The8thChevronanswered grow question 6y ago
Yea, like I said, cut off all the affected leaves just in case. And be very careful not to brush them against anything else.
Similar Grow Questions
Solved
Aeries
Slimey/Webby parts of the flower? Looks like rot or mold?I removed the infected parts of the plant and defoliated the fan leaves around the sites to help with aeration. Did she go past her prime and now she is dying? Or just because of high humidity in the air?
Buds. Other
Other. Mold
Plant. Other
6y ago
1
Solved
Daddypool89
mold or something else?Just dried gorilla glue and went to trim some more of the leafs off before i started curing and while inspecting the buds i seen little white strings inside the bud, looks like it could be in early stages of mold and if it is what should i do?
Other. Mold
5y ago
2
Solved
KingMickey
Is this still good or is it ruined?Hung plants to dry and waited for stems to snap, unfortunately when I checked the buds were so crispy they basically crumbles in my hands. I heard this could be mold/rot also. Did I mess up and over dry my buds, or is this something much more awful? Is this still salvageable?
Other. Mold
Other. Harvest - Drying
2y ago
3
Solved
rando_herber
Mold on stored coco/worm castingsHey all,
I mixed together 40L of Coco and 10L of worm castings, and left it sitting with a lid. Sure enough, it has some mold growing on the top. Can I still use this medium or should I just throw it out? (Not broke, but cheap!)
ThanksWeek 2
Other. Mold
5y ago
5
5
Solved
greenflipcali89
How to treat (NOT prevent) Powdery Mildew on a flowering plant (week 4)?Ok, here is a question to ALL growers out there. How do you remedy Powdery Mildew on a flowering plant? I gave her a major defoliation and sprayed the milk/water sol'n. So HOW do you treat PM? Milk/Water or H2O2/Water? Or?? Suggestions?
6y ago
2
4
Solved
sorethumb
humiditythe humidity has been controllable with my a/c… but we just had a few days of rain and humidity. my plant has a mildewy smell. i see no signs of mold at this time… is it time to play it safe and get a dehumidifer?, or will a couple days of 55% humidity be enough to stave off moldOther. Mold
5y ago
1
1
Solved
idkman1337
mold?those buds are molding right? and nothing i can do with them
Other. Mold
4y ago
1
3
Solved
LegalCanadian
Does my plant look healthy? It is approx 13” high alll four of them... lots of new growth.... and how can I control height growth? As I am limited to 63” grow tent... I have done zero cropping besides removing a few fan leaves blocking light to lower
Canopy.Week 4
Other. Mold
8y ago
2
2
Solved
guerilla
(budrot) darkness for early harvest?Hi all.
I have just found 2 more buds with budrot..
They are around 8 weeks now. Showing milky trichomes on most. Some with slight clear/milky. Very few with amber...
… universal_button_show_more
Buds. Other
Other. Mold
Other. Harvest - Drying
5y ago
2
2
Solved
ImIHighyes
Mold suspectingHi, this is my first amateur growing, I have 2 strains Bud Orange Auto and Skywalker Auto.
I noticed a musty smell from my 2 plants, one is almost ready but the other one seems in stuck..
From the pictures, could you give me some advice if my plants are healthy or not? Many thank
Other. Mold
2y ago
2
3
Solved
buddhi_coop
Co2, tempAre these okay levels? Been kind of hard to manage the heat in my tent. Weather here is super hot right now.
Other. Mold
Other. General questions
Setup. Ventilation
5y ago
1
Solved
CannaZen
H2O2 bath for light PM on pocorn/trim, pre QWISO?PM found on trim, post harvest, my bad darnit. *Very light* but I take pride in my work. Personal consumption only. Forums reviewed so lets skip the chatter, will proceed with QWISO. Should I do a H2O2 bath before extraction in ISO? Trim off best plant, Dos Si Do which is strong.
Week 19
Other. Mold
7y ago
1
1