Stress Killer Automatic by TOTEM

Looking strange, uh? It’s normal at this stage. Branches are getting longer and leaves are like merged up one into each other because they are many, at the same level, and can’t get enough space. But it’s just a graphical issue 😜 Last week I had some problems with some curled up leaves. It was a VPD related problem. High temperature, low humidity. This caused leaves to hide their surface from light in order to keep the humidity level steady. Now, with an added humidifier just right there, RH is 70%, she's feeling great, and same for her leaves. Day 22: Pulling down branches on the second node (to reinforce the LST), I made a cut just where they’re plugged into the stem. You can see it on the last photo of this day. I think she'll handle these cuts like she would with two cropped branches. Day 23: I added two more 18W LED lights (2700K) on two sides to help the two lower branches become longer and push higher. Day 24: Better LST (cables) on branches on the top. Day 26: Fixing the LST day by day, as leaves become bigger and cover lower branches. I cropped those two small branches that came out from topped area in the middle. I was lucky because the top created 4 branches instead of two, though the extra two are a bit weaker than the others. Day 27: Cropped the main two topped branches in order to wait for lower branches to grow a little more and better organize the final structure of the plant. Day 28: Cropped again on 3rd node branches, and same on 2nd and 1st nodes branches, plus some LST.