that the tops are crowding the light fixture and reducing the total light penetration. Working to keep the PPFD and DLI in a reasonable range and even across the canopy. First day of week 3 bloom nutrients. Both plants are looking incredible and moving along nicely into flower. Working hard to keep Plant A from overcrowding plant B. 9/17/2024 Adjusting fan setup to promote better circulation around the tent. Continuing to move the light over plant A an inch at a time. Running out of room slowly and will likely be forced to supercrop. Added 40watt bar light over plant B to offset the take over from plant A. 9/21/2024 Discovered herm signs all over plant B during trimming. Decided to cull it to avoid issues with plant A. Going to work to tailor the tent setup to push plant A going forward. The empty bucket will remain in the tent but is disconnected from its feed line and return line to the reservoir. Due to the herm in plant B, I left a lot more plant material on Plant A than I initially planned. With more room, it should hopefully bush out even more! Flower development on plant A is good with great stacking thus far. Still stretching, but slowing down. Any more stretch will require super cropping to avoid burning as I turn the lights up over the next two weeks, Planning to add lower lighting now with the additional space.