Chat
RecommendedRecommended

Any recommendations for cloning?

Erasmus
Erasmusstarted grow question 4 years ago
I just topped a second time and am trying cloning for the first time. Any tips or suggestions? I have them in a cloning chamber and I used clonex cloning agent. I raised the humidity of the tent and tried standing them up as much as possible.
Solved
Week 4
Techniques. Other
like
DreamOn
DreamOnanswered grow question 4 years ago
Looks good. Keep the temperatures in the cloning chamber between 70-78F with relative humidity between 75-90%. I use to fill the holes in the cubes with the rooting agent and cut the stem at a 45-degree angle then just put in the cube. Add a little layer with water to keep all moist and the humidity up. I would have removed the lower leaves also.
1 like
Complain
Selected By The Grower
amon_grows
amon_growsanswered grow question 4 years ago
Looking good, and sounds like you have a good environment setup. Beyond keeping the humidity at 90% in the clone dome, I would just recommend clipping half your fan leaves to reduce the bend and open things up a bit more. If you can get a heating pad with a thermostat it would be helpful to quicker rooting.
like
Complain
MangoDudu
MangoDuduanswered grow question 4 years ago
High umidity, cutting new branches and all the base for cloning. Spray one week before the cuts the cloning agent on the mother plant for better propagation success
like
Complain
Esoteric_growing
Esoteric_growinganswered grow question 4 years ago
You are covering the propagator right? If not do so. I find you need about 90% humidity or even a touch higher to start with to avoid the cuts dropping. I also use a single 28w t5 tube a few inches above. Also I give the cuts a fine mist of just normal water to make sure if the humidity. Happy growing pal
1 like
Complain
Similar Grow Questions