The Grow Awards 2026 🏆
Likes
Comments
Share
Hoping for a big finsh a few plants are a couple weeks behind but you czn see it doesn't take long for them to flower and take shape
Likes
18
Share
5.6oz with a 3 week Veg in a 3 gallon, I'd say it was a good harvest
Likes
48
Share
@xbrico
Follow
Day 36/Flower Day 8 - Starting to get them girle bits showing now. Stretch is still unreal but the smaller nodes that have crept up to the top are thickening their branches so that’s a good sign they'll hold something and if not, have a spare elasticated SCROG net for support, which will DEFINATELY be needed by the looks of things!!! The main branches are sitting near as thick as 1 of the stems of my last grow so these girls are definitely sturdy and strong growers! If only they didn't push for the roof!!! Apart from the one SCP (#2) that is staying squat in the back corner...sub nodes getting up there but the "tops" staying low and bushy!!! When I start to see a few more flower sets/bud buttons proper actually forming, I'll start inching up the lights to 13/11 over the week...still tempted to start it now but thinking best to wait til the bloom nutes get upped drastically (which is next week - will be upping them by about 50-60% volume). Feared a bit right now that the extra light may fuel some stretch rather than fuel the flowers...but then again, having the plants acclimatise to 13/11 by the time the buttons are forming may not be bad...but then again, that 13/11 may slow down their formation!!! Choices and Choices!!! Was expecting the flower initiator would have knocked some time of the pre-flowers showing (can't think now if nodes were asymmetrical before flip...honestly couldnt have vegged any more though...or could I???) but nope, hopefully the buttons start to set quickly now though. Apart from that, all going well so far. Been a bit of a drop in the temps outside and clearer nights so hopefully that helps bring day temps and night temps down a bit - bringing down humidity some too. Need to restart my CO2 Jug now for the flowers and keep on watching them grow! Happy growing all! 💪
Processing
Likes
11
Share
@4F1M6
Follow
I started germination of 1 Strawberry lemonade bean on 29/12/2020. I pre moistened my rockwool cubes with ph balanced water to 6.4. Made sure the plug was just damp and not soaked. Using a small wooden dowel I increased the size of the plugs pre made hole. Than I sowed my bean into the hole. Ripped off a small piece of rockwool and mulched it up. Lightly filled the hole in with the mulched rockwool. Than stuck the plug into a misted humidity dome, to complete germination. Shouldn't take anymore than 4-5 days to see a sprout. Once I see some cotlydon leaves bursting to the surface. I will get the plug planted into some 1 gallon pots. Plus get this lady situated into her home. Cant wait! Some background information on my experience with Strawberry lemonade. Ive only grown this variety out once. In a 1 gallon SOG grow where she faired ok. I could tell she really wanted to explode and branch out. But a restricted root mass just would not allow for it. She had some of the sweetest tasting flowers that came with a strong potent kick. Really looking forward to giving her a larger container and see what she can do when shes let loose.
Likes
3
Share
@CeGrow
Follow
week 6 day 39 first day outside after may holidays the wheather was bad, so not much light, but she growed well the flowers are growing nutrition: day 39: 0,4 litre water + 1,2ml mairol blütenwunder
Likes
25
Share
@kizdog
Follow
DAY 85 - 92 (F31-F38) Lots of progress on the flowers this week. Not much stacking on her but the buds are super hard and covered in trichomes. Honestly the frost on her is incredible, even on the poorly half of the plant. I did my best to cover the mold with the agricultural sulphur I bought, but I could only really cover the top of it. The mold is still exposed and visible in some places. I really hope the sulphur works. I also added an extra circulating fan on the tent floor to increase air movement in the bottom half. Thanks for reading growmies. I really appreciate having a community to talk to about this stuff. Our plants are all beautiful and deserve the best possible treatment. We should worship them! See u next week 👊💚🍃💨🌷 EC: 1.2 pH: 6.1
Likes
3
Share
@Knowitall
Follow
This week I've managed to get down b&q and get my materials to build the table.. it's all set up not just gota hand water this week because I need an upgraded pump to reach to all the plants on my dripper system..
Likes
19
Share
Really love a set of scales to keep track of weight too. pH and EC are both critical for thriving plant health, but temperature also plays a pivotal role in achieving optimal growth. It also happens to be the fundamental parameter that's most commonly overlooked. When you think about temperature in the context of a growing environment, you could be referring to the temperature of the air around the plants or you could also be referring to the temperature of nutrient solution or irrigation water, which will affect the root zone temperature. While air temperature is important, for the purposes of this piece, I'll be focusing on root zone temperature and its effect on nutrient uptake and overall plant health. That's because a plant's root system is the location of two essential chemical processes: water and nutrient absorption. In each of these processes, having the correct root zone temperature is paramount for these to occur efficiently. In a nutshell, root zone temperature will affect the rate at which your plants are able to absorb nutrients. If you let your root zone temperature remain unmonitored and uncontrolled, this could lead to disastrous effects on your overall crop yield. Nutrient absorption is largely driven by chemical processes, which take place in your plants' roots; the efficacy of these processes is determined by the temperatures to which those roots are exposed. Once your root zone temperature moves out of its optimal range, the plant will not be able to deliver optimal levels of nutrients and water. Ideally, you should aim to have your nutrient solution or irrigation water temperature at around 18 – 22 °C (65 - 72 °F) to ensure optimal nutrient and water uptake. In addition to having an effect on nutrient absorption, your root zone temperature also affects oxygen availability and solubility. If your water is too warm, you could risk starving your roots of oxygen as warm water cannot hold as much dissolved oxygen as colder water. On the other hand, if your water is too cold, this could shock your plant roots, decrease plant metabolic rates, and stunt plant growth. Peace out.
Likes
9
Share
@Headies
Follow
This is the beginning of each week. So I flushed them and switched nutrients. They were mag deficient, nitro toxic. Not PH actually. I'm adding co2 next week after I seal the room. I think I need to back the PAR down to 800 but they are still alive and it's over half way done. How any more weeks? I thought this was a 65 day auto. Hydro in a 5 gallon pot could add up to three weeks I heard with Autos. could these go 12 weeks total?
Likes
7
Share
@420keef
Follow
Finally got myself a dehumidifier, now i can controll the humidity in my room because it often went above 60% 🤷‍♂️🏻 Also love how the big northern light is really packing some weight! & the buds on the bottom look as good as the ones more on top!! Can’t wait till i can harvest all of em😁
Likes
46
Share
@Capo420
Follow
This past week has been a blast! After getting these ladies nutrition straightened out, they are thriving!💚🌱💚 I gave defoliated wayyy more than what I see other growers traditionally doing. After the "3rd and final haircut" I defoliated two more times 😅 Thank you the GD community for the support and resources along the way 🙏 My only concern now is the tent actually becoming too crowded.😆. Other then that I am thinking it should be smooth sailing these next 6 weeks or so. 🏴‍☠️😎🏴‍☠️ Happy Growing! 💚💪🌱😎🌱💪💚
Likes
3
Share
Autoflowers Update 🌱⚡ One of the autos is clearly ahead of the others, showing faster progress in its flowering stage 🌸. It’s exciting to see the difference in growth rates between them! I had a small issue with the light, which caused some slight leaf burn 🔥🍃 — you can see it in the video too. Nothing serious, though, and the plants are still looking healthy and happy overall. 💪🌿 Can’t wait to see how they develop over the next couple of weeks! 🚀.
Likes
5
Share
Small harvest but was due to the over feed of CAL-MAG I had quite early on but still pulled through and flowered almost and OZ. Really nice Sativa from Barneys Farm.
Likes
12
Share
@w33dhawk
Follow
Glaub ich hab ein bißchen mit dem düngeplan übertrieben wie man bei dem Video sehen kann bei den Sapphire scout bei den beiden zkittles die vorne stehen auf der rechten Seite sind es die jiffies die sich nicht richtig aufgelöst haben aber die hintere sieht gut aus. Mir ist gestern durch ein Gespräch mit nem Kollegen aufgefallen das ich den spreader von der Lampe schon vor 2 Wochen hätte drauf werfen können ich Trott hab das völlig verplant hab den gestern Abend schnell mal drauf gesetzt besser spät als nie
Likes
30
Share
Content de voir le bout! Presque 4 mois. Mais elle sent fameusemrnt bon. Et j'ai assez de dechet pour faire un bon paquet de bho :)
Likes
43
Share
@Eyeduno
Follow
Got the dehumidifier out the weathers making the humidity stupidly high
Processing
Likes
6
Share
A little topping on 3 if the girls. Some low LST on a few. Pinning leaves for maximum light. The 3 I topped are coming along also. Sometimes my head starts playing with me, doubting my efforts. Only light feeding. Super light right now. Nothing on schedule. Just like to adjust according to nature so I dont disturb the peace and make things harder.. i like to go with the flow and not make issues.. only fed once this week and once last week with nutrients.