Hello my friends 👩‍🌾👨‍🌾, This 8th flowering week was good 👊, maturation Buds continue 🌲❄️, I thought it will be the last week, but need one more. The end is for this week end I think, for moment trichromes not really full milky, and I like something like 20% amber. I've started flush with flash cleaner The senesence is started on the #3. 💦 1 Watering this week 1.8l/plant . Water + flash cleaner PH@6 Lamp @100% Bisous 💋😘, and see you next week. Thanks community for follow, likes, comments, always a pleasure 👩‍🌾👨‍🌾❤️🌲 Mars Hydro - TS 1000 https://www.mars-hydro.com/ts-1000-led-grow-light Mars Hydro - FC3000 https://www.mars-hydro.com/fc-3000-samsung-lm301b-led-grow-light Mars Hydro - SP3000 https://www.mars-hydro.com/sp-3000-samsung-lm301b-greenhouse-led-grow-light The High Chameleon - Bisous Au THC 💋💋🌲🌲😘😘 https://www.thehighchameleon.com/shop/bisous-au-thc-83

Smells amazing, buds are greesy to the touch…serious genetics from fast buds!

Flowering day 7 since time change to 12/12 h. Hey guys :-) The flowering started last week because otherwise the space in the small tent would end up being too narrow :-) Cuttings were taken from each phenotype beforehand. To change the flower, I rinsed it very lightly with clean fruits. With the next watering she gets a mix of grow liquid and bloom liquid before she only gets bloom. The heating mat works perfectly in the small tent and the parameters are all in the optimal range 🙏🏻👍. Now we hope that everything stays that way and that the cold days will slowly pass :-) . Everything was cleaned and checked. have fun and stay healthy 🙏🏻 👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼 You can buy this Nutrients at : https://greenbuzzliquids.com/en/shop/ With the discount code: Made_in_Germany you get a discount of 15% on all products from an order value of 100 euros. 👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼 You can buy this strain at : Clearwater Seeds Water 💧 💧💧 Osmosis water mixed with normal water (24 hours stale that the chlorine evaporates) to 0.2 EC. Add Cal / Mag to 0.4 Ec Ph with Organic Ph - to 5.8 - 6.5 MadeInGermany

All in all i had no problems when growing, except for the heavy mold infestation in all the main flowers at the end of the grow, a great pity, as half of the total weight had to be thrown away. And yes, there are 3 plants wrapped inside each other :D I will definitely grow them again.

26.12.24: These are my 2 best plants P1 and P2 Purple Punch, they are looking great! Not sure what happened to P3. They are in early flower/ pre-flower with the pistils clearly seen on P2. I am also hoping to tie some of the branches down to help light penetration on the lower canopies. I have noticed light stress on my plants. I had moved the lights further away and increased the light intensity to 70%. Unfortunately that created some issues. Namely severe palour of the leaves. To try and rectify the situation, I've dimmed the lights to about 30%, staying at the same distance, about 30 inches away. I measured the par levels, after I did this. They should a reading of anywhere between 40 and 150, at the canopy of the plants. They are all different sizes. This seems to have improved the colouring on all plants. After this evenings watering, I will monitor recovery and increase lighting intensity again slowly. I am also using the light cycle of 21/3, so the plants have many hours more light to absorb, than for example 12/12 or 18/6. I am pleased with the progress, considering all of my mistakes! 29.12.24: So I finally gave LST a shot, it's probably a bit too late, however I really want to get the most of the triploid pheno, and I went a little crazy and LST'd all plants except 2, as they're too small. I did that late last night, this afternoon I was amazed to see the plants turn their leaves back to the light source. I'm glad I overcame my fear of trying it. I'm very excited to see them adapt and progress! 😁 there are videos above with before and after of my LST process. Thanks for checking out my diary 🍃 ✌️

Divine Seeds Website says this Auto Candy could be as tall as 100-120 cm. My Auto Candy is 41 inches which translates to 104cm. On POINT. What started out to be a little on the bushy side ended up sprouting up like a teenager. Divine Seeds Website says this Auto Candy should be flowering in 60 days. My Auto Candy is flowering in 42 days--WHY??--Why is it flowering 18 days sooner?? Please advise. Maybe it is this wonderful @advancenutrient jungle juice that I am using:) I do know that the past couple of weeks have been excruciatingly HOT. This week is incredible cool--Thank you Jesus for the break in weather. It will be very interesting to see what this cooler weather does during this flowering season. Keep the comments and conversations coming this way. Be Happy!!

Week 3 Day 1 8/26/2023 Water Change Day!! Added: 36 gallons of Water TPS SILICA GOLD-.5mil/Gal Root Drip- 1mil/Gal CALMag- .5mil/Gal GH FLoraMicro-4.2mil/Gal GH FlroaGro-3.8mil/Gal GH FLroaBloom-3.0Mil/Gal ORCA-.5mil/Gal She continues to be my Mutant! Week 3 Day 2 8/27/2023 Topped her a little and took a little from the bottom. The PH was just a little high so I added 4mil PH down to get it to 5.86. Week 3 Day 3 8/28/2023 Topped her a little and just enjoyed her individuality. Week 3 Day 4 8/29/2023 Topped her a little, and started cleaning up the lower 1/3, I am starting with the fan leaves that are touching the clay and some of the lower, lower portion but leaving the stems for when I take clones. Week 3 Day 5 8/30/2023 The temp has been getting to 79-80 the last few days and I don't like it that high. I lowered the light to 29 inches and decreased intensity to reach the 350ppfd for the plants. By dropping the light it should also drop the temperature. I took a few bottom leaves as I start my clean up, leaving the lower stems for clone material for now. Week 3 Day 6 8/31/2023 Found out why the temp had been getting so high in my tent and my grow room, the controller for my other light for my other tent was malfunctioning and overheating. I guess this was the unknown contributing factor to the sudden increase in temp, how am I sure about this, because the light no work no more. I am working with Spider-Farmer Warranty since the light was under a year old, very sad day yesterday was to replace my SE 7000 on my breeding plant which was in week 9 of flower with a VS2000 I am thinking I am going to have to cut my losses. On a good note she looks Amazing full on Growth Spurt happening, I adjusted the PH up slightly to get it from 5.81, to 5.89. Tomorrow Measurements incoming. Week 3 Day 7 9/1/2023 She is looking Mutanty this morning! I took off some lower leaves cleaning up the bottom 1/3.

11/3 - Today was the first day of week 5 and also the first day I could see a visibly measurable decrease in her water level between check-ins (~12 hours apart). As a result of her drinking so much water in such a short time, the ppms shot up to almost 800. I used straight tap (7.5 pH, 170ppm) to adjust since her pH was also measuring 5.3. I adjusted her with this method until she registered 5.6pH and 670ppm (1.0ec + tap, 500ppm of nutrients). I would prefer for her pH to be a bit higher (5.8, ideally), but I will settle with this for now since the water is back to just touching the basket. Over the last couple days I've been adjusting her LST to help her bush up as much as possible. I can already see the heavy Sativa influence in her compared to her sister in the tent. I can't wait to see what she will throw at me. 11/4 - I wasn't even planning on doing an update today, but I want to note a few changes. Her root bundle is over a foot long and getting more wound up every day. I removed her LST ties in order to take advantage of the ScrOG screen apparatus (see notes below). After lights came back on, she measured 650ppm and had another notable drop in water level. Currently, I am preparing another nutrient solution that closely matches what she is feeding on now. I will be upgrading her to a 5 gallon bucket. I will be aiming for 1ec of nutrients/additives (500ppm + Tap on my meter, Hanna Primo .5 conversion). Tap measured 180ppm, so target ppm would be 680. Later that same day... So I finished upgrading her to a 5 gallon bucket before I actually got done writing the update. Added one photo showing new 5 gallon setup. Solo ScrOG test mk1 - In an attempt to do a ScrOG, but maintain control over each bucket, while still having relatively easy access to each reservoir, I decided to throw together this little contraption. I removed the lowest complete segment of a tomato cage, leaving a short "tail" beyond the lower ring to act as a peg to insert into corresponding holes in the lid. The lower ring is 10" in diameter and the upper is approximately 12" in diameter. Each ring is 11" apart. I would prefer to have a shorter segment, but I haven't worked out exactly how to do this yet. I would prefer to set the screen height at around 6" above the bucket instead of 11". This will have to suffice for the time being while I let my latent conscious work out a solution or one is provided by the community. Above each cage will sit a coated wire fence with grids measuring ~2"x3", as shown in the above picture. 11/5 - Uploaded short video showing Solo ScrOG Apparatus in place. Screen height currently set to 6". Thanks for stopping by my garden, and, as always, Happy Growing!

this is my first experience with hydroponics. I would like help from you! I'm using the NA line can I already use it? is the amount of water good? I put a video thks

21.09 3 Harvested, 5 to go.

I haven't veen around for a while but my plant kept on doing her thing, she looks gorgeous now, she is full on flowering and I am extremely happy with how this grow is going, in the next week or 2 I will replace that 45w blurple with 60w led quantum board filled with samsung lm281b diodes which should set me up for blooming perios when the buds stack, I nearly filled the 55x45cm screen and I'm expecting high yield after I install the new LED board

The girls look healthy, happy, and smell delicious, kinda sweet citrusy. I'm overall satisfied so far. They have some crystals forming on them as well. I feel like it's gonna be a successful grow. But don't think I'm gonna use Green-O-Matic again, it's not as short as I wanted it to be, and it has unstable phenotype. I hope the effects are nice and relaxing though.

i harvested second part this week. the rest will be harvested in about a week. Buds turned out beautifully. Great Colours and great smell. My best Autoflower so far. Terps are dark and red Berrys combined with some floral Rose aroma. Super Sticky and as you can see good producer.

This week has been cold in the grow room with day time temps at 16c and night time around 12-13c. Growth this week has been quite slow and I wonder what has the biggest impact on growth rate. Is it temperature, light intensity or soil moisture levels? I've had the light at 25% since germination and wonder if it would be beneficial to start increasing the light levels or wait until they're more established before doing this. If anyone happens to read this and has thoughts about how to encourage faster growth, I'd be interested to hear.

Great bud growth with white powdery resin showing. Starting to drink more water consistently every 2 to 3 days.

Semi Jealousy-Zamnesia, messi ieri nel bicchiere, si aspetta che germini, intanto sto preparando il box e la lampada, per quando saranno pronti per la vegetazione

D16 : So far, the weather is really cloudy for the month of June and the plants stretched due to the lack of light. Since this is their final pots I decided to add a bit of soil around the stem to stabilize them. So far, it works pretty well. To test their stability, I've tried to blow on the plant before and after and the difference was clear! The weather was bad this week but knowing that, the plants grew pretty well. Parameters : ------------------------------------------- Humidity range : 60-70% Temperature range : 18-21°C SUN Average : cloudy Plants heights at the end of the week : ------------------------------------------- Apricot : 12 cm Gorilla Punch : 10 cm Orange Sherbet : 10 cm Pound Cake : 12.5 cm

First week of flowering, all goes great.