Things are going just fine for the first week of flower, but not perfect. She got a little over fed with N, which was due to me not backing off of the cal mag I use, which also contains N. Mostly just some clawing on a few leaves, so I didn’t freak out and just topped off the bucket with plain water. Other than that, I’m trying to give the individual tops some room, but I’m kinda doing the training I’d normally do in veg in flower. So I’m trying to be very gentle. I’ve removed the older fan leaves and cleaned up any that prevent light from getting into the middle of the canopy or blocking other tops. I expect the stretching to finish this week or next and again, I hope flipping when I did doesn’t affect the final yield too much. See you in a week...
@Gardenofweeden, you may be right, though this particular pheno didn’t have those big fat flowers like many other BD phenos I’ve seen. Looking at some of those other ones, 8 tops seemed like plenty. Ordinarily I would veg longer, but I needed the harvest to be done by a certain time in this case.
Good luck with DWC grow 😀 How is the water temperature? I want to try DWC next time too but I was reading that water temperature is the main issue (too high) and the roots will not grow and RIP.
@grzesiekkuzniak, I think that is the biggest lesson I have learned with this DWC grow. I switched to a sterile approach and since then I’ve had things dialed in. I change my water every week and use UC Roots, and I swap buckets each week with a fresh, clean bucket. After that if you just track pH and ppm and top off accordingly, it’s a stupid simple way to grow and I’m never doing it another way.
@iLoveGoodWeed,,if u change water frequently you can have temps up to 25 C and nothing will rot and no hydroguard needed..................dwc is about keeping it clean and not let water oxidize too much ...................too cold aint good too btw..........💩
@grzesiekkuzniak, I also found some adhesive cable clips that I’m going to attach to my bucket lid so I can more effectively train my plant, while also being able to move the lid and plant from one bucket to another.
@grzesiekkuzniak, early on in the grow I fashioned a little cardboard disc to cover the clay pebbles and keep light out of the reservoir and I wrapped it in tin foil and taped it to the bucket. It’s super janky but it’s working. I found some 1/4” thick neoprene sheeting I’ll use next time that has an adhesive backing and I’ll cut to my specs. Should be much less ridiculous looking.